Go Rhino GRT3410 Installation guide

INSTALLATION INSTRUCTIONS

Exhaust Tip

Parts List:

x1 Exhaust Tip

x1 Clamp

Required Tools (not included):

A. Ratchet

B. 15mm socket/wrench

Steps:

1. Clean exhaust pipe to ease the instalation.

2. Place the clamp on the narrow part of the tip (See picture above). Adjust it, do not tighten yet.

3. Place the exhaust tip over the pipe.

4. Tighten the nut with a 15mm socket/wrench to 40Lb/ft (55 N/m).

5. Revise periodically and re-tighten if necessary.

R&D QA FODI7.003.I

Page 1/1

This manual is also suitable for

Download PDF