Polar ART 463/A++ Owner's manual

Brand: Polar

Model: ART 463/A++

Category: Fridge-freezers

Type: Owner's manual

Prior to replacing bulbs or LED lights, disconnect the refrigerator from the power supply, then follow the

respective instructions depending on the type of lighting the appliance is fitted with.

To replace the bulb, use the same type of bulbs that are available at the service centre or supplied by authorized

representatives.

1) type of lighting

1. Unscrew the bolts and take off the bulb cover.

2. The lamp is fitted with the pin type bulb, therefore, do not pull it

out or unscrew. Turn it in the direction indicated by the arrows.

3. After inserting a new bulb, set back the bulb cover and wait for

five minutes before connecting the appliance to the mains.

2) type of lighting

To remove the bulb, turn it counterclockwise, as indicated in the

Figure. Wait for 5 minutes before connecting the appliance to the

power supply.

3) type of lighting

If the appliance is fitted with LED lighting that needs replacement,

contact the service centre.

LED lighting serves longer than standard bulbs and

provides evener and more environment-friendly lighting.

Regularly clean the appliance using a cloth and warm water solution as well

as neutral cleaning detergents for cleaning the inside of the refrigerator. Do

not use abrasive detergents. Regularly clean the thaw water drain outlet

located on the rear wall (beside the fruit and vegetable shelf) using the

provided tool in order to drain the thaw water correctly (see the Figure).

Before carrying out maintenance or cleaning, disconnect the appliance from

the mains or discontinue power supply.

Connect the appliance to the mains.

In some models, an acoustic signal can be heard indicating that the temperature alarm is activated. To

deactivate the signal, press and hold the knob. If the appliance is fitted with the antibacterial un odour

eliminating filter, insert it into the fan, as indicated in the instructions.

Note: after switching on, the refrigerator needs approximately 4-5 hours to reach the temperature necessary for

storage of usual quantity of food.

FIRST TIME USE

APPLIANCE MAINTENANCE AND

CLEANING

BULB OR LED LIGHT REPLACEMENT

(Depending on the Model)

Disconnect the appliance from the mains, empty, defrost (if necessary), and clean. Leave the doors ajar to allow

the air circulation in the appliance. This prevents the formation of mould and unpleasant odours.

WHEN THE APPLIANCE IS NOT USED

Do not open the doors, so that to ensure storage of food in cool conditions as long as possible. Do not refreeze

partially thawed food. If the power supply remains disconnected for a longer time, an acoustic signal can be

switched on (depending on the model).

IF THE POWER SUPPLY IS DISCONNECTED

The refrigerator compartment is suitable for storage of fresh food and beverages.

The refrigerator is defrosted automatically.

Water drips on the rear wall indicate that refrigerator is being automatically defrosted on a periodic basis. The

thawed water is automatically conveyed to the drain outlet and then to the container for further vaporization.

Depending on the model, the appliance may be fitted with a special compartment (the meat and fish

compartment or the Zero Degree compartment) that is perfectly suitable for storage of fresh meat and fish.

Important: it is not allowed to wash refrigerator accessories in a dishwasher!

Note: ambient temperature, frequent door opening, and appliance deployment

can impact the temperature inside both compartments. Set the temperature considering

these factors.

Note: if the level of humidity inside the refrigerator is high and water drips are seen on the glass shelves, this

can lead to the formation of water condensate. In such case, it is advisable to close all dishes that contain

liquids (for example, a bowl with soup), wrap all food with a high level of liquid (for example, vegetables) in a

food film, and set higher temperature.

Removing the Vegetable Compartment (Depending on the Model)

If the appliance is fitted only with the vegetable compartment, then for easier removal of the vegetable

compartment empty (and remove if necessary) both lower shelves in the refrigerator door prior to taking off the

vegetable compartment.

Fan and Antibacterial/Odour Eliminating Filter (Depending on the Model)

The fan ensures even air circulation in the compartment, thus, favourably impacting storage of food, and

decreases the humidity. Do not block air inflow into the fan. The fan can be activated/deactivated manually (see

the Quick Guide). After activation, the fan works automatically when necessary.

REFRIGERATOR COMPARTMENT

Freezer compartment is suitable for storage of frozen food (during time period marked on the packing)

and for freezing of fresh food. The quantity of fresh food that can be frozen within 24 hours is indicated on

the data plate. Insert the food into the freezer compartment (see the Quick Guide) ensuring around packages

enough space for air circulation. It is not advisable to refreeze partially thawed food. It is essential to pack the

food in a way that prevents water, humidity and condensate from penetrating into the food.

To save energy and prolong the service life of the appliance, never place hot food in this compartment.

Note: ambient temperature, frequent door opening, and appliance deployment can impact the temperature

inside both compartments. Set the temperature considering these factors.

Making Ice Cubes

Fill 2/3 of the ice cube mould (if provided) and insert it into the freezer. Do not use sharp object to remove the

ice cubes.

Removing Drawers (Depending on the Model)

Pull the drawers out entirely, slightly lift them, and remove. To obtain more

space, the freezer compartment can be also used in the following way:

A) If the bottom of the freezer compartment is like figure A, take out the

upper drawers and/or covers. Leave the lower drawer in its place. Ensure

whether the doors can be properly closed when the food is placed on the

grates/shelves.

B) If the bottom of the freezer compartment matches the one in figure B,

take out all drawers or covers. Ensure whether the doors can be properly

closed when the food is placed on the grates/shelves.

Removing Cover (if Provided)

Open the cover and remove the pin, as seen in figure C.

For No Frost models, defrost is not necessary.

For other models, if ice is accumulating in the freezer compartment, it is

advisable to defrost the freezer compartment twice a year or when too much

ice has been accumulated (3 mm thick layer).

Ice accumulation is a usual phenomenon.

The quantity of accumulated ice and the speed of ice accumulation depends

on the temperature and humidity of environment and the frequency of door

opening. To defrost, disconnect the appliance from the mains and remove

all food. Leave the doors open – ice will thaw quicker. For models where the

freezer compartment is located beneath the refrigerator compartment, you can

take out water drain tube (see the Figure) and place beneath it a container for

collecting water.

After defrost, insert back the drain tube and check that no water remains in it.

Clean the freezer and dry it completely.

Turn on the appliance and place back the foodstuff.

DEFROST OF FREEZER COMPARTMENT

(Depending on the Model)

FREEZER COMPARTMENT

The meat and fish compartment is especially designed to keep the freshness

and nutritional value of the products longer.

Do not store fruits and vegetables in this compartment – the temperature

might drop below 0°C and the water in the foodstuffs might freeze.

Adjusting Temperature

In meat and fish compartment, the temperature is indicated by the arrow

position on the compartment handle, and it depends on the overall

temperature in the refrigerator compartment.

The recommended refrigerator compartment temperature is +2° to +6°.

Adjust correct temperature in the meat and fish compartment according to the figures below:

Important: If this function is activated and food with high level of water content is kept, condensation can form

on the shelves. In such case, disable the function temporarily.

Removing Meat and Fish Compartment

To ensure correct operation of the appliance, proper product storage and

optimal energy consumption, it is recommended not to remove

the meat and fish compartment if the symbol

is not visible in the

control panel (see the Quick Guide). In other cases, e.g., if you want to

make additional space in the refrigerator, you can remove the meat and fish

compartment.

Do the following:

1. Remove the compartment drawer (Fig. 1).

2. Remove the drawer cover by loosening the bottom clamps (Fig. 2).

When placing back the compartment, make sure to put on the cover before

inserting the drawer and using the refrigerator.

3. In the control panel, press and hold Meat and Fish Compartment

Function button for 3 seconds until the yellow indicator disappears.

For optimal energy consumption, we recommend to deactivate the meat and

fish compartment and remove the containing products (except for the shelf

above fruit and vegetable drawers).

MEAT AND FISH COMPARTMENT

(depending on the model)

If the arrow is on the left, you need to increase

temperature in refrigerator compartment.

If the arrow is in the middle, optimal temperature

is gained.

If the arrow is on the right, you need to decrease

temperature in refrigerator compartment.

Fig. 1

Fig. 2

Zero Degree compartment is especially designed for maintaining

low temperature and appropriate level of moisture to keep products

(e.g., meat, fish, fruits and winter vegetables) fresh longer.

Activating and Deactivating the Compartment

When the compartment is activated, its internal temperature is about 0°.

To activate the compartment, press and hold

the button shown in the image for more than

1 second until the symbol lights up.

When lit up, the symbol indicates that the

compartment is in operation. To deactivate the

compartment, press and hold the button again

for more than 1 second.

For correct operation of the Zero Degree compartment, follow these conditions:

- Refrigerator compartment must be turned on.

- Refrigerator compartment temperature should be +2°C to +6°C.

- The compartment must be in place to make activation possible.

- No special functions are selected, e.g. Standby, Cooling Off or Vacation mode, that deactivate the appliance or

refrigerator compartment.

If any of these functions are selected, Zero Degree compartment should be deactivated manually, and all

containing food products should be removed.

Note:

- If the symbol is not lit up when the compartment is activated, make sure that the compartment is inserted

correctly. If the problem persists, contact your nearest authorized After-Sale Service.

- If the compartment is activated and the drawer is open, the symbol in control panel can be deactivated

automatically. When the drawer is in place, the symbol is active again.

- When the compartment is activated, you might hear a small noise. This is normal, and you should not worry.

- When the compartment is activated, its internal temperature depends on the overall temperature in the

refrigerator compartment. In such conditions, we recommend to use it for storing fruits and vegetables resistant

to low temperatures (wild fruits, apples, apricots, carrots, spinach, lettuce etc.).

Important! If this function is activated and products with high level of water content are kept, condensation can

form on the shelves.

In such case, disable the function temporarily. When placing small containers or food products on the top shelf

of the Zero Degree compartment, make sure that these accidentally don't fall between the drawer and the back

of refrigerator compartment.

ZERO DEGREE COMPARTMENT

(depending on the model)

Before contacting the service centre:

Turn on the appliance again to check if the error is

fixed. If not, disconnect the appliance from the power

supply and wait for about an hour before switching it

on again.

If you find any fault after performing the checks

indicated in the manual and the appliance still does

not work properly after turning it on repeatedly,

contact the service centre, clearly describe the

problem and mention:

• Thenatureofthefault

• Themodel

• Thetypeandserialnumberoftheappliance(on

the rating plate)

• Theservicenumber(thenumberaftertheword

SERVICE on the rating plate inside the appliance)

Note:

It is possible to change the direction of

refrigerator door. If this procedure is performed

in the service centre, it is not covered by the

warranty.

SERVICE CENTRE

Removing the Zero Degree Compartment

To make more space in the refrigerator, you can remove the Zero Degree compartment. Do the following:

- For your convenience, we suggest to empty (and remove, if necessary) both lower door trays.

- Turn off the compartment.

- Pull out the drawer and the white plastic shelf under the compartment.

Note: The top shelf and the side fastenings cannot be removed.

To turn on the Zero Degree compartment again, first put back the white plastic shelf placed under the

compartment and then insert the drawer and activate the function.To ensure balanced energy consumption, we

recommend to deactivate the Zero Degree compartment and remove it.

Clean the compartment and its parts on a regular basis using a cloth and a solution of warm water and a neutral

detergent intended for cleaning the inside of a refrigerator (do not soak in water the white plastic shelf placed

under the compartment).

Before cleaning the compartment (and its outside), remove the drawer to disconnect the compartment

from power supply.

Do not use abrasive detergents.

Polar ART 463/A++ Owner's manual

Brand: Polar

Model: ART 463/A++

Category: Fridge-freezers

Type: Owner's manual

Download PDF

report

Polar ART 463/A++ Owner's manual

Polar ART 463/A++ Owner's manual

Related papers

Other documents