5019 100 12522
Programme Type of fabrics / Degree of soiling / Notes Max.
Load
kg
Detergent and Additives Options Maximum
Spin Speed
rev/min
Recommended
Spin Speed
rev/min
Programme
Duration
min (1)
Pre-
wash
Wash Softener Bleach Intensive
Wash
1/2 Load Rinse
Hold
Pre-wash
Heavily soiled sheets, tablecloths, underclothes, shirts etc. in hard wearing and
high temperature resistant cotton.
The maximum load for heavily soiled washing is 3.5 kg.
5.0 Yes Yes
❉❉
—
❉❉
700 600 to 700 130
Cotton 60° C
Moderately soiled sheets, tablecloths, underclothes, towels etc.
in hard wearing and high temperature resistant cotton.
5.0 Yes Yes
❉❉❉ ❉❉
700 600 to 700 115
Coloureds 60° C
Normally soiled shirts, blouses etc.made of polyester
(Diolen, Trevira), polyamide (Perlon, Nylon), or cotton blends.
2.0
—
Yes
❉
—
❉❉❉
700 450 to 700 100
Synthetics 40° C
Lightly soiled shirts, blouses etc. made of polyester (Diolen, Trevira), polyamide
(Perlon, Nylon) or cotton blends.
2.0
—
Yes
❉
——
❉❉
700 450 to 700 85
Rinse/
Spin
This programme allows starch or softener to be added.
It is followed by an intensive spin cycle.
5.0
——
❉
——
❉❉
700 450 to 700 20
Spin
Programme for intensive spin cycle. 5.0
——— — — — —
700 450 to 700 10
Delicate 40° C
Delicate curtains and fabrics (dresses, skirts, blouses, etc.). 1.5
—
Yes
❉
———
❉
600 100 to 400 55
Wool
Machine washable woollens with pure new wool label.
If the “Rinse Hold” option is selected don’t leave the washing to soak too long.
1.0
—
Yes
❉
———
❉
600 100 to 400 45
Rinse/
Spin
This programme allows starch or softener to be added.
It is followed by a gentle spin cycle.
1.5
——
❉
———
❉
600 100 to 400 15
Spin
Programme for gentle spin cycle. 1.5
——
—
————
600 100 to 400 5
Drain
Drain only, without spin cycle.
Alternative way to end programmes with a “Rinse Hold” setting.
———
—
———— — —
3
(1)The programme times
(supplied for information
only) are valid for
maximum temperature
wash without option.
GB
PROGRAMME TABLE
Evidence 7033
Programme Selector
Spin Speed Selector
Intensive Wash
1/2 Load
Rinse Hold
On/Off
5019 100 12522
Programmes with pre-wash last about 15 minutes more than programmes without pre-wash. Water and energy
consumption values were measured in standard conditions in compliance with the Standard CEI 60456. Individual
consumption may vary in comparison with the values specified in the table, because of differences in supply water
pressure and temperature, the load and the type of wash.
ADDING DETERGENT AND ADDITIVES
Pour the detergent and additives into the respective
compartments as follows:
• Programme with pre-wash and main wash
• Main wash programme without pre-wash
• Fabric softeners and starch
• Bleach
• Stain remover agents
• Anti-scale agents (water hardness 4)
Important:
• Do not fill beyond the “
MAX
” level mark.
• For programme with pre-wash: do not use liquid
detergent.
• For programmes without pre-wash from cold to 40° C, it is recommended to use a
liquid detergent to avoid white traces on coloured washing.
CLOSE THE DOOR AND SELECT THE PROGRAMME
1. Turn the
programme selector
“” clockwise to the required programme.
2. Turn the
spin speed selector
“”
to the required speed.
PRESS THE BUTTON CORRESPONDING TO THE REQUIRED OPTION.
“Intensive Wash ”
• This option will allow increasing the wash temperature to 95° C instead of 60° C for the
“Cotton 60° C” programme.
• Especially recommended for soiled washing.
“1/2 Load ”
• Reduces the water consumption in the “Cotton” and “Synthetic” programmes
especially during pre-wash and rinse.
• Recommended for lightly soiled or small washing loads (reduce the quantity of
detergent).
“Rinse Hold ” button
• The unspun washing remains in the last rinse water, thus enabling creasing and
discolouration of the washing to be avoided.
• This option is especially recommended for the “Synthetics 40° C” or “Delicate 40° C”
programmes.
• This option is perfectly suitable if you wish to postpone the spin or you don’t wish to
spin the washing.
Note:
the programme selectro stops on “”.
To stop the programme
• Again press on the “Rinse Hold” button; the programme will stop automatically with the
spin cycle corresponding to the previously selected wash programme.
• If you don’t wish to spin the clothes, switch off the appliance by pressing the “On/Off
” button. The warning light goes out. Turn the programme selector to the “Drain”
position and switch on the appliance.
PROGRAMME START
Open the water inlet tap and press the “On/Off ” button. The warning light lights up.
DOOR LOCK
During the programme, the door cannot be opened.
The door locks automatically during all programmes.
If the programme is interrupted or if an electrical power failure occurs, the door unlocks
automatically after about 1 minute.
PROGRAMME END
• The programme selector knob is at “Stop”.
1. Press the “On/Off” button. The warning light goes out.
2. Cancel the options by pushing the corresponding buttons.
3. Close the water inlet tap.
4. Wait for the door to unlock (about 1 minute).
5. Open the washing machine door and the drum doors. Remove the washing.
PROGRAMME CHANGE AFTER THE START OF THE CYCLE
1. Press the “On/Off” button to switch off the appliance.
The warning light goes out.
2. Select another programme, the spin speed and the options.
3. Press the “On/Off” button to switch on the appliance.
The warning light lights.
INTERRUPTION OF THE PROGRAMME BEFORE THE END OF THE CYCLE
1. Press the “On/Off” button to switch off the appliance.
The warning light goes out.
2. Position the programme selector on “Drain”.
3. Press the “On/Off” button to start the “Drain” programme.
Only open the door when the programme selector is at “Stop” and
the door is unlocked (after about 1 minute).
ENERGY AND WATER CONSUMPTION DATA
Programme Load
(kg)
Water
(l)
Energy
(kWh)
Programme
time
(min)
Cotton + Intensive Wash 95° C 5.0 72 1.8 115
Cotton 60° C 5.0 69 1.15 115
Coloureds 60° C 2.0 66 0.8 100
Synthetics 40° C 2.5 49 0.5 85
Delicate 40° C 1.5 70 0.65 55
Wool 1.0 70 0.55 45
GB
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Whirlpool AWT 2176 Program Chart
-
-
-
-
-
-
Whirlpool AWT 2376 Program Chart
-
-
-