Melissa 646-057 User manual

Type
User manual
SE Matberedare
...........................................................................
2
DK Foodprocessor ..................................................................... 4
NO Foodprosessor ..................................................................... 6
FI Monitoimikone ...................................................................... 8
UK Foodprocessor
...................................................................
10
DE Küchenmaschine ................................................................ 12
PL Robot kuchenny
...................................................................
14
646-057
Design Function
10
10
INTRODUCTION
To get the best out of your new appliance, please read this
user guide carefully before using it for the first time. We also
recommend that you keep the instructions for future reference,
so that you can remind yourself of the functions of your
apparatus.
SAFETY MEASURES
Normal use of the appliance
Incorrect use of this appliance may cause personal injury
and damage.
Use for its intended purpose only. The manufacturer is
not responsible for any injury or damage resulting from
incorrect use or handling (see also Guarantee Terms).
For connection to 230 V, 50 Hz only.
The motor section or cord of the appliance must not be
submerged in water or any other liquid.
Do not operate with wet or damp hands. Make sure that no
liquid gets into the motor section.
Never leave unattended when in use, and keep an eye on
children.
The blade and grating/slicing disc must be handled with
caution, as these parts are extremely sharp. Always remove
the blade before emptying the jug.
Do not leave the appliance running for more than 1 minute
at a time. If the appliance has been running for more than 1
minute, leave it to cool down before you use it again.
Never use if the jug is empty.
For domestic use only.
Not for outdoor or commercial use.
NEVER use your fingers, kitchen utensils or similar to push
ingredients down the feed tube! Use the accompanying
tamper.
Do not remove any accessories until the appliance has
stopped completely.
Do not use the blade and the grating/slicing disc at the
same time in the jug.
Positioning the appliance
Always place the appliance at the back of the kitchen
counter.
Do not place next to hot areas, for example gas rings and
electric hotplates.
Cord, plug and mains socket
Ensure that the cord is fully extended.
Do not allow the cord to hang over the edge of a table/
counter, and keep it away from hot objects and naked
flames.
Check regularly that neither cord nor plug is damaged and
do not use if they are, or if the appliance has been dropped
or damaged in any other way.
If the appliance or plug is damaged, it must be inspected
and if necessary, repaired by an authorised repair engineer,
otherwise there is a risk of electric shock. Never try to repair
the appliance yourself.
Unplug before changing accessories, taking the lid off the
jug or cleaning, and when not in use.
Avoid pulling the cord when removing the plug from the
socket. Instead, hold the plug.
Check that it is not possible to pull or trip over the cord or
any extension cord.
KEY TO MAIN COMPONENTS OF THE APPARATUS
1. Power cord
2. Motor section
3. On/off button
4. Blade bushing for shaft (not visible in picture)
5. Jug
6. Motor spindle
7. Jug lid
8. Funnel
9. Tamper
10. Blade
11. Plastic cover for blade
12. Stirrer
13. Shredder
14. Blade
15. Citrus presser adapter
16. Citrus press
PRIOR TO FIRST USE
Before using for the first time, or after prolonged storage
without use, wash any parts that will come into contact with
food.
USING THE APPLIANCE
Place the motor section (2) on a flat surface, e.g. a kitchen
counter, and make sure it is standing firmly on the four
suckers underneath.
Fit the short end of the blade bushing (4) into the shaft hole
on the motor section.
Fit the jug (5) onto the blade bushing with the handle
pointing towards you. Lock the three studs on the motor
section into the three holes on the base of the jug.
Fit the motor spindle (6) on the stud in the middle of the jug.
Fit the required accessories, and place the ingredients into
the appliance as described below.
Start by turning the on/off button (3) to position “1” or “2”
and switch it off by turning it back to position “0”.
To use for brief food preparation, turn the on/off button to
position P (pulse function). The appliance will run at top
speed as long as you hold the button down in that position,
and will stop when you release the button, which then
automatically reverts to position “0”.
When using the knife (10) or blade (12), stop the food
processor at regular intervals and check whether the food
has been adequately blended/chopped.
UK
11
11
IMPORTANT! If using to chop different types of food (e.g.
raw meat followed by vegetables, or egg followed by fruit),
you must wash the parts that come into contact with food
between each type of food.
Using knife or stirrer
Remove plastic cover (11) from knife. Fit knife or stirrer to
motor spindle.
Place the food in the jug.
Fit lid (7) to jug and turn clockwise until the long plastic tab
locks into place on the motor section, and the three holders
along the lid edge engage the studs on the jug.
Start appliance.
Using the shredder
Fit the shredder (13) onto the motor spindle. Turn the blade
(14), so that the cutters are upwards. Press the shredder
under the studs on the drive. Turn clockwise until it locks.
Fit lid to jug and turn clockwise until the long plastic tab
locks into place on the motor section, and the three holders
along the lid edge engage the studs on the jug.
Start appliance.
Place food in jug through the funnel (8) a little at a time and
push down using the tamper (9).
TIP
If adding more food later, always use the funnel. Stop the
appliance before removing the stopper, to avoid splashes.
Always switch off before removing lid from jug.
If you need to scrape inside the jug, wait until the blade
has stopped completely before you remove the lid! Always
switch electricity supply to appliance off, or remove jug
completely, before scraping it. Use the spatula, never your
fingers.
Turn lid anticlockwise to remove.
Important! Do not use to crush ice and frozen berries.
Damage to the knife and motor can result.
Using the citrus press
Fit citrus press adapter (15) to accessories shaft and turn
clockwise until the long plastic tab locks into place on the
motor section, and the three holders along the lid edge
engage the studs on the jug.
Press citrus press (16) into place on the adapter.
Start appliance.
Storage
Ensure the appliance is clean and dry before storing.
CLEANING
Before cleaning, remove the plug from the wall socket.
The best way to clean the motor section is with a slightly
dampened cloth and, if necessary, a little detergent. Do
NOT immerse the motor section in any form of liquid!
The jug and all loose parts can be washed in soapy water.
Do not use any kind of strong or abrasive cleaning agent
on the appliance or its accessories. Never use a scouring
sponge or similar to clean it, as the surface may be
damaged.
INFORMATION ON DISPOSAL AND RECYCLING OF THIS
PRODUCT
Please note that this Adexi product is marked with this
symbol:
This means that this product must not be disposed of together
with ordinary household waste, as electrical and electronic
waste must be disposed of separately.
In accordance with the WEEE directive, every member
state must ensure correct collection, recovery, handling and
recycling of electrical and electronic waste. Private households
in the EU can take used equipment to special recycling
stations free of charge. In some member states you can, in
certain cases, return the used equipment to the retailer from
whom you purchased it, if you are purchasing new equipment.
Contact your retailer, distributor or the municipal authorities for
further information on what you should do with electrical and
electronic waste.
GUARANTEE TERMS
The guarantee does not apply:
if the above instructions are not followed
if the apparatus has been interfered with
if the apparatus has been mishandled, subjected to rough
treatment, or has suffered any other form of damage
if faults have arisen as a result of faults in your electricity
supply.
Due to the constant development of our products in terms of
function and design, we reserve the right to make changes to
the product without prior warning.
IMPORTER
Adexi Group
www.adexi.eu
We cannot be held responsible for any printing errors.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16

Melissa 646-057 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI