Product Data Sheet
PROPINK Complete
™
Fabric
Description
PROPINK Complete Fabric is a
spunbond polypropylene, non-
woven material designed for the
speci c needs of insulating wall
and ceiling cavities in new
residential building construction.
Its primary function is to provide
the insulation retention
membrane for the PROPINK
Complete Blown-in Wall System.
In addition, PROPINK Complete
Fabric may be left exposed on
wall or oor assemblies insulated
with unfaced glass ber batt and
roll insulation.
PROPINK Complete can also be
used as a solution for un nished
basement ceilings and walls
providing a smooth surface
over unfaced ber glass blanket
insulation.
Product Attributes
Durability
PROPINK Complete Fabric is
designed to resist tearing during
the installation process.
Performance
The unique structure of
PROPINK Complete Fabric
allows air to pass through but not
glass bers during the installation
process.
Translucent
PROPink Complete Fabric is
translucent so framing members
are clearly visible for easy
application. It also allows a
convenient visual check when
installing PROPINK Complete
insulation.
Dimensions
PROPINK Complete Fabric is
available in sheets measuring 9+
feet wide by 611 feet long.
Handling
The sheets are folded and
shipped in easy to handle 4 – 4 ½
feet wide by 14 inch diameter
rolls weighing 38–40 lbs. each.
Design Considerations
Owens Corning does not
recommend using PROPINK
Complete Fabric with glass ber
loose ll insulation products other
than PROPINK Complete.
Owens Corning will not accept
liability when the product is not
installed according to instructions.
The perm rating for PROPINK
Complete Fabric is well above 5
and, therefore, will not act as a
water vapor retarder when
applied to wall and ceiling
assemblies.
Product Data
• When tested in accordance
with ASTM C 1338, PROPINK
Complete Fabric exhibited no
mold growth
• The surface burning
characteristics of this product
have been determined in
accordance with ASTM E 84
1
* Flame Spread: 0
* Smoke Developed: 5
1
This standard is used to measure and describe the
response of materials, products, or assemblies to heat
and ame under controlled conditions, but does not by
itself incorporate all the factors required for re-hazard
or re risk assessment of the materials, products, or
assemblies under actual re conditions. However, the
results of these tests may be used as elements of a
re risk assessment that takes into account all of the
factors pertinent to an assessment of the re hazard of
a particular end use. Values are reported to the nearest
ve (5) rating.
OWENS CORNING INSULATING SYSTEMS, LLC
ONE OWENS CORNING PARKWAY
TOLEDO, OHIO 43659
1-800-GET-PINK
™
www.owenscorning.com
P u b. N o. 5 9 12 6 - C . P ri n te d in U. S . A . Au gu st 2 0 0 7. T H E P I N K PA N T H E R™ & © 19 6 4 -
2007 Metro-Goldwyn-Mayer Studios Inc. All Rights Reserved.
The color PINK is a registered trademark of Owens Corning.
©2007 Owens Corning.
/
