Bauknecht TGE 4406-1SW is an innovative gas cooktop with several user-friendly features:
- Automatic burner lighting - simply turn the knob, no need to press it down or use a separate igniter.
- Dual-direction knobs - turn right for minimum, left for maximum flame without going through intermediate levels.
- Instantaneous ON/OFF - quickly turn off all working burners in case of emergencies.
- Automatic relighting - if a burner accidentally goes out, it will automatically reignite.
- Built-in minute counter and timer - use the timer to turn off a burner automatically or as a simple kitchen timer.
Bauknecht TGE 4406-1SW is an innovative gas cooktop with several user-friendly features:
- Automatic burner lighting - simply turn the knob, no need to press it down or use a separate igniter.
- Dual-direction knobs - turn right for minimum, left for maximum flame without going through intermediate levels.
- Instantaneous ON/OFF - quickly turn off all working burners in case of emergencies.
- Automatic relighting - if a burner accidentally goes out, it will automatically reignite.
- Built-in minute counter and timer - use the timer to turn off a burner automatically or as a simple kitchen timer.
5019 619 61191
TGE 4406 PRODUCT DESCRIPTION SHEET
DE AT
INNOVATIVE COOKTOP
FEATURES
The gas cooktop you have bought has some
innovative features, compared with traditional gas
cooktops.
• Easy burner lighting after switching the
cooktop on with the ON/OFF button just turn
the knob. There is no need to keep it pressed
down or to press a separate igniter.
• The burner knob can be turned in both
directions: to the right the burner goes to
the minimum, to the left it goes directly to
the maximum. There is no need to go
through the other levels.
•The ON/OFF push-button turns off all the
working burners immediately, so that you
can act quickly if there is an unexpected
situation on the cooktop (water spill,
dangerous situation with children, etc.).
• With automatic relighting the cooktop
can react to the burner being turned off,
relighting it automatically. If relighting
happens too frequently, however, the
cooktop recognises that there is something
wrong and informs the user. This avoids
continuous attempts to relight which could
make the product dangerous.
•The minute counter can be used when the
cooktop is being used, for cooking needs, and
when the product is switched off for needs not
directly linked to the cooktop.
• Instead the timer can operate directly on
the burner, turning it off automatically at
the end of the set time.
• The timer can be used both with a burner
turned off, and with a burner already lit,
where cooking is taking place, just by turning
the corresponding knob: this function can be
useful when cooking must continue for a set
number of minutes once the water is boiling.
•The timer can also be switched off
without turning the burner off, as at the
end of normal timer use: cooking can then
continue for as long as wished without
turning the burner off.
• Residual heat pilot lights at the cooktop
centre indicate that the grid is still hot.
• Attention: When switching on the
cooktop after a power failure, the
residual heat pilot lights remain off,
even if the grids are still hot.
1. Removable grids
2. Large burner
3. Rear medium burner
4. Front medium burner
5. Auxiliary burner
6. Control panel
Warning
Improper use of the grids can result in damage
to the hob: do not position the grids upside
down or slide them across the hob.
Do not use:
- cast iron griddles or terracotta pots and
pans
- heat diffusers such as metal mesh, or any
other types
- two burners simultaneously for one
receptacle (e.g. fish kettle).
DIMENSIONS OF THE COOKTOP AND
THE WORKING SURFACE (in mm)
•Using the search for the minimum the
cooktop can automatically identify the
lowest minimum compatible with the local
gas network distribution conditions at the
time the function is used. The burner can
thus be used for long cooking at the lowest
level possible, without turning the knob in
the OFF direction, as in traditional cooktops,
when the knob minimum is too high.
• When searching for the minimum the knob
checks the flame continuously through its
range, as it has a direct flame-knob link on
all its rotation.
• As in modern cars this cooktop has self-
diagnosis capacity and can signal abnormal
situations which require the help of the
Technical After-Sales Service.
DESCRIPTION OF THE KNOBS AND COOKTOP OPERATION
COOKTOP OPERATION
• Switch on the cooktop by pressing button
. Pilot light comes on. The cooktop is
ready for use.
• Turn the knob corresponding to the burner
to be used to the position required. The
pilot light near the knob and the residual
heat light come on.
• As soon as the knob is turned the burner
lights completely automatically: a pulsing
noise indicates that the safety and gas
control systems have been activated and are
working correctly.
• To turn off the burner turn the knob to “0”.
Switch off the cooktop by pressing button
. The pilot light goes out.
N.B.:
— If the burner goes out automatically
(draught, spilt liquids, etc.) the burner
relights automatically.
— If this happens too often, the cooktop
recognises the abnormal situation, turns off the
burner involved, sounds a warning and flashes
“0”. In this case turn the knob to “0”.
— If at the end of cooking the cooktop is not
switched off by pressing button , after a
few minutes pilot light begins to flash and
an acoustic signal is given, until the cooktop
is switched off.
— This obligatory switching off function reduces
the consumption of electricity when the
product is not working and also makes sure
that the product cannot be switched on by
accident (knocking the knobs, faults, etc....)
— If the cooktop is used for too long, the
display indicates “H” and the cooktop
switches off until the electronic components
cool down. The indication “H” then flashes.
Turn the knob to “0” and light the burners
again, if necessary.
1. Front medium burner control
knob
2. Rear medium burner control
knob
3. Large burner control knob
4. Auxiliary burner control knob
5-6-7-8. Knob pilot lights
9-10. Timer/minute counter buttons
11. Signal display (Timer/Faults)
12-13-14-15. Timer section pilot
light
16. ON pilot light
17. ON/OFF button
18-19-20-21. Residual heat pilot
light
If the burners will not light
• The burner will automatically stop within
22 seconds.
• One of pilot lights or flashes and
an acoustic signal sounds.
• Turn the knob back to “0”.
• Look for the cause (see “Trouble Shooting
Guide” in the separate instruction booklet)
and repeat the lighting operations.
If the system stops one of the burners:
• Turn the burner off and turn the knob back
to “0”.
• Look for the cause (see “Trouble Shooting
Guide” in the separate instruction booklet).
• Repeat the lighting operations.
To switch off all the burners at the same
time in an emergency (e.g. food spills
over, etc.):
• Press button . The pilot lights of the lit
burners flash.
• Remember to put all the knobs back to
“0” because if the cooktop is used again
and the knobs have not been zeroed, a
buzzer will sound.
OPERATION OF THE TIMER/
MINUTE COUNTER (Maximum
time: 99 minutes)
To use the MINUTE COUNTER:
• Select the cooking time required by pressing
buttons or . The set time appears on
display and the 4 pilot lights and
come on for a few seconds.
• a few moments after selection, the
minute counter starts to count down and a
buzzer sounds.
• When the set time has elapsed a buzzer
sounds.
• To zero press buttons and at the same
time or zero the time by pressing button .
N.B.:
The minute counter works even with the
cooktop switched off.
To use the TIMER:
— The timer function can be used for any
burner, whether turned off or already lit.
1) Select the cooking time required by pressing
buttons or . The set time appears on
display and the 4 pilot lights and
come on for a few seconds.
2) Turn the burner knob to the position
required before the pilot lights go out.
The pilot light corresponding to the burner
chosen lights up.
N.B.:
If the knobs are not turned before the pilot
lights go out, the minute counter function is
switched on.
3) When the set time has elapsed, the burner
goes out automatically and the timer and
knob pilot lights flash.
The acoustic signal sounds.
• Turn the knob back to “0”:
To stop the timer:
a) To zero the time and switch off the
burnerturn button or turn the knob to
“0”.
b) To cancel the timer function press buttons
and at the same time.
The burner remains lit.
N.B.:
the residual heat pilot lights stay on even
when the cooktop is OFF, until the burner has
cooled down.
AUTOMATIC SEARCH AND
SETTING OF THE MINIMUM
• Turn the burner control knob to symbol .
After a few seconds small bars light up on
display and the residual heat pilot light
flashes for a few seconds until the search is
complete, confirmed by an acoustic signal.
The burner searches for the minimum and
set it automatically.
• If the knob is positioned on the automatic
search and setting of the minimum, the
burner lights again until the gas has reached
the correct flow rate.
DIMENSIONS OF THE COOKTOP AND
THE WORKING SURFACE (in mm)
NOTE: If the distance “A“ between the wall cabinets is between 660 mm and
680 mm, the height “B” must be a minimum of 520 mm.
If the distance “A” between the wall cabinets is greater than the width
of the cooktop, the height “B” must be a minimum of 400 mm.
In case of installation of a hood above the cooktop, please refer to the
hood instructions for the correct distance.
INJECTOR TABLE CATEGORY II2H3B/P
Type of
gas used
Type of
burner
Gas
type
code
No.
Injector
marking
ø 100/mm
Rated
thermal
flow
rate kW
Rated
consump-
tion
Low
thermal
nominal
flow rate
kW
Gas pressure
min. rated max.
NATURAL GAS
(Methane) G 20
High-speed
Medium-speed
Auxiliary
C1
140
103
86
3.00
1.65
1.00
286 l/h
157 l/h
95 l/h
1.20
1.00
0.70
17 20 25
LIQUID
PETROLEUM GAS
(Butano/Propano)
G 30/G 31
High-speed
Medium-speed
Auxiliary
C3
75
58
46
3.00
1.65
1.00
218 g/h
120 g/h
73 g/h
1.20
1.00
0.70
42.5 50 57.5
Type of gas
used
Appliance model Total rated
heat capacity
kW
Total rated
consumption
Air needed
for combustion
m
3
/h
G 20 20 mbar
4 gas 7.30 695 l/h 14.6
G30/G3150 mbar
4 gas 7.30 531 g/h 14.6
-
1
-
2
-
3
-
4
Bauknecht TGE 4406-1SW is an innovative gas cooktop with several user-friendly features:
- Automatic burner lighting - simply turn the knob, no need to press it down or use a separate igniter.
- Dual-direction knobs - turn right for minimum, left for maximum flame without going through intermediate levels.
- Instantaneous ON/OFF - quickly turn off all working burners in case of emergencies.
- Automatic relighting - if a burner accidentally goes out, it will automatically reignite.
- Built-in minute counter and timer - use the timer to turn off a burner automatically or as a simple kitchen timer.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Whirlpool AKR 300/NB/01 Program Chart
-
Whirlpool AKR301/NB/S/01 Program Chart
-
-
-
-
Westinghouse WFE914SB User manual
-
-
Premier SAK600BP Owner's manual
-
GE JGBP75 User manual
-