Lanco LO657-5 User manual

Lanco
Brand
Lanco
Model
LO657-5
Type
User manual

Lanco LO657-5 is an effective natural wood preservative and finish that forms a protective moisture repellent film on unfinished wood in exterior or interior applications. It is commonly used on exposed surfaces such as exterior wood siding, gutters, and fence railings.

Here are some key features of Lanco LO657-5:

  • Penetrates deeply into the wood to provide long-lasting protection
  • 100% pure virgin linseed oil formula for high performance and durability
  • Enhances the natural beauty of wood without the need for paint or varnish
  • Suitable for use on both new and existing unfinished wood surfaces

Lanco LO657-5 is an effective natural wood preservative and finish that forms a protective moisture repellent film on unfinished wood in exterior or interior applications. It is commonly used on exposed surfaces such as exterior wood siding, gutters, and fence railings.

Here are some key features of Lanco LO657-5:

  • Penetrates deeply into the wood to provide long-lasting protection
  • 100% pure virgin linseed oil formula for high performance and durability
  • Enhances the natural beauty of wood without the need for paint or varnish
  • Suitable for use on both new and existing unfinished wood surfaces
Natural Oil Wood Preservative
Linseed Oil
™
LO-657
MPI: N/A
Green Performance1: N/A
Green Performance 2: N/A
VOC Compliant (<400g/L): N/A
Meets Requirements for:
TECHNICAL DATA SHEET
Product Type: Natural Oil Resins
Finish: Satin
*Geometry 60º
Solids (%): 100 ± 2% by weight
100 ± 2% by volume
Weight/Gallon: 7.72 ± 0.05 lbs.
( 3.5 ± 0.02 kg.)
Sizes: 1 gallon
1 quart
Thinning: Do not thin
Flash Point: 210
0
F TOC
Viscosity: 68 - 78 KU's
VOC: <500g/L
Technical Data:
www.lancopaints.com continued on back
Surface Preparation:
All surfaces must be dry, clean, sound and free
of contaminants. Remove all dirt, grease,
mildew, oil, dust, and other soluble
contaminants. Remove all loose detrimental
foreign matter by scraping, sanding or power
sanding.
Method of Application:
New wood: Sand down to a smooth finish with
fine sandpaper following the grain.
Mixing: This is a one component product.
Always hand mix thoroughly with a paddle
before application.
Apply by air pressure pump, brush, roller or
airless spray. Roller application may require
special care to prevent bubbling and more than
one application to assure proper penetration to
the wood.
Extinguishing media: Water, carbon dioxide or
foam.
Hazardous decomposition products: Under
severe thermal degradation, carbon monoxide
and low molecular weight organic compounds
may be formed.
Special reghting procedures: None known.
However, fire fighters should wear
self-contained breathing apparatus to prevent
inhalation of smoke or vapors.
Unusual re & explosion hazard: This product
will oxidize and can cause spontaneous
heating. Avoid spontaneous combustion of
contaminated rags or other ignitable absorbent
material by immersing in water immediately.
Uses:
Linseed Oil
TM
is especially formulated to protect
and preserve the natural beauty on virgin
woods, new or existing without paint or
varnish on interior or exterior surfaces. Is best
suited for exposed surfaces such as exterior
wood siding, gutters, and fence railings.
Notice: The technical data contained herein are
true and accurate to the best of our knowledge.
Published technical data and instructions are
subject to change without prior notice.
S.D.S.: Available upon request.
Description:
Linseed Oil
TM
is a natural wood preservative
and finish that forms a moisture repellent film,
which delays splitting on unfinished wood in
exterior or interior applications.
Product Advantages:
• Penetrates the wood
• 100% virgin linseed oil
• High performance
• Pure natural wood preservative
• For new or existing unfinished woods
Permissible exposition level: Does not apply.
Threshold limited value: Does not apply.
First Aid:
If on skin: Wash affected areas with water and soap.
If in eyes: Flush with large amounts of water, lifting upper and lower lids
occasionally and get medical attention.
If swallowed: Do not induce vomiting. Get medical attention immediately.
If inhaled: If affected, remove individual to fresh air.
• NORTH AMERICA • 600 Mid Florida Drive Airport Industrial Park of Orlando, Florida 32824 • Tel. (407) 240-4000 Fax (407) 240-4046
• CARIBBEAN & SOUTH AMERICA • Urb. Aponte #5, San Lorenzo, Puerto Rico USA 00754 • Tel. (787) 736-4221 Fax (787) 736-5313
• CENTRAL AMERICA • Zona Industrial Bes, lote #4, El Coyol de Alajuela, Costa Rica • Tel. (506) 2438-2257 Fax (506) 2438-2162
Page 2 Linseed Oil LO-657 Rev. 06 / 2016
Warning Information:
Dangerous information about health:
Uses:
Linseed Oil
TM
is especially formulated to protect
and preserve the natural beauty on virgin
woods, new or existing without paint or
varnish on interior or exterior surfaces. Is best
suited for exposed surfaces such as exterior
wood siding, gutters, and fence railings.
Notice: The technical data contained herein are
true and accurate to the best of our knowledge.
Published technical data and instructions are
subject to change without prior notice.
S.D.S.: Available upon request.
  • Page 1 1
  • Page 2 2

Lanco LO657-5 User manual

Lanco
Brand
Lanco
Model
LO657-5
Type
User manual

Lanco LO657-5 is an effective natural wood preservative and finish that forms a protective moisture repellent film on unfinished wood in exterior or interior applications. It is commonly used on exposed surfaces such as exterior wood siding, gutters, and fence railings.

Here are some key features of Lanco LO657-5:

  • Penetrates deeply into the wood to provide long-lasting protection
  • 100% pure virgin linseed oil formula for high performance and durability
  • Enhances the natural beauty of wood without the need for paint or varnish
  • Suitable for use on both new and existing unfinished wood surfaces
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents