2. Harbor Freight Tools
  3. Item 94354

Harbor Freight Tools Item 94354, 94354, Swivel Handle for Wooden Dolly Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Harbor Freight Tools Item 94354 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Swivel Handle For Wooden Dolly
Copyright © 2006 by Harbor Freight Tools. All rights reserved. No portion of this manual or any
artwork contained herein may be reproduced in any shape or form without the express written
consent of Harbor Freight Tools.
For technical questions please call 1-800-444-3353
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at: http://www.harborfreight.com
94354
660 Lb. Towing Ability
( Works with Harbor Freight Tools SKU # 92486, 93888 and 38970 Furniture Dollys)
ASSEMBLY & OPERATING INSTRUCTIONS
1. Read and fully understand this instruction sheet before using the Handle.
2. The maximum towing capacity is 660 LBS. Do not exceed this limit.
3. Always wear ANSI-approved safety goggles when working with tools and equipment.
4. Always keep arms, feet, legs, etc. out from under the furniture dolly. Children should
always be kept at a safe distance. Never allow children to play with or ride on a dolly.
5. Make sure the Handle for the Wooden Dolly is securely connected to the furniture dolly
before attempting to move any furniture.
6. The furniture dolly should only be used on a flat and level surface. Make sure the load is
evenly distributed on the furniture dolly before moving it.
SKU 94354 Page 2
ASSEMBLY & OPERATING INSTRUCTIONS
Figure 1
The Handle for Wooden Dolly is attached to a furniture dolly (not included) using the four
screws included with this product. Position the Handle in the middle of the furniture
dolly, as shown in Figure 2. Mark the placement for the screws. Use a small diameter
drill bit (one smaller than the screws) to drill four pilot holes. Use a Philips Head screw-
driver to thread the screw through the Handle and into the furniture dolly (not included), as
shown in Figure 2.
The Handle is adjustable from 27-1/2” to 38-1/4”. Remove the Adjusting Bolts, as shown in
Figure 1, and move the handle to the desired length. Then insert the same bolts back into
the handle and tighten them using a wrench.
Adjusting
Bolts
Figure 2
Holding Bracket
The Handle comes with a plastic Holding Bracket, as shown in Figure 2. After installing the
Handle, mark the spot for the Holding Bracket. Drill pilot holes and screw the Bracket into
the furniture dolly to secure it.
Mounting Screws
/