Bosch SE70A591/17 Owner's manual

Brand: Bosch

Model: SE70A591/17

Type: Owner's manual

Auto Wash

Start

5 600 053 917 (8301) 635D–nf

Brief and handy:

everything your dishwasher

needs.

Before using for the first time,

still read the installation and

operating instructions!

Start programme Off we go

Press ”Start” in the main menu

Switch off the appliance Everything o.k.

When a buzzer has been emitted 5 times

(end of programme), press the main switch .

Fill with rinse aid

Fill with detergent

Select programme

with /-+ in main menu

Fill with salt

Turn on the tap

Switch on the appliance

To switch on, press main switch .

Summary of instructions for dishwasher

Options

Useful information when using the appliance for the first time

Before using the appliance for the first time

– Select the display language, see operating instructions

– Fill with salt and rinse aid, see below

– Adjust softening system, see operating instructions

Main menu:

– Clear text provides information about possible settings, operations

– Arrows identify the buttons which can be pressed

– Buttons enable settings, operations

Operating principle, display with buttons:

StartOptions

Auto Wash

Not required if softening system set to “0”. Required if “Refill salt” is displayed

Unscrew

the lid.

Only before using

the dishwasher

for the first time

pour approx. 1 l /

1 1/4 pt water into

the salt opening.

Pour in max.

1.5 kg / 3 lb 5 oz

salt (never deter-

gent!)

Screw on the

lid. Switch on

dishwasher

immediately.

Required if “Refill rinse aid” is displayed.

Press the

marking,

Lift the

lid

Pour in

the rinsing

agent

Close the

lid.

CLICK

Little dirt, little cleaning agent

Warning,

combination

products are not

suitable for all

programmes,

follow manufac-

turer’s instructions.

Pour in the

cleaning agent

Push the lid

too, press.

PLOP

Quick, economical or intensive

The programme data is based on laboratory

measured values in compliance with Euro-

pean standard EN 50242. Deviations are

possible in practice.

Programme overview

Duration in minutes

Power consumption in kWh

Water consumption in litres

Auto

Super

Wash

Auto Wash

Prerinse

only

Auto

Delicate

Wash

Quick

Wash

100-140

1,20-1,60

16-23

100-160

1,00-1,30

12-20

80-110

0,80-1,10

10-17

0,60

0,10

Options/standard settings Standard programmes

Select with “Options”, adjust with –/+, save with main menu/“Options”:

1. Timer programming

2. Reduce time

3. Degree of dryness

4. Buzzer volume

5. Water hardness

6. Rinse aid dosage

7. Language

8. Standard programmes

Duration in minutes

Power consumption in kWh

Water consumption in litres

135

0,65

Normal

Extra

Normal

Eco

Normal Normal

Plus

150

1,05

140

1,05

140

1,05

Maintenance and care

For perfect rinsing results

Filters

Check and,

if required,

clean:

Rotate filter cylinder,

remove filter system

Rinse under

running water

Insert Screw on filter

system.

NOTE MARK!

Spray arms

Remove blockages/

deposits

Pull up lower arm Unscrew upper arm Clean under running

water (if required, use

a toothpick)

Insert lower arm Screw on upper arm

Troubleshooting

Dealing with problems correctly ...

Fault Possible causes

Wrong language displayed

Appliance does not run/

stops ...

Utensils are

not clean ...

Sand or gritty

residue on the

utensils ...

Language adjusted

No/insufficient water

check whether ...

Utensils close together/on top

of each other ...

Insufficient detergent ...

Unsuitable programme ...

Spray arms blocked ...

Filters loose ...

Filters dirty ...

Spray arm nozzles blocked ...

Insufficient water ...

Switch off the appliance. Switch on

the appliance by holding down the

main switch until the display illumi-

nates. Select the language.

Turn on the water supply.

Supply fittings unobstructed

and not calcified.

Supply hose kink-free.

Arrange utensils according to

instructions.

Comply with manufacturer’s

specifications, select suitable pro-

gramme. Re-arrange obstacles

(e.g. large spoons).

Clean filters (see above),

attach correctly (MARK).

Clean filters (see above).

Clean spray arms (see above).

See “Appliance does not run”.

Remedial action

Programme does not start/does

not continue ...

Residual water in the appliance ...

Programme has not been

started ...

Door is open or was opened

before end of programme ...

If required, start the programme.

Close the door, wait until the

programme ends (buzzer

emitted 5 times).

Fault Possible causes Remedial action

Plastic parts/utensil

parts discoloured ...

Detergent with lower

bleaching effect ...

Insufficient detergent ...

Use detergent with chlorine

bleaching.

Comply with manufacturer’s

specifications.

Milky deposits on

the utensils

(removable) ...

Glasses cloudy/

dull ...

Rust on the cutlery ...

Rinse aid dosage too high

(visible streaking) ...

Rinse aid dosage too low ...

Water too hard ...

Glasses not dishwasher-proof ...

Detergent unsuitable ...

Cutlery not

rust-resistant ...

Reduce or increase dosage

according to instructions.

Refill with salt/adjust

softening system.

User dishwasher-proof glasses.

Use glass-friendly detergents.

Use dishwasher-proof cutlery.

Further information can

be found in the operating

instructions ...

Self-help is worthwhile!

Interrupting the programme ... Terminating the programme ...

Arranging utensils correctly ...

– Open the door.

– To continue the programme, close the door.

– Open the door and press the “Terminate programme” button.

– Close the door and wait until the buzzer is emitted 5 times.

– Restart the programme or switch off the appliance.

Arrange dishwasher-proof utensils (having removed any ash, wax, grease or ink. Coarsely remove

sticky labels, large remnants of jam, milk products or food) according to the operating instructions

and check that the spray arms can rotate freely.

Bosch SE70A591/17 Owner's manual

Bosch SE70A591/17 Owner's manual

Bosch SE70A591/17 Owner's manual

Related papers

Other documents