Aiphone NE-SSV User manual

Category
Security cameras
Type
User manual

Aiphone NE-SSV is a vandal and weather resistant sub station designed for use with NEM, NDR and NDRM systems. It is constructed of 12 gauge stainless steel and has a stand alone color camera built in. The NE-SSV is capable of auto iris control and has a minimum illumination of 1.0 lux. The Effective Pixels are 510 (H) x 492 (V) NTSC. The camera is powered by a 12V DC, 100mA power supply, which is included with the unit. The NE-SSV has a built-in call button and speaker, allowing for hands-free communication.

Aiphone NE-SSV is a vandal and weather resistant sub station designed for use with NEM, NDR and NDRM systems. It is constructed of 12 gauge stainless steel and has a stand alone color camera built in. The NE-SSV is capable of auto iris control and has a minimum illumination of 1.0 lux. The Effective Pixels are 510 (H) x 492 (V) NTSC. The camera is powered by a 12V DC, 100mA power supply, which is included with the unit. The NE-SSV has a built-in call button and speaker, allowing for hands-free communication.

- INSTRUCTIONS -
The NE-SSV is a 2-gang vandal and weather resistant sub station designed for use with the NEM, NDR and NDRM
systems. It is constructed of 12 gauge stainless steel and has a stand alone color camera built in. It is also equipped with
an option for an external output contact closure when the sub station places a call (relay required). The unit either flush
mounts into a 2-gang box, or surface mounts using the SBX-2G. Each unit includes a 12V DC power transformer for the
camera, tamper proof screws, and a tool for installation.
Vandal Resistant Sub Station with built in Color Pinhole Camera for use with
NEM, NDR, NDRM Systems
INSTALLATION:
1. For flush mounting, install sub station in standard 2-gang electrical box with minimum 2-1/2" depth.
2. For surface mounting, use the SBX-2G surface mount enclosure (sold separately).
3. Only the 12V DC power transformer included should be used to power the NE-SSV camera.
5. IMPORTANT! These units are designed for use in normal weather conditions, and to allow drainage and
evaporation of moisture that naturally gets into the unit. Do not apply caulking or silicone sealant around the
unit when installing, and do not use weather stripping around the perimeter of the box when mounting. If
sealing the unit is required, the bottom must remain unsealed. Sealing the unit will prevent or inhibit moisture from
dissipating from inside the unit, which may cause corrosion or deterioration of the internal components over time.
Page 1
45cm
18”
67cm
26½”
Transparent corner shadowing
on the picture is normal.
Front View Back View
The view achieved if the subject is 20" from the
camera is: 18" Vertically and 26½” Horizontally
Speaker
Camera
Call button
50cm / 20”
50cm
20”
0607
Page 2
+
-
WIRING DIAGRAMS:
1
E
H
2
E
H
Red
Blk
Pur
Blu
NDRM Master
CP-544A board
NE-SSV
NE-SSV
(w/dry closure output)
PS-2420UL
RY-PA
Blk
Blk
Yel
Dry closure
output for
duration of
call-in
A+
A-
B+
B-
H
Q
E
S
B
Y
A1
V1
A2
V2
CP-544A board
Red
Blk
Pur
Blu
+
-
1
2
3
~
20
E
+
-
H
Red
Blk
Blu
Pur
NEM/NDR
Master
NE-SSV
(w/dry closure output)
PS-2420UL
RY-PA
Blk Blk
Yel
Dry closure
output for
duration of call-in
Red
Blk
Blu
NE-SSV
(w/corridor lamp)
Blu
Blu
NBY-4A
12V DC power input for camera
(Red - Must use supplied transformer)
12VDC power in (Red)
Video Out (Yellow)
12VDC power in
(Red)
Video Out (Yellow)
Video output to monitor
or CCTV system (Yellow)
12VDC power in (Red)
Video Out (Yellow)
Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005
(425) 455-0510
FAX (425) 455-0071
NE-SSV Instr.
0607JDJS
SPECIFICATIONS:
Audio Power Source: Supplied by master station
Speaker: 20 ohms, 4W, 2" diameter, water proof and puncture resistant, 2.4 oz. magnet
Call Button: SPST call button, momentary activation. Limited stop button.
Call Annunciation: Pressing the call button at sub activates and latches call at NEM/NDR/NDRM master. The master
station's LED will be lit and a ringing tone will be heard until the call is answered.
Communication: Hands free at sub. Master is push-to-talk or VOX with handset.
CCTV Camera Output: 75 Ohm, 1Vp-p, NTSC, DC-coupled
Iris Control: Auto
Minimum Illumination: 1.0 lux
Camera image sensor: 1/3" CCD
Focal Length: 4.3mm Cone Pinhole Lens (78°)
Effective Pixels: 510(H) x 492(V) NTSC
Camera Power Source: 12V DC, 100mA (via included power supply)
MTBF: (Mean Time Before Failure) 80,000 Hours
Faceplate: 12 gauge stainless steel
Mounting: Flush mount into a 2-gang box (minimum 2-½” depth) or surface mount into SBX-2G (sold separately)
Tamper proof screws included (6x32 for use with flush 2-gang box) with T-10 TORX bit
When using SBX-2G, use the hardware included with that unit.
Terminations: Color-coded prewired pigtails
Operating Temperature: 14
F ~ 140°F (-10°C ~ 60°C)
Audio Wiring: 2 conductors homerun; or 1 common plus 1 individual per sub, looped through each sub.
Shielded cable is recommended.
Use Aiphone #822202 or #821802 for homerun wiring, #822206 for up to 5 stations
on each run, or #822210 for up to 9 stations on each run.
Audio Wiring Distance: 420' with 22AWG; 1,000' with 18AWG
Video Wiring: Independent BNC connection from substation pigtail to destination video device
Dimensions (HxWxD): NE-SSV alone: 4-11/16" x 4-11/16" x 2"
With SBX-2G: 4-3/4" x 4-7/8" x 3-5/8" (Top) 2-3/8" (Bottom)
TOLL FREE TECHNICAL SUPPORT: (800) 692-0200
TOLL FREE FAX LINE: (800) 832-3765
TECHNICAL SUPPORT E-MAIL: [email protected]
Color Camera
Call Button
Yellow BNC connector for
video output
Red: # terminal of Master
Blue: Corridor Lamp (optional)
Black: E of Master
Purple: Relay for call-in closure (optional)
Speaker
NE-SSV BACK VIEW:
Red connector for 12V DC camera
power input (from included power supply)
Power supply dimensions:
1-" W x 2-¼” H x 1-” D
6' DC cord.
NOTE: If using fiber optic interface, the video input on
the IFS VIC-5211 is not compatible with the NE-SSV
camera. The VIC-5211 can be used for audio only,
with a separate fiber module required for video.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Aiphone NE-SSV User manual

Category
Security cameras
Type
User manual

Aiphone NE-SSV is a vandal and weather resistant sub station designed for use with NEM, NDR and NDRM systems. It is constructed of 12 gauge stainless steel and has a stand alone color camera built in. The NE-SSV is capable of auto iris control and has a minimum illumination of 1.0 lux. The Effective Pixels are 510 (H) x 492 (V) NTSC. The camera is powered by a 12V DC, 100mA power supply, which is included with the unit. The NE-SSV has a built-in call button and speaker, allowing for hands-free communication.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI