Whirlpool AWO/C 62200 User guide

Brand: Whirlpool

Model: AWO/C 62200

Category: Washing machines

Type: User guide

This manual is also suitable for

GB PROGRAMME CHART

E. Programme selector

F. “Start/Pause” button

G. Spin speed selector

H. Programme sequence indicator

I. “Reset” button

J. “Start delay” button

Acustic noise level :

Washing - 59 dB(A) / 1 pW

Spinning - 1400 rpm 77 dB(A) / 1 pW

- 1200 rpm 75 dB(A) / 1 pW

- 1000 rpm 74 dB(A) / 1 pW

A. “Door open” indication

This washing machine is equipped with

automatic safety functions which detect

and diagnose faults at an early stage

and react appropriately, e.g.:

B. “Service” indication

C. “Water tap closed” indication

D. “Clean pump” indication

Programme

Care

Labels

Max.

Load

Type of wash / Notes

- respect the manufacturer's recommendations on the care label

Detergents and Additives Special options

Max

Spin

Speed

rpm

Pre-

wash

Main

Wash

Softener Pre-

wash

Rapid Start

delay

Clean+ Cold

wash

Intensive

rinse

Easy

ironing

Rinse

hold

Spin

Cotton/

Antibacterial

95 °C

6.0

Normally to heavily soiled and robust white cotton laundry. In case of heavy soiling or

stains, you can add an oxygenbased bleach additive which can be used at 95°C. This

programme eliminates bacteria, ensuring sanitization of your laundry.

Yes

i i

–

i i

–

i i i i

Max.

Cotton

40 - 60 °C

6.0

Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc.

made of cotton and linen.

Yes

i i i i i i i i i i

Max.

SuperEco

60 °C

6.0

Heavily soiled and robust laundry made of cotton, synthetics and their blends.

Economical energy consumption by prolonged wash duration - ideal to be run overnight to

profit from more favourable energy rates. Avoid noise of spinning at night by setting the

spin speed to “0” and start spin programme in the morning, or by defining programme start

with “Start delay” accordingly. - For garments with a high share of synthetic fibres, we

recommend to use a laundry net.

– Ye s

– –

–

i i

–

i i

Max.

Synthetics

30 - 40 - 60 °C

3.0

Normally soiled garments made of artificial fibres (like polyester, polyacryl, viscose

etc.) or their blends with cotton.

Yes

i i i i

–

i i i i i

Max.

Delicates

30 - 40 °C

1.5

Curtains and delicate clothing, dresses, skirts, shirts and blouses.

Yes

i i

–

– –

i i

1000

Daily load

40 °C

3.0

Slightly to normally soiled robust laundry made of cotton, linen, artificial fibres and

their blends. Effective one-hour programme. Make sure to wash only similar colours

together in one wash load.

– Ye s

– –

–

i i i i i

Max.

Quick wash

30 °C

3.0

Shortly worn clothing made of cotton, polyester, polyamide and blends with cotton.

Brief programme to refresh your laundry.

– Ye s

– –

–

– –

i i

Max.

Wool

Cold - 40 °C

1.0

Only woollens, labelled with the Woolmark and identified as machine washable.

– Ye s

– –

–

– –

i i

1000

Handwash

40 °C

1.0

Textiles made of silk, linen, wool and viscose marked as “handwashable”.

– Ye s

– –

–

– –

i i

400

Lingerie

30 °C

1.0

This programme is particurarly suitable to treat delicate lingerie (use of laundry net

strongly recommended).

– Ye s

– –

–

– –

i i

400

Rinse & Spin

–

6.0

Same as the last rinse and the final spin in the “Cotton” programme.

– –

–

i i

Max.

Spin

–

6.0

Intensive spin. Same as the spin cycle in the “Cotton” programme.

– – – – –

Max.

Drain

–

Drain only - no spinning. Alternative method of terminating programme after “Rinse hold”.

– – – – –

– – – – – – –

i : option / Yes : dosing required

For improved garment care spin speed is restricted in these programmes.

Whirlpool is a registered trademark of Whirlpool USA.

5019 300 00447

Programme

Temperature

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

without “Rapid”

Approx. programme duration

(hours : minutes)

without “Rapid” with “Rapid”

Cotton/Antibacterial 95 6.0 59* 1.90 2:00 -

Cotton * 60 6.0 49 0.78 4:00 2:30

Cotton * 60 3.0 37 0.69 2:20 ***

Cotton 40 6.0 54 0.65 2:45 1:45

Cotton * 40 3.0 37 0.58 2:30 ***

SuperEco 60 6.0 51 0.72 4:00 -

Synthetics 60 3.0 50* 0.70 1:30 1:09

Synthetics 40 3.0 46 0.50 1:15 0:54

Delicates 30 1.5 50 0.50 0:45 -

Daily load 40 3.0 45 0.45 1:00 -

Quick wash 30 3.0 40 0.40 0:30 -

Wool 40 1.0 55 0.60 0:45 -

Handwash 40 1.0 45 0.60 0:40 -

Lingerie 30 1.0 45 0.50 0:36 -

Whirlpool is a registered trademark of Whirlpool USA.

5019 300 00447

CONSUMPTION DATA

LOAD LAUNDRY, ADD DETERGENTS

AND SELECT THE PROGRAMME

SELECT ANY DESIRED OPTION

“DOOR OPEN” INDICATION

Before starting and after end of a programme, the lamp

lights to show the the door can be opened. As long as a

wash programme is running, the door remains locked and

must on no account be forced open. In case you have an

urgent need to open it during a running programme, refer to

“Cancel (Reset) a running programme before the end”.

Push the button of any option desired - the respective

indication lamp lights up. If the combination of programme

and additional option(s) is not possible, the indication lights

switch off automatically.

“Prewash” button

• Adds a prewash cycle to the wash programme selected;

prolongs the programme by about a quarter of an hour.

• Recommended for heavily soiled laundry (e.g. with sand

or granular dirt).

• Do not use liquid detergent for the main wash when

activating the “Prewash” option.

PROGRAMME START

Open the tap and press the “Start/Pause” button.

The indication lamp next to the “Start/Pause” button lights

up. The programme sequence indicator shows the current

programme phase, running from left to right through Wash,

Rinse, Spin/Drain.

When the laundry load is detected or the programme

duration is updated, the display shows an animation.

PROGRAMME END

The “Door open” indicator lights up, and the display shows

“End”. After about a quarter of an hour, the washing

machine will switch off completely to save energy.

1. Turn the programme selector to the “Off/O” position.

2. Close the water tap.

3. Open the door and unload the machine.

4. Leave the door ajar to allow the drum to dry.

CHANGE PROGRAMME AND/OR OPTIONS

AFTER PROGRAMME START

1. Press the “Start/Pause” button to pause the

programme. The light blinks.

2. Select the new programme, any options and another

spin speed if you want.

3. Press the “Start/Pause” button again.

The new programme continues at the same position

where the previous programme was interrupted.

Do not add detergent for this programme.

CANCEL (RESET) A RUNNING PROGRAMME

BEFORE THE END

“Rapid” button

• Enables quicker washing by shortening the programme

duration.

• Recommendable for only lightly soiled laundry.

• Not selectable for Cotton 95°C.

“Clean+” button

• Choose this option if you use an in-wash additive for

stain removal (powder, for example “Vanish”) - it will

optimize the additive’s efficiency to get better wash

performance and stain removal.

• Use with the maximum load.

• Add an appropriate amount of in-wash additive for stain

removal (powder) to the main wash chamber, together

with your detergent (only use powder detergent with this

option). Respect the manufacturer’s dosing instructions.

• May prolong the programme by up to 15 minutes

• Appropriate for use of stain removers and bleaches

on oxygen basis. Chlorine or perborate bleaches

must not be used!

“Cold wash” button

• Saves energy used for water heating while maintaining

good wash result.

• Recommendable for lightly soiled laundry without stains.

• Make sure that your detergent is suitable for cold

wash temperatures (15 or 20 °C).

• Mainly selectable on the lowest temperature step of

the programmes.

“Intensive rinse” button

• More water is added and rinse cycle is prolonged.

START DELAY

Load the laundry, close the door and add detergents as

indicated on the front page and as described in the chapter

“Detergent and Additives” in your Instructions for Use.

Turn the programme selector to the desired programme

and temperature. The display shows the programme

duration and the predefined spin speed. The indication lamp

next to the “Start/Pause” button blinks.

If you do not start the programme soon after having

made your choice, the washing machine will switch off

automatically after about a quarter of an hour. To switch the

washing machine on again, turn the programme selector to

“Off/O” and afterwards to the desired programme again.

• This option is particularly suitable for areas with very soft

water, washing baby linen and helps people with allergies

“Easy ironing” button

• Reduces creasing by an increased water quantity and

a very gentle spin.

“Rinse hold” button

• The laundry remains in the last rinse water without

pregressing to the final spin cycle to avoid creasing and

prevent colours from changing.

• It is particularly useful if you want to postpone spinning to

a later time, or if you want to drain only.

• The programme stops to “Rinse hold” at the time the

“Rinse hold” lights in the preogramme sequence

indication is on. The “Start/Pause” indicator blinks.

Terminate the “Rinse hold” option:

• Press the “Start/Pause” button; the programme will

terminate automatically with the final spin cycle for the

present wash programme.

• If you do not wish to spin the clothes, turn the

programme selector to the “Drain” programme and press

the “Start/Pause” button.

“Spin” button

• Every programme has a predefined spin speed.

• Press the button to set different spin speed.

• If spin speed “0” is selected, the final spinning is cancelled

but intermediate spin peaks remain during rinse.

The water is drained out only.

The “Start delay” allows to run the machine at the

consumer’s convenience, for example at night when

electricity is cheaper. Do not use liquid detergent when

activating “Start delay” option.

• Select programme, temperature and options.

• Press the “Start delay” button to select the desired

delay time up to 23 hours.

• Press the “Start/Pause” button. On the display, the start

delay symbol and the dot between hours and minutes

blink. The countdown of the delay time begins.

• The time delay indication disappears when the

programme starts and it is replaced by the remaining

programme time.

• Once having pressed the “Start/Pause” button, the delay

time can be reduced by pressing again the “Start delay”

button.

To cancel the “Start delay”

...before you press the “Start/Pause” button:

• Turn the programme selector to another position or

press the “Reset” button.

...after having pressed the “Start/Pause” button:

• Press the “Start/Pause” button - the start delay time

disappears from the time display.

FAILURE INDICATIONS

The “Reset” button cancels a programme before the end.

• Press and hold the “Reset” button for a few seconds.

Any existing water is drained out. It may last some time

until the door can be opened.

Consumption values were measured in normalized conditions, in compliance with IEC/EN 60456. In the home, they may vary depending on the individual

water supply pressure and temperature, the load and the type of wash. The consumption data indicated are based on an inlet water temperature of approx.

15°C through the cold fill valve as well as the hot fill valve (if available). If your washing machine has a hot fill valve, connection of this valve to hot water supply

will lower the energy consumption by reduced heating times, depending on the individual hot fill inlet water temperature. Water and energy consumptions

refer to the default setting of the programmes, with temperature and load as indicated in the table; selecting any options or changing the spin speed will also

change the consumption data.

The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also

“Troubleshooting Guide” in your Instructions for Use).

* Reference programmes for Energy Label. For reasons of energy saving, the real water temperature may deviate from the declared cycle temperature.

** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

*** Automatic adaptation of programme duration after detection of wash load

Power consumption in off-mode 0.16 W / in left-on mode 0.16 W

In case of any failures or irregularities, consult the

“Troubleshooting Guide” in your Instructions for Use.

“Water tap closed”: no or not sufficient inlet water.

”Service”: failure or malfunction of an electrical

component.