21 January, 2012, www.brodit.com, © 2012 Brodit AB
Product 540320
540320 Active holder with cig-plug. With tilt swivel. And integrated TMC in charging cable.
The choice for you who want to have your device within easy reach, attached onto a ProClip on the dashboard
instead of in the windshield providing you clear sight.. Active holder with a cig-plug. Connects to the vehicle's
cigarette lighter socket. 12 Volt.
You can easily take the device with you when leaving the vehicle. The holder is equipped with a tilt swivel so it
can be adjusted in order to avoid light reflection on the screen. Attach onto ProClip Mounting Platform.
EAN: 7320285403208
Item no 540320 fits:
Navigon 42 Easy
Navigon 42 Plus
Navigon 42 Premium
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the holder. The holder in the
installation pictures may look slightly different from the one you have received. However, the same instructions
apply.
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed
screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel.
3. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly
tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at
first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.
4. The holder is in place.
2(2)
/