Powermate PM0435251 User manual

Page is loading ...

*Robin EX30 OHC engine

*Cast-iron cylinder sleeve

*Low oil sensor

*Receptacles on control panel

*6 gallon plastic fuel tank

*Portability Kit

A.120 V, 20 Ampere Duplex Receptacle

20 amps of current may be drawn from each half of the

receptacle. However, total power drawn must be kept within

nameplate ratings. These receptacles may be used along with

the twistlock receptacle provided the generator is not

overloaded.

B.120/240 V, 30 Ampere Twistlock Receptacle

A maximum of 30 amps may be drawn from the 120/240

volt receptacle, provided it is the only receptacle used.

However, current must be limited to the nameplate rating. If the

120/240 volt receptacle is used along with the 120 volt

receptacle, the total load drawn must not exceed the nameplate

ratings.

C.Circuit Breakers

The receptacles are protected by an AC circuit breaker. If

the generator is overloaded or an external short circuit occurs,

the circuit breaker will trip. If this occurs, disconnect all

electrical loads and try to determine the cause of the problem

before attempting to use the generator again. If overloading

causes the circuit breaker to trip, reduce the load. NOTE:

Continuous tripping of the circuit breaker may cause

damage to generator or equipment. The circuit breaker may

be reset by pushing the button of the breaker.

This product is warranted by Powermate Corporation to the

original retail consumer against defects in material and

workmanship for a period of two (2) years from the date of retail

purchase and is not transferable. This two year warranty

applies only to products used in consumer applications. If this

generator is used in a commercial application, then the period

of warranty coverage is limited to one (1) year from the date of

purchase.

Please complete and return the enclosed Customer

Information Card so that we can reach you in the unlikely event

a safety recall is needed. Return of this card is not required to

validate this warranty.

WHAT IS COVERED: Replacement parts and labor.

WHAT IS NOT COVERED: Transportation charges to

Powermate Corporation for defective products. Transportation

charges to consumer for repaired products. Brushes, fuses,

rubber feet, and receptacles. Damages caused by abuse,

accident, improper repair, or failure to perform normal

maintenance. Power units or engines which are covered

exclusively by the warranties of their manufacturer. Sales

outside of the United States or Canada. Any other expense

including consequential damages, incidental damages, or

incidental expenses, including damage to property. Some

states do not allow the exclusion or limitation of incidental or

consequential damages, so the above limitation or exclusion

may not apply to you.

IMPLIEDWARRANTIES: Any implied warranties, including

the Implied Warranties of Merchantability and Fitness For A

Particular Purpose, are limited in duration to one (1) year from

the date of retail purchase. Some states do not allow

limitations on how long an implied warranty lasts, so the above

limitation may not apply to you.

HOW TO OBTAIN WARRANTY PERFORMANCE:

Replacement parts and service are available from Powermate

Corporation Service Centers. Locate your nearest Service

Center by calling TOLL FREE 1-800-445-1805. In the unlikely

event a Service Center can not be located you may call

Powermate Corporation for a return authorization number. Any

unit returned WITHOUT an authorization number will be

refused.

To the extent any provision of this warranty is prohibited by

federal, state, or municipal law, and cannot be preempted, it

shall not be applicable. This warranty gives you specific rights,

and you may also have other rights which vary from state to

state.

2

English

CONTROL PANEL

MAJOR GENERATOR FEATURES LIMITED WARRANTY

(NOT VALID IN MEXICO)

TOOLS REQUIRED: 7/16”, 1/2” and 9/16" sockets and ratchets, block(s) of wood (minimum of 6” tall).

Refer to the parts list and drawing on pages 8 and 9.

WHEEL INSTALLATION

1.Block up end of generator opposite the fuel tank cap to install wheel kit.

2.Insert wheel spacer (item 46) into the center of the wheel (item 31).

3.Slide 3/8 x 4.25” bolt (item 35) and 3/8 washer (item 47) through the wheel (item 31), then through the wheel bracket on the

carrier, with the offset side of the wheel hub against the wheel bracket.

4.Thread 3/8 nyloc nut (item 36) onto the bolt and tighten to securely clamp the wheel assembly to the carrier.

5.Repeat above instructions for the remaining wheel.

FOOT INSTALLATION

1.Assemble the rubber feet (item 32) to the foot bracket (item 30) using a 1/4-20 x 1.5” bolt (item 45). Thread a 1/4 washer

(item 39) and a 1/4 nyloc nut (item 13) to the bolt to secure the assembly. Caution: Do not over tighten so that the foot

material collapses.

2.Blocking up the engine side of the generator, place the foot bracket under the carrier channel. Thread a 5/16-18 x 1” bolt

(item 44) with a 5/16 washer (item 34) through the mounting holes and thread a 5/16 washer (item 34) and a 5/16 nyloc nut

(item 16) to the bolt to secure the foot bracket to the carrier.

LOCKING HANDLE

1.Attach the lanyard (item 33) to the release pin

(item 37) and carrier as shown in the illustration.

2. To lock the handle (item 28) in the extended

position, align the holes in the handle bracket

with the holes in the carrier bracket and insert

the release pin (item 37).

3.Insert caps (item 38) into ends of handle

(item 28).

3

English

PORTABILITY KIT INSTALLATION

1

2

Page is loading ...

9

REF.PARTDESCRIPTION DESCRIPTION DESCRIPCIÓNQTY

NO.NO.

10062936Carrier, assemblyEnsemble transportTransportador, conjunto1

2Note AEngine Robin EX30 OHCMoteurMotor1

30051094IsolatorSectionneurAislador4

40050236.01Adapter, engineAdaptateur pour moteurAdaptador, motor1

50000919.01Bolt whz 3/8-16 x .75BoulonPerno4

60062494Stator 5.25 KW 60 HZ StatorEstator1

6A0056716Connector, statorJeu pr logemt prise, statorConjunto de conectores stator1

6B0062196Connector hsg set panelJeu pr logemt priseConjunto de conectores panel 1

70058130Rotor 5.25 KW RotorRotor1

80049004Bolt, hex 5/16-24 x 7.25BoulonPerno1

9Note BWasher, lock 5/16Contre-écrou 5/16Arandela, de cierre 5/163

100062470Endbell Wired Couvre-enroulement, câblage completCaja posterior con cable

tableau1

10A0050439Brush, E-4RBalais, E-4REscobilla, E-4R2

10B0062455Assembly, bridge rectifierEnsemble de planche de Conjunto de la tabla del rectificador del puente

boardredresseur de pont1

10C0062264Brush CoverCouvre-balaisCubierta de escobillas1

110056076Bolt, HH 1/4-20 x 6.50BoulonPerno4

120008854Lug, groundOeillet de mise à la terreTerminal, tierra1

130040832Nut, nyloc 1/4-20Écrous nyloc 1/4-20 Tuerca, nyloc 1/4-20 6

14Note BBolt, 5/16-18 x 1 1/2BoulonPerno2

15Note BWasher, flat 5/16Rondelles plates 5/16Arandela, plana 5/165

160048736Nut, nyloc 5/16-18Écrous nyloc 5/16-18Tuerca, nyloc 5/16-189

170049224Assembly, ground wireEns. fil de masse tressé a tierraConjunto, cable trenzado 1

18Note BWasher, star external 5/16Rondelles à dents externa 5/16Arandela, estrella 2

19Note BBolt, hex 5/16-18 x 3/4Boulon, tête hex 5/16-18 x 3/4Perno 5/16-18 x 3/42

20

0062568MufflerSilencieuxSilenciador1

210062566GasketJointEmpaquetadura1

220062937Panel, wiredTableau compl. câbléPanel, cabeado completo1

22A0049072Circuit Breaker 25 ampDisjoncteurs 20 ampCortacircuitos 20 amp2

230062462Screw #6-20 x .38 Type BVisTornillo4

240062944

Shield, heatÉcran de chaleurPantalla para el calor1

25Note CFuel tank assemblyAssemb. complet du réservoirConjunto tanque1

25A0055340Fuel CapCapuchonTapa de combustible1

25B0049114Fuel shut off with filterRobinet de carburantVálvula combustible con filtro1

25C0062673Fuel bushingBague d’essenceBuje de combustible1

26

0058618Screw, #10 x 1VisTornillo4

270062916Bracket, handle lockSupportSoporte1

280062938HandlePoignéeManija1

29Note BBolt, 5/16-18 x 1 3/4BoulonPerno1

300062301Bracket, footSupport de piedSoporte del pie1

310057704WheelRoueRueda2

320055894Rubber FootPiedPie2

330062174LanyardLanyardAcollador1

340049352Washer, flat 5/16 WRondelles plates 5/16 largeArandela, plana 5/16 lejos4

35Note BBolt, 3/8-16 x 4.25BoulonPerno2

360057578Nut, nyloc 3/8-16Écrous nyloc 1/2-13Tuerca, nyloc 1/2-132

370062502Pin, releaseEpingle de relâchementAlfiler de la liberación1

380058955Cap, plasticCapuchonTapa2

39Note BWasher, flat 1/4Rondelles plates 1/4Arandela, plana 1/46

400056342Bracket, statorSectionneur statorConjunto de soporte1

410049279Bolt, whz 5/16-18 x 1/2BoulonPerno3

420000901.01Bolt, whz 5/16-24 x 5/8BoulonPerno2

430062567Nut whz 8mmÉcrousTuerca2

44Note BBolt, 5/16-18 x 1BoulonPerno2

45Note BBolt, 1/4-20 x 1 1/2BoulonPerno2

460062433Wheel spacerBague d’espacement Espaciador de la rueda2

47Note BWasher, flat 3/8Rondelles plates 3/8Arandela, plana 3/82

480062760Bracket, air cleanerSupportSoporte1

490062761Bolt, flangeBoulonPerno1

500007587Assembly, ground wireEns. fil de masse tressé a tierraConjunto, cable trenzado 1

PARTS LIST / LISTE DES PIÈCES / LISTA DE PIEZAS

Page is loading ...

4970 Airport Road

P. O. Box 6001

Kearney, NE 68848

1-800-445-1805

1-308-237-2181

Fax 1-308-234-4187

are registered trademarks of The Coleman Company, Inc. used under license.

Powermate ® is a registered trademark of Powermate Corporation.

sont des marques déposées de The Coleman Company, Inc. utilisées sous licence.

Powermate® est une marque déposée de Powermate Corporation.

son marcas comerciales registradas de The Coleman Company, Inc. utilizadas bajo licencia.

Powermate ® es una marca comercial registrada de Powermate Corporation.

Coleman® and

Coleman® et

Coleman® y

Powermate PM0435251 User manual

Powermate PM0435251 User manual

in other languages

Related papers

Other documents