2. MODWAY
  3. EEI-6533-SBR

MODWAY EEI-6533-SBR Assembly Instructions

  • Hello! I have reviewed the assembly instructions for the modway EEI-6533 lamp. This document provides a detailed guide for assembling the lamp, including how to attach the mounting plate, connect wires, and secure the lamp in place. The instructions also cover important aspects such as grounding and light bulb compatibility. I'm ready to answer any questions you have about assembling your new lamp.
  • What type of light bulb is compatible with this lamp?
    What tools are needed for assembly?
    What should I do if there is no ground wire?
    How do i connect wires?
EEI-6533
V1.07.17.23
Wait!
PAGE 2 0F 5
x2Long Screw
x1Mounting Plate
A
B
Assemble your item on a flat, carpeted
area, with plenty of space to work. This will
prevent damage and scratches to your
floors or the item while you're assembling
the product.
+ Ladder
x1Short Green Screw
x3Wire Cap
C
D
x4Side Screw
E
+ Electrical Tape
+ Wire Stripper or Cutters
+ Power Drill
+ One (1) G9 (Light Bulb (MAX. 25W)
PAGE 3 0F 5
Attach the Mounting Plate (A) to the junction
box in the wall and affix it with 2 Long Screws
(B).
Mounting Plate
Ax1
Long Screw
Bx2
PAGE 4 0F 5
Step 3
Wire Cap
Cx3
Connect wires with matching polarity. The black
fixture wire connects to the black supply wire
(live wire) and the white fixture wire to the white
supply wire (neutral wire). Secure each
connection using a Wire Cap (C).
Connect the copper fixture wire to the ground
wire and secure the connection with a Wire Cap
(C). If there is not a supply ground wire, attach
the copper fixture wire to the Short Green
Screw (D) to ground.
L
N
Short Green Screw
Dx1
Step 4
Your lamp is complete and ready to enjoy.
Indoor use only.
PAGE 5 0F 5
Step 5
Step 5.1 Attach the wall base to the
Mounting Plate (A), secure it with 4 Side
Screw (E).
Step 5.2 Install the light bulbs according to
the wattage label (G9, MAX. 25W, bulb not
included).
Attached the glass shade to lamp holder.
ATTENTION: To avoid the risk of fire, do not exceed the
recommended wattage indicated on the wattage label.
E
Side Screw
Ex4
Step 5.1
Step 5.2
/