JS998SH/TH/KH/BH – GE Profile
™
30" Slide-In Electric Range with Trivection
™
Technology
Dimensions (in inches)
Note: Cabinets installed adjacent to slide-in electric ranges must have an
adhesion spec of at least 194°F temperature rating.
Note: All 30" Slide-In Ranges conform to U.L. requirements for 0" spacing from range
to adjacent walls below countertop. To reduce possibility of scorching the side walls
above the countertop when no load is present on burners, it is recommended that a
minimum 6" spacing from adjacent side wall be allowed for possible extended high-
heat element operation.
Receptacle Locations: For all 30" Slide-In Ranges locally approved flexible service
cord or conduit must be used because terminals are not accessible after range
installation. See shaded area in drawing for location of electrical outlet box. Recom-
mended outlet locations allow range to be installed directly against rear wall.
Accessory Backguards
(Attaches to the back of range as a backguard when unit is installed in
30" free-standing cutout)
JXS37WW – White
JXS37CC – Bisque
JXS37BB – Black/Stainless
Installation Information: Before installing, consult installation instructions
packed with product for current dimensional data.
KW Rating
240V 12.8
208V 9.6
Breaker Size
240V 40 Amps
208V 40 Amps
For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center
®
service, 800.626.2000.
Specification Revised 7/05
220450
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Acceptable
Electrical
Outlet Area
30" Min.
30" Min.
Shave Raised Edge To Clear
31-1/8" Wide Control Panel
2000_slide_in.eps
2-7/8"
To
Front
Surface Of
Countertop
20-5/8" Door
Clearance
From Front
Surface of
Countertop
31-1/4
30
27-1/2
36
Recommended
6" Min.
From
Walls
23-3/16
15" Min.
A/B
13" Max.
2-1/2
30
25
9/16
7-1/2
2-1/2
Accessory
Backguard
24
Acceptable
Electrical
Outlet Area
30" Min.
30" Min.
Shave Raised Edge To Clear
31-1/8" Wide Control Panel
2000_slide_in.eps
2-7/8"
To Front
Surface Of
Countertop
20-5/8" Door
Clearance
From Front
Surface of
Countertop
31-1/4
30
27-1/2
36
Recommended
6" Min.
From
Walls
23-3/16
15" Min.
A/B
13" Max.
2-1/2
30
25
9/16
7-1/2
2-1/2
Accessory
Backguard
24
Listed by
Underwriters
Laboratories
28-1/4*
36
Maintain
at least 6"
from nearest
combustible
surface.
Acceptable
Electrical
Outlet Area
30" Slide-In Range
Dimensions (in inches)
45-1/8
2-1/4
5
6
4-1/2
30
30 Min.
15 Min.
6
30" Slide-in Elec. Range
Aug. 8, 2003 -km
23-3/16
30
30
If you are NOT using the
Filler strip or Backguard:
If you are using the
Filler strip or Backguard:
25
*Wall to front of
closed door handle
on model JSP34
.
28" on models
JSP26/JSS26/16.
Note: Range may be placed with 0" clearance (flush) at the back wall and side walls
below countertop if the range side trims above the countertop extend beyond the cabinet
fronts at least 1/4". (Self-clean models only.) Maintain at least 6" distance from nearest
combustible surface.
30
31-1/2
28-1/4*
36
Maintain
at least 6"
from nearest
combustible
surface.
Acceptable
Electrical
Outlet Area
30" Slide-In Range
Dimensions (in inches)
45-1/8
2-1/4
5
6
4-1/2
30
30 Min.
15 Min.
6
30" Slide-in Elec. Range
Aug. 8, 2003 -km
23-3/16
30
30
If you are NOT using the
Filler strip or Backguard:
If you are using the
Filler strip or Backguard:
25
*Wall to front of
closed door handle
on model JSP34
.
28" on models
JSP26/JSS26/16.
Note: Range may be placed with 0" clearance (flush) at the back wall and side walls
below countertop if the range side trims above the countertop extend beyond the cabinet
fronts at least 1/4". (Self-clean models only.) Maintain at least 6" distance from nearest
combustible surface.
30
31-1/2