KRT672001 EN
Copyright © 2018 VARO P a g e | 1 www.varo.com
WORKBENCH
KRT672001
1 PACKAGE CONTENT LIST
▪ Remove all packing materials
▪ Remove remaining packaging and transit supports (if existing).
▪ Check the completeness of the packing content.
▪ Check the appliance, the power cord, the power plug and all accessories for transportation
damages.
▪ Keep the packaging materials as far as possible till the end of the warranty period.
Dispose it into your local waste disposal system afterwards.
WARNING: Packing materials are no toys! Children must not play with
plastic bags! Danger of suffocation!
NOTE: When parts are missing or damaged, please contact your dealer.
Number
Description
Quantity
1
Table top
2
2
Wood screw 5mmx16mm
16
3
Slide base
2
4
Bolts (HEX)
4
5
Washers Ø8xØ16
8
6
Nuts (nylon) M8
4
7
Cross bar
2
8
Leg frame
2
9
Plastic pad
4
10
Bolts M6x32.5mm
8
11
Nuts (hex) M6
8
12
Clamp
4
13
Washers Ø6xØ13
8
2 SAFETY WARNINGS
▪ Before each use, check that all moving parts have been secured and the foldable legs
frames are fully unfolded and secured. Always ensure that the workbench is stable.
▪ Before each use check that all bolts and nuts are secured. Tighten these bolts and nuts if
necessary.
▪ Do not exceed the maximum load.
▪ They product may not be used as a ladder, stairs or a scaffold. Never stand on the
product or work pieces placed on it. Do not lean on the product when working.
▪ Keep any part of the body, especially hands clear of the moving parts when folding or
unfolding the bench.
▪ Use the product only as described in this instruction manual. Failure to follow instructions
could cause property damage and personal injury.
▪ Only for use on firm, level surface
3 ASSEMBLY
▪ Tools required: cross screwdriver (PH2), hammer and spanner.
▪ STEP 1: Use woodscrews (#2) to connect slide base (#3) with table top (#1).
▪ STEP 2: Use bolts (#10), washer (#13) and nuts (#11) to connect cross bars (#7) with
legs (#8).
▪ STEP 3: Attach plastic pad (#9) to legs (#8).
KRT672001 EN
Copyright © 2018 VARO P a g e | 2 www.varo.com
NOTE: Each foot must be attached with longest side at outer corner which
is indicated by arrow inside.
▪ STEP 4: Fit leg into slide base and line up holes of both. Then insert bolts (#4), washer
(#5) from outside and attach washers (#4), nuts (#6) from inside. Tighten bolts and nuts
with spanners and screwdriver. Do same procedure for 4 bolts.
NOTE: The handles must be at front side
▪ STEP 5: Select suitable holes on table top to fix clamps (#12).
4 TECHNICAL DATA
Model Nr.
KRT672001
Size
60.5 x 62.5 x 75.5 cm
Max capacity
100kg
/