Toro Switch Installation guide

Type
Installation guide

This manual is also suitable for

FORM NO. 3319-626
INSTALLATION
INSTRUCTIONS
PART NO. 98-2393 & 98-2394
SWITCH KIT
Loose Parts
Note: Use the chart below to identify parts used for assembly.
DESCRIPTION QTY. USE
Bracket
Switch
Screw#4-40 x 1-1/4” (32 mm)
Nut #4–40
Adapter wire
1
2
2
2
1
Install replacement switches
Decal 1 Install on rear of tractor hood
Install Switch Kit
(Part No. 98-2393)
1. Remove existing switch from tractor, discard.
2. Align (2) switches inside of bracket as shown
(Fig. 1).
3. Secure switches to bracket with (2)
#4–40 x 1-1/4” (32 mm) screws and (2) #4–40
nuts (Fig. 1).
4. Plug adapter wire onto switch terminals (Fig. 1).
5. Mount bracket in tractor in place of previously
removed switch.
6. Connect adapter wire terminals to tractor wire
harness. Wide terminals to wide connectors and
narrow terminals to narrow connectors.
4
m–3998
3
2
1
5
Figure 1
1. Bracket
2. Switch
3. Screw #4–40 x 1-1/4”
(32 mm)
4. Nut #4–40
5. Adapter wire
2
Install Switch Kit
(Part No. 98-2394)
1. Remove existing switch from tractor, discard.
2. Align (2) switches outside of bracket as shown
(Fig. 2).
3. Secure switches to bracket with (2)
#4–40 x 1-1/4” (32 mm) screws and (2) #4–40
nuts (Fig. 2).
4. Plug adapter wire onto switch terminals (Fig. 2).
5. Mount bracket in tractor in place of previously
removed switch.
6. Connect adapter wire terminals to tractor wire
harness. Wide terminals to wide connectors and
narrow terminals to narrow connectors.
m–3999
3
2
1
4
5
Figure 2
1. Bracket
2. Switch
3. Screw #4–40 x 1-1/4”
(32 mm)
4. Nut #4–40
5. Adapter wire
Install Decal
1. Remove backing and install decal to rear of
tractor hood in a very visible location (Fig. 3).
Figure 3
  • Page 1 1
  • Page 2 2

Toro Switch Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI