Datexx LED-45 User manual

Datexx
Brand
Datexx
Model
LED-45
Category
Wall clocks
Type
User manual
Inserting the Batteries
Before using your LED-45 insert
Five 1.5V AAA alkaline batteries:
1.
2. Insert batteries, following
polarity diagram
3. Replace the cover
To Reset the Clock
Insert paper clip into
RESET Hole
Button
Reset Hole
12/24
Hour
Display
(Speech
12 hr.
only)
Save Battery Power
Turn off Chime and
Alarm when not used.
When voice slows,
replace Batteries.
Set the Time
1. Press SET.
2. Press H and M to set hour and minute
3. Press SET twice.
Set the Alarm
1. Press SET twice.
2. Press H and M to adjust
the Alarm hour and minute.
3. Press iTALK button to choose a
Chirping
or
Beeping
sound.
4. Press SET.
ALARM
When Alarm sounds:
Press iTALK button to snooze,
Press iTALK button twice to stop alarm.
Hourly Chime
Press CHIME for an
hourly time and
temperature report.
TELEDEX Limited U.S.A. Warranty
TELEDEX INC. warrants these products to the original purchaser to
be free from defective material and workmanship. The product will
be repaired or replaced at our option, for up to one year when
returned with proof of purchase to the address below. Include a
check or money order for $5.00 to cover postage.
TELEDEX INC. 1 Atlas st. Kenilworth, NJ 07033
Warranty valid only in the U.S.A. Printed in China 2/04
www.datexx.com
Talking Clock
LED Flash Light
LED-45
Remove back cover
PM
ON
OFF
ALARM
12/24
SET H M CHIME
RESET
Bottom
Ligth Switch
Automatically Shuts
Light OFF when
Standing
Note: Three batteries are for LIGHT
Two batteries are for CLOCK
Note: To select Military Time Press 12/24 Button
Before Setting Time (Clock will only speak in regular Time Mode)
Back Side
  • Page 1 1

Datexx LED-45 User manual

Datexx
Brand
Datexx
Model
LED-45
Category
Wall clocks
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents