Qtx MBM-1 User manual

Qtx
Brand
Qtx
Model
MBM-1
Type
User manual

This manual is also suitable for

QTX MBM-1 is a battery-powered mirror ball motor, perfect for small to medium-sized events or parties where mains power is unavailable. It can rotate mirror balls weighing up to 2kg at a steady 6rpm, and its adjustable hinge allows for precise positioning. Installation is simple, and it operates with a single 1.5V D-type battery (not included).

QTX MBM-1 is a battery-powered mirror ball motor, perfect for small to medium-sized events or parties where mains power is unavailable. It can rotate mirror balls weighing up to 2kg at a steady 6rpm, and its adjustable hinge allows for precise positioning. Installation is simple, and it operates with a single 1.5V D-type battery (not included).

MBM-1
Battery Powered Mirror Ball
Motor
Item ref: 153.106UK
User Manual
Introduction
Thank you for choosing the QTX MBM-1 battery powered mirror ball motor.
This item will provide a convenient solution for small to medium tasks where no mains power is available.
Please read the below instructions to ensure proper implementation and avoid damage through misuse.
153.106UK User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
General safety
The MBM-1 is intended for indoor use only. Keep away from damp or humid environments.
Keep the motor and housing dust free and do not allow particles to enter the mechanism.
Clean the MBM-1 periodically with a dry, lint free cloth. Do not use solvents on the casing.
Keep away from heat sources or direct sunlight.
Installation
The MBM-1 mirror ball motor is powered by a single 1.5V cell (D type) which should be installed before
installation. Open the battery compartment and connect the D cell, ensuring the correct polarity as
indicated.Positioning of the mirror ball motor is very important. Safety is the most important factor. Please
note the following to avoid failure and possible injury…
The motor and mirror ball should be out of reach to avoid tampering
The mirror ball should not weight more than 2kg
The chain holding the mirror ball should be adequate for the load
The fixing into the ceiling must be strong enough to hold both mirror ball and motor
Operation
To start the motor rotation, slide the side-mounted switch to the on position. The spindle will rotate and
so the mirror ball will rotate also. The MBM-1 is hinged to allow some sideways movement if the load is
not perfectly symmetrical. Remember to switch off when not needed to preserve the battery. If not being
used for long periods, remove the battery and store in a dry place.
Battery
1.5V (1 x D) not supplied
Max. weight load
2kg
Rotation per minute
6rpm
Dimensions
180 x 50mmØ
Weight
130g
Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or
Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.
The goods must be disposed of according to your local council guidelines.
Errors and omissions excepted.
Copyright© 2013. AVSL Group Ltd.
  • Page 1 1
  • Page 2 2

Qtx MBM-1 User manual

Qtx
Brand
Qtx
Model
MBM-1
Type
User manual
This manual is also suitable for

QTX MBM-1 is a battery-powered mirror ball motor, perfect for small to medium-sized events or parties where mains power is unavailable. It can rotate mirror balls weighing up to 2kg at a steady 6rpm, and its adjustable hinge allows for precise positioning. Installation is simple, and it operates with a single 1.5V D-type battery (not included).

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents