2. Stonco / Keene
  3. LytePro 7 LED Wall Sconce Gen3

Stonco / Keene LytePro 7 LED Wall Sconce Gen3 Install Instructions

  • Hello! I'm your chat assistant. I've reviewed the Installation Instructions for the LytePro Wall LPW7 Wall Mount. This document outlines the mounting process, wiring connections, and safety precautions needed for installation. It also covers features such as the internal splicing approval, integrated bubble level and the ability to install it with or without junction box. I'm ready to answer your questions about this device and its installation!
  • Can the fixture be mounted directly to a surface without a junction box?
    Is this fixture suitable for internal splicing?
    What voltage range is suitable for this fixture?
    What should be done to ensure the plate is level?
Wall Mount
LytePro Wall
LPW7 Small Wall Mount
LytePro Wall LPW7
Installaon Instrucons
PN 442100079700 Rev B
Install mounting plate to wall
or junction box using hardware
supplied by others.
Use integrated bubble level to
ensure plate is level.
Connect black wire to the
120v-277v supply lead.
Connect white wire to the supply
common lead. Connect supply
ground lead.
Hook fixture onto mounting plate
& ensure wires are not being
pinched between housing &
mounting plate. Secure with
supplied screw.
Remove appropriate knockouts in
mounting plate and gasket.
Install adhesive gasket to back of
mounting plate.
Fixture can be mounted to 3-1/2”
recessed and surface junction
boxes, or directly to a surface
without the use of a junction box.
This fixture is approved for
internal splicing.
Place a bead of caulk on the
top and side edge of fixture
between the housing and
wall.
1/25/2019 page 1 www.stonco.com & www.keene.com
LPW7 Installaon Instrucons ‐ Cover Plate Accessory
© 2019 Signify Holding. All rights reserved. This document may be subject to change.
No representaon or warranty as to the accuracy or completeness of the informaon
included herein is given and any liability for any acon in reliance thereon is disclaimed.
All trademarks are owned by Signify Holding or their respecve owners.
1/25/2019 page 2 www.stonco.com & www.keene.com PN 442100079700 Rev B
NOTICE: DO NOT MOUNT LYTEPRO SOLELY TO THIS COVER PLATE. IT IS
NOT INTENDED TO SUPPORT THE WEIGHT OF THE LUMINAIRE.
/