2. Computers & electronics
  3. Computer components
  4. System components
  5. Motherboards
  6. NEC
  7. PowerMate ES SlimLine Series

NEC PowerMate ES SlimLine Series User manual

  • Hello! I am an AI chatbot trained to assist you with the NEC PowerMate ES SlimLine Series User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Memory Upgrade
■
Maximum memory supported: 512 MB;
minimum memory required: 32 MB.
■
Memory type and size can vary between sockets.
■
System supports 168-pin, 100-MHz non-ECC SDRAM modules
in 32-MB, 64-MB, 128-MB, and 256-MB configurations.
Use NEC memory upgrade kits for the best compatibility with your
system. For memory compatibility information, call Technical Support.
■
Single- or double-sided DIMMS are supported.
■
No jumper setting required.
409-00065-000
PowerMate
®
ES SlimLine Series System Board Configuration
Note: See your
PowerMate ES SlimLine Series User’s
Guide
for detailed option installation information.
Website: www.nec-computers.com
Technical Support: 800-632-4525
Secondary
IDE Connector
Processor Socket
(Socket 370)
System
Memory
Upgrade
Sockets
Primary
IDE Connector
J4
Jumper
JP4
Jumper
JBAT1
Jumper
Processor Upgrade
See your user’s guide for detailed processor upgrade information.
JP3
Jumper
JKBV1
Jumper
Jumper Settings
J23
Jumper
BIOS Factory setting. Sets the system for
Recovery normal operation. The BIOS uses current
configuration information and passwords
at power on.
To enable BIOS recovery for a corrupted
system, remove the jumper. Wait 10 seconds.
Replace the jumper on pins 1 and 2.
Restores Safe BIOS settings as the
default BIOS settings and loads the
BIOS Setup at power on.
123
J4
123
J4
CPU Factory setting.
Type Uses an Intel
®
CPU.
3
2
1
J23
Uses a Cyrix
®
CPU.
3
2
1
J23
CMOS Factory setting. Maintains system board
Clear configuration in CMOS RAM
with onboard battery.
Clears CMOS while system power is off.
Return jumper to pins 1 and 2 before
powering system on.
Caution: To prevent damage to the system board,
avoid clearing CMOS while power is on.
3
2
1
JBAT1
3
2
1
JBAT1
Keyboard Factory setting. Wakes up the system from
Wakeup Suspend to RAM mode via the keyboard.
Requires Windows 98 running in Advanced
Configuration Power Interface (ACPI) mode.
Normal operation.
Disables Keyboard Wakeup.
321
JKBV1
321
JKBV1
Onboard Factory setting. Enables onboard audio.
Audio
Disables onboard audio. Use this
setting if you install a sound card.
123
JP3
123
JP3
Save to Factory setting. Enables the
RAM Save to RAM function.
Disables the Save to RAM function.
JP4
JP4
409-00065-000 4/19/00 3:01 PM Page 1
/