Gtech SW10 Installation guide

www.gtechonline.co.uk

Remove the dust tray and tubes from the

main body of the sweeper (Pull tubes out

of the lower handle).

1x Phillips Screw Driver

Remove the visor.

Once all the screws are removed, lift the

bottom housing off the sweeper.

Remove the battery. Open the battery

compartment and disconnect the

terminals by pinching the connectors.

Remove 11 screws from the bottom of the

sweeper. (Two are hidden under the rear

wheels; these can be prised out using a

at–headed screwdriver).

This will free the lower handle assembly.

SW10 Lower Handle Replacement Instructions

Page 1 of 2

www.gtechonline.co.uk

Simply place the new lower lower handle

assembly (knuckle joint rst) in the section

at the back of the sweeper.

Replace all 11 screws, making sure all the

sides are level are sealed – you can check

this by looking at the charger port and

making sure this is also level.

Replace the battery, visor, dust tray and

tubes.

Turn the sweeper up the correct way,

and ensure that the lower handle can be

rotated 360º and click in and out of place.

Ensure that the wires connecting to the

battery are fed back through into the

battery compartment before sealing

the unit.

Page 2 of 2