American Standard 0790.001.020 User manual

Brand: American Standard

Model: 0790.001.020

Type: User manual

TOWN SQUARE

24"

PEDESTAL SINK

FIRECLAY

* See faucet section for additional models available

NOTES:

DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE

SUGGESTED.

▼ PEDESTAL ANCHORING SCREWS NOT INCLUDED.

■ FOR REINFORCEMENT ONLY. TAKE ACTUAL DIMENSIONS FROM

FIXTURE.

FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.

PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.

INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY.

IMPORTANT: Dimensions of xtures are nominal and may vary within the

range of tolerances established by ANSI Standard A112.19.9M.

These measurements are subject to change or cancellation. No responsibility

is assumed for use of superseded or voided pages.

1-1/4" O.D.

WASTE

24"

(610mm)

22"

(559mm)

SUPPLIES AS

REQUIRED

(152mm)

DRAIN

CHASE

OPEN

FLOOR

9-1/2"

(241mm)

20-1/4"

(514mm)

24"

(610mm)

FINISHED WALL

FINISHED

FLOOR

1-3/4" DIA.

STD. DRAIN

OUTLET

18-3/4" (476mm)

2-5/8"

(67mm)

(102mm)

5/8"

(16mm)

PED BASE

OUTLINE

PED TOP

OUTLINE

35-1/2"

(902mm)

28"

(711mm)

3-3/4" (95mm)

7-1/2"

(191mm)

(152mm)

10"

(254mm)

3/8" (10mm) DIA.

BASE ANCHOR

SCREW HOLES

ON 6" (152mm)

CTRS

3/8" (10mm) DIA.

SLAB ANCHOR

SCREW HOLES

ON 18-3/4" (476mm)

CTRS

TOWN SQUARE

24" PEDESTAL SINK

• American classic design

• Clean straight lines with classic ogee curves

• Rear overow

• Supplied with mounting kit

• Design-matched to Town Square xture

and faucets

• Right Height™ for greater comfort during use

• Made from reclay

❏ 0790.400 Faucet holes on 4" (102mm) centers

❏ 0790.800 Faucet holes on 8" (203mm) centers

❏ 0790.100 Center hole only

Nominal Dimensions:

24" x 20-1/4" x 35-1/2"

(610 x 514 x 902mm)

Separate Components:

❏ 0790.004 Pedestal top 4" (102mm) centers

❏ 0790.008 Pedestal top 8" (203mm) centers

❏ 0790.001 Center hole only

❏ 0031.000 Pedestal only

Bowl sizes:

14" (356mm) wide

11-3/4" (298mm) front to back

6-1/2" (165mm) deep

Compliance Certications -

Meets or Exceeds the Following Specications:

• ASME A112.19.9M for Non-Vitreous

Ceramic Fixtures

• CAN/CSA B45 Series

Revised 2/08

To Be Specied:

❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Black

❏ Town Square Faucet:

❏ Centerset Lavatory Faucet: 2555.201 (shown)

❏ Widespread Lavatory Faucet: 2555.801

❏ Other Lavatory Faucet*:

❏ Faucet Finish:

❏ Supplies:

❏ 1-1/4" Trap:

American Standard 0790.001.020 User manual

American Standard 0790.001.020 User manual

American Standard 0790.001.020 User manual

Related papers

Other documents