2. Primera
  3. Server XR

Primera Server XR, Bravo XR / XRP Integrated Kiosk Stand, XRP Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Primera Server XR Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1. Set the stand on a smooth flat surface. The dimensions of the stand are
listed below:
• Back of stand to front of bezel - 18.125" (46.038 cm)
• Back of stand to front of kiosk bin - 21.375" (54.3 cm)
• Height - 6" (15.25 cm)
• Height with XR - 13.0625" (33.18 cm)
• Height with XRP - 16.5" (41.91 cm)
• Width - 17" (43.18 cm)
2. Disconnect all cables from the XR or XRP.
3. Place the XR or XRP on top of the stand so that the feet on the XR/XRP
fit inside the corresponding holes in the stand.
4. The rubber bumpers on the top the stand should elevate the XR/XRP
slightly above the stand so that there is no metal to metal contact.
Note: Since there are no screws holding the XR/XRP on the stand please sepa-
rate the stand from the XR/XRP when transporting.
Thank you for purchasing the Disc Publisher XR/XRP Kiosk Stand .
This stand may be used with the Disc Publisher XR or Disc Publisher
XRP only. Follow the instructions below to setup your kiosk stand.
Rubber Bumpers
Kiosk Stand
Disc Publisher XR/XRP Kiosk Stand
Installation Instructions
121307-510997
© 2007 All rights reserved
/