Page is loading ...
*Robin EX30 OHC engine
*Cast-iron cylinder sleeve
*Low oil sensor
*Receptacles on control panel
*6 gallon plastic fuel tank
*Portability Kit
A.120 V, 20 Ampere Duplex Receptacle
20 amps of current may be drawn from each half of the
receptacle. However, total power drawn must be kept within
nameplate ratings. These receptacles may be used along with
the twistlock receptacle provided the generator is not
overloaded.
B.120/240 V, 30 Ampere Twistlock Receptacle
A maximum of 30 amps may be drawn from the 120/240
volt receptacle, provided it is the only receptacle used.
However, current must be limited to the nameplate rating. If the
120/240 volt receptacle is used along with the 120 volt
receptacle, the total load drawn must not exceed the nameplate
ratings.
C.Circuit Breakers
The receptacles are protected by an AC circuit breaker. If
the generator is overloaded or an external short circuit occurs,
the circuit breaker will trip. If this occurs, disconnect all
electrical loads and try to determine the cause of the problem
before attempting to use the generator again. If overloading
causes the circuit breaker to trip, reduce the load. NOTE:
Continuous tripping of the circuit breaker may cause
damage to generator or equipment. The circuit breaker may
be reset by pushing the button of the breaker.
This product is warranted by Powermate Corporation to the
original retail consumer against defects in material and
workmanship for a period of two (2) years from the date of retail
purchase and is not transferable. This two year warranty
applies only to products used in consumer applications. If this
generator is used in a commercial application, then the period
of warranty coverage is limited to one (1) year from the date of
purchase.
Please complete and return the enclosed Customer
Information Card so that we can reach you in the unlikely event
a safety recall is needed. Return of this card is not required to
validate this warranty.
WHAT IS COVERED: Replacement parts and labor.
WHAT IS NOT COVERED: Transportation charges to
Powermate Corporation for defective products. Transportation
charges to consumer for repaired products. Brushes, fuses,
rubber feet, and receptacles. Damages caused by abuse,
accident, improper repair, or failure to perform normal
maintenance. Power units or engines which are covered
exclusively by the warranties of their manufacturer. Sales
outside of the United States or Canada. Any other expense
including consequential damages, incidental damages, or
incidental expenses, including damage to property. Some
states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion
may not apply to you.
IMPLIEDWARRANTIES: Any implied warranties, including
the Implied Warranties of Merchantability and Fitness For A
Particular Purpose, are limited in duration to one (1) year from
the date of retail purchase. Some states do not allow
limitations on how long an implied warranty lasts, so the above
limitation may not apply to you.
HOW TO OBTAIN WARRANTY PERFORMANCE:
Replacement parts and service are available from Powermate
Corporation Service Centers. Locate your nearest Service
Center by calling TOLL FREE 1-800-445-1805. In the unlikely
event a Service Center can not be located you may call
Powermate Corporation for a return authorization number. Any
unit returned WITHOUT an authorization number will be
refused.
To the extent any provision of this warranty is prohibited by
federal, state, or municipal law, and cannot be preempted, it
shall not be applicable. This warranty gives you specific rights,
and you may also have other rights which vary from state to
state.
2
English
CONTROL PANEL
MAJOR GENERATOR FEATURES LIMITED WARRANTY
(NOT VALID IN MEXICO)
TOOLS REQUIRED: 7/16”, 1/2” and 9/16" sockets and ratchets, block(s) of wood (minimum of 6” tall).
Refer to the parts list and drawing on pages 8 and 9.
WHEEL INSTALLATION
1.Block up end of generator opposite the fuel tank cap to install wheel kit.
2.Insert wheel spacer (item 46) into the center of the wheel (item 31).
3.Slide 3/8 x 4.25” bolt (item 35) and 3/8 washer (item 47) through the wheel (item 31), then through the wheel bracket on the
carrier, with the offset side of the wheel hub against the wheel bracket.
4.Thread 3/8 nyloc nut (item 36) onto the bolt and tighten to securely clamp the wheel assembly to the carrier.
5.Repeat above instructions for the remaining wheel.
FOOT INSTALLATION
1.Assemble the rubber feet (item 32) to the foot bracket (item 30) using a 1/4-20 x 1.5” bolt (item 45). Thread a 1/4 washer
(item 39) and a 1/4 nyloc nut (item 13) to the bolt to secure the assembly. Caution: Do not over tighten so that the foot
material collapses.
2.Blocking up the engine side of the generator, place the foot bracket under the carrier channel. Thread a 5/16-18 x 1” bolt
(item 44) with a 5/16 washer (item 34) through the mounting holes and thread a 5/16 washer (item 34) and a 5/16 nyloc nut
(item 16) to the bolt to secure the foot bracket to the carrier.
LOCKING HANDLE
1.Attach the lanyard (item 33) to the release pin
(item 37) and carrier as shown in the illustration.
2. To lock the handle (item 28) in the extended
position, align the holes in the handle bracket
with the holes in the carrier bracket and insert
the release pin (item 37).
3.Insert caps (item 38) into ends of handle
(item 28).
3
English
PORTABILITY KIT INSTALLATION
1
2
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
9
REF.PARTDESCRIPTION DESCRIPTION DESCRIPCIÓNQTY
NO.NO.
10062936Carrier, assemblyEnsemble transportTransportador, conjunto1
2Note AEngine Robin EX30 OHCMoteurMotor1
30051094IsolatorSectionneurAislador4
40050236.01Adapter, engineAdaptateur pour moteurAdaptador, motor1
50000919.01Bolt whz 3/8-16 x .75BoulonPerno4
60062494Stator 5.25 KW 60 HZ StatorEstator1
6A0056716Connector, statorJeu pr logemt prise, statorConjunto de conectores stator1
6B0062196Connector hsg set panelJeu pr logemt priseConjunto de conectores panel 1
70058130Rotor 5.25 KW RotorRotor1
80049004Bolt, hex 5/16-24 x 7.25BoulonPerno1
9Note BWasher, lock 5/16Contre-écrou 5/16Arandela, de cierre 5/163
100062470Endbell Wired Couvre-enroulement, câblage completCaja posterior con cable
tableau1
10A0050439Brush, E-4RBalais, E-4REscobilla, E-4R2
10B0062455Assembly, bridge rectifierEnsemble de planche de Conjunto de la tabla del rectificador del puente
boardredresseur de pont1
10C0062264Brush CoverCouvre-balaisCubierta de escobillas1
110056076Bolt, HH 1/4-20 x 6.50BoulonPerno4
120008854Lug, groundOeillet de mise à la terreTerminal, tierra1
130040832Nut, nyloc 1/4-20Écrous nyloc 1/4-20 Tuerca, nyloc 1/4-20 6
14Note BBolt, 5/16-18 x 1 1/2BoulonPerno2
15Note BWasher, flat 5/16Rondelles plates 5/16Arandela, plana 5/165
160048736Nut, nyloc 5/16-18Écrous nyloc 5/16-18Tuerca, nyloc 5/16-189
170049224Assembly, ground wireEns. fil de masse tressé a tierraConjunto, cable trenzado 1
18Note BWasher, star external 5/16Rondelles à dents externa 5/16Arandela, estrella 2
19Note BBolt, hex 5/16-18 x 3/4Boulon, tête hex 5/16-18 x 3/4Perno 5/16-18 x 3/42
20
0062568MufflerSilencieuxSilenciador1
210062566GasketJointEmpaquetadura1
220062937Panel, wiredTableau compl. câbléPanel, cabeado completo1
22A0049072Circuit Breaker 25 ampDisjoncteurs 20 ampCortacircuitos 20 amp2
230062462Screw #6-20 x .38 Type BVisTornillo4
240062944
Shield, heatÉcran de chaleurPantalla para el calor1
25Note CFuel tank assemblyAssemb. complet du réservoirConjunto tanque1
25A0055340Fuel CapCapuchonTapa de combustible1
25B0049114Fuel shut off with filterRobinet de carburantVálvula combustible con filtro1
25C0062673Fuel bushingBague d’essenceBuje de combustible1
26
0058618Screw, #10 x 1VisTornillo4
270062916Bracket, handle lockSupportSoporte1
280062938HandlePoignéeManija1
29Note BBolt, 5/16-18 x 1 3/4BoulonPerno1
300062301Bracket, footSupport de piedSoporte del pie1
310057704WheelRoueRueda2
320055894Rubber FootPiedPie2
330062174LanyardLanyardAcollador1
340049352Washer, flat 5/16 WRondelles plates 5/16 largeArandela, plana 5/16 lejos4
35Note BBolt, 3/8-16 x 4.25BoulonPerno2
360057578Nut, nyloc 3/8-16Écrous nyloc 1/2-13Tuerca, nyloc 1/2-132
370062502Pin, releaseEpingle de relâchementAlfiler de la liberación1
380058955Cap, plasticCapuchonTapa2
39Note BWasher, flat 1/4Rondelles plates 1/4Arandela, plana 1/46
400056342Bracket, statorSectionneur statorConjunto de soporte1
410049279Bolt, whz 5/16-18 x 1/2BoulonPerno3
420000901.01Bolt, whz 5/16-24 x 5/8BoulonPerno2
430062567Nut whz 8mmÉcrousTuerca2
44Note BBolt, 5/16-18 x 1BoulonPerno2
45Note BBolt, 1/4-20 x 1 1/2BoulonPerno2
460062433Wheel spacerBague d’espacement Espaciador de la rueda2
47Note BWasher, flat 3/8Rondelles plates 3/8Arandela, plana 3/82
480062760Bracket, air cleanerSupportSoporte1
490062761Bolt, flangeBoulonPerno1
500007587Assembly, ground wireEns. fil de masse tressé a tierraConjunto, cable trenzado 1
PARTS LIST / LISTE DES PIÈCES / LISTA DE PIEZAS
Page is loading ...
Page is loading ...
4970 Airport Road
P. O. Box 6001
Kearney, NE 68848
1-800-445-1805
1-308-237-2181
Fax 1-308-234-4187
© 2005 Powermate Corporation. All rights reserved.
are registered trademarks of The Coleman Company, Inc. used under license.
Powermate ® is a registered trademark of Powermate Corporation.
© 2005 Powermate Corporation. Tous droits réservés.
sont des marques déposées de The Coleman Company, Inc. utilisées sous licence.
Powermate® est une marque déposée de Powermate Corporation.
© 2005 Powermate Corporation. Reservados todos los derechos.
son marcas comerciales registradas de The Coleman Company, Inc. utilizadas bajo licencia.
Powermate ® es una marca comercial registrada de Powermate Corporation.
Coleman® and
Coleman® et
Coleman® y
/