Allied Brass TD-GRS-16-PNI Installation guide

WALL

TIMBER STUD

1. Use a stud finder to accurately locate the center of the stud.

2. Remove Cap on end of post to allow opening for mounting screw.

3. Place Grab Bar on wall at desired mounting location and mark drill hole location

with pencil. Mark is made by inserting pencil through the end post and marking

location of small hole at bottom of post.

4. Drill 3/16" hole into the wall studs.

5. Mount and position end posts to the drilled holes.

6. Fasten the Grab Bar to mounting surface using #12 Pan Head Screw supplied

and tighten.

7. Replace Cap on posts.

Ø3/16" HOLE

TD-GRS

INSTALLATION INSTRUCTIONS (TIMBER STUD ONLY)

No portion of this document or any artwork contained herein should be reproduce anyway withouth the express written consent of ALLIED BRASS INC.

This manual is also suitable for

Download PDF