Page is loading ...
LED Group
Western Retail Park
Nangor Road
Dublin 12
Ireland
Tel: +353 1 7099000
Fax: +353 1 7099060
Email: [email protected]
Website: www.led.ie
1 2
3 4
15mm
22mm
25mm
2m
1. Ensure mains supply is switched off before commencing work
2. Choose desired location to mount the extrusion, ensure that the cables are long enough to reach the start of the strip.
Note: Not suitable for vertical mounting
3. Remove diffuser. Place LED strip inside the aluminium channel and remove self-adhesive film, press the strip into the channel,
ensure it is secure. Attach diffuser and end cap, ensure they are correctly attached
4. Mark appropriate fixing points for the brackets on the surface, ensure that the hole does not impinge on joists, pipe work, cables or
other building services
5. Attach the brackets to the surface using screws provided
6. Attach the unit to the brackets
RECESSED ALUMINIUM EXTRUSION, 15MM DEEP, 2M
REXR152-23
Issue 1 010916
The Installation must be carried out by an electrician
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
! Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or
use of this product, consult a competent electrician
Note:
Product technical information and specification may change over time without prior notification. For the latest technical
information please visit our web site www.ledgrouprobus.com or robusdirect.com, ledgrouprobus.com.au
Instruction manual
LED Group ROBUS Australia
9/210 Queensport Road North Tel: +61 73893 1488
Murarrie Fax: +61 73112 1927
QLD 4172 Email: [email protected]
Australia Website: www.ledgrouprobus.com.au
Weight: 0.46Kg
/
