Handle Screw hole
Handle Screw hole
Handle Screw hole
Handle Screw hole
INSTRUCTION
How to install the door handles?
1. Tool required: Phillip screwdriver
2. Locate the handles. They are tied on the backside of the wine cooler.
3. Open the doors and locate the door seal
4. Pull the door seal to expose two screw holes for the door handle (
DO NOT
remove the entire
door seal).
5. Position the door handle and screw both screws from the other side. Do not over tighten the
screws.
6. Push the seal back in position. Test if the seal is installed properly by closing and opening the
door. You should feel a bit of suction when you open the door.
7. Please contact us at 1-800-330-0388 or [email protected] if any question.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI