B00B7GV4JC
2
Instruction Manual • English
AmazonBasics Wireless Keyboard
& Wireless Mouse Combo
3
Contents
• Wireless Keyboard
• Wireless Mouse with receiver
(inside battery compartment)
• 4 AAA batteries
• Quick start guide
• This instruction manual
Setup:
Keyboard
1. Remove the battery cover
on the bottom of the
keyboard.
2. Insert two batteries. Make
sure that the + and -
symbols on the batteries
align with the + and -
symbols inside the battery
compartment.
3. Replace the battery cover.
4. Place the keyboard near
the computer.
Mouse
1. Remove the battery cover
on the bottom of the
mouse.
2. Insert two batteries over
the plastic tab. This tab
will help you remove the
4
-
+
+
ON
OFF
C
O
N
N
E
C
T
-
+
Place batteries over plastic tab
-
+
batteries.
3. Remove the receiver
stored between the two
batteries.
4. Replace the battery
cover.
6. Insert the receiver into a
USB port on your
computer.
Note: The LED on top of the
mouse lights when the
batteries need to be
replaced.
To Use:
On the bottom of the mouse,
switch the button to ON. The
optical sensor lights, the
computer detects the mouse
and the keyboard. The
keyboard and mouse are
ready to use.
5
-
+
ON
OFF
C
O
N
N
E
C
T
ON
OFF
C
O
N
N
E
C
T
OFF
ON
6
Note: When not in use, turn the mouse OFF and store the
receiver inside the battery compartment.
Keyboard Hot Keys Function
Mouse Overview
Go forward
Go back
Play/Pause
Internet
Browser
Home
Mute
Decrease
volume
Increase
volume
Previous
Track
Launch
Email
Next
Track
Left-click
button
Right-click
button
Scroll
wheel/3rd
button
Low battery
LED
7
Troubleshooting
The mouse does not operate or is not recognized and the optical sensor on the
bottom of the mouse does not light
• Make sure the batteries are installed correctly. Match the
+/- symbols on the battery to the +/- symbols in the battery
compartment.
• Make sure the power switch is in the ON position.
• Try plugging the receiver into a different USB port.
• Move the mouse to a different surface. Transparent
surfaces like glass, dark surfaces, reective surfaces like
mirrors, and rough surfaces are not recommended.
• Press the CONNECT button on the bottom of the mouse to
reestablish a connection between the mouse and the
receiver.
• If the optical sensor does not light, turn the mouse off, then
on. If the optical sensor still does not light, replace the
batteries.
Cursor moves erratically or misses button clicks
• Remove metal objects between the mouse and receiver.
• Try moving the receiver to a different USB port.
• Check battery power by turning the mouse off, then on. If
the optical sensor does not light, replace the batteries.
8
The LED on the top of the mouse is lit
• This indicates the batteries are low. Replace the batteries.
Keyboard is not working
• Position the keyboard closer to the receiver.
• Replace the batteries.
Cleaning the keyboard and mouse
Use a damp cloth or gentle cleaning wipes intended for
keyboard/mouse cleaning.
Specications
• Supported operating system—Windows® 8/Windows®7/
Windows® XP/Windows Vista®/Windows® 2000
• Operating temperature—0°C ~ 40°C
• Battery life—Mouse: 300 hours; Keyboard: 900 hours
• Operating distance—32 feet (10 meters)
Battery Warning Statement:
• Keep batteries out of the reach of children.
• Insert the batteries in the proper direction as indicated by positive (+) and negative (-) markings in battery
compartment.
• Do not mix old and new batteries or batteries of different types (for example, carbon and alkaline batteries).
• Always remove old, weak, or worn-out batteries promptly and recycle or dispose of them in accordance with
Local and National Disposal Regulations.
• If a battery leaks, remove all batteries and recycle or dispose of them in accordance with battery
manufacturer's instructions and Local and National Disposal Regulations. Before inserting new batteries,
thoroughly clean compartment with a damp paper towel or follow battery manufacturer's recommendations
for cleanup. If uid from the battery comes into contact with skin or clothes, ush with water immediately.
• Remove batteries if your device is to be stored for an extended period of time without being used.
PRODUCT DISPOSAL INFORMATION
Dispose of this product in accordance with Local and National Disposal Regulations.
All electrical and electronic equipment must be marked with the symbol above to indicate that it is not to be
disposed of with your household waste.
Regulatory Information: Disposal of Waste Electrical and Electronic Equipment (WEEE)
The Waste Electrical and Electronic Equipment (WEEE) Directive aims to minimize the impact of electrical
and electronic goods on the environment, by increasing re-use and recycling and by reducing the amount of
WEEE going to landll. The symbol on this product or its packaging signies that this product must be
disposed separately from ordinary household wastes at its end of life. Be aware that this is your responsibility
to dispose of electronic equipment at recycling centers in order to help conserve natural resources.
Each country should have its collection centers for electrical and electronic equipment recycling. For
information about your recycling drop off area, please contact your related electrical and electronic equipment
waste management authority, your local city ofce, or your household waste disposal service.
FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, Pursuant to
Part 15 the FCC rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
9
Made in China
© 2013 Amazon.com, Inc. or its afliates. All Rights reserved. Amazon and the AmazonBasics logo are trademarks
of Amazon.com, Inc. or its afliates.
10
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Responsible party: AmazonBasics • 410 Terry Avenue North, Seattle, WA 98109-5210, U.S.A.
1-866-216-1072
13-0147
/
