Samsung RF261BEAESR Installation guide

RF261BEAESR
Samsung
Brand
Samsung
Model
RF261BEAESR
Type
Installation guide

This manual is also suitable for

After completing each step, check the box
If you have further questions or damaged accessory parts, contact us at 1-800-SAMSUNG (726-7864)
1. Check the entrance
for the Refrigerator.
Check Check
2. If Entrance is less than 36” wide, remove the Doors.
Reassemble in reverse order. Be sure to reattach and tighten all bolts.
3. Water Installation
Make sure water
does not leak.
Check
4. Connect
Power
Check
See grounding information attached
to power cord.
5. Level unit
Check
Lower support legs to touch the
floor. If unit be moved, raise the
support legs before moving the
unit.
6. Door Alignment
Make sure doors are properly aligned
Check
Check
Energy Saver + Freezer button (For RF263 Model)
Power Freeze + Freezer button (For RF261B / RF260B Model)
(On some models)
DA68-02600A Rev.04
ENGLISH
8. Set Temperatures
Check
Recommended setting
∙ Freezer : 0ºF (-18ºC)
∙ Fridge : 37ºF (3ºC)
36”
< Width >
69”70”
< Height >
FridgeFreezer
B
Take out the lower basket ( 1 )
by lifting the basket up from the
rail system.
Household water line
Compression Nut
(1/4”) (Purchased)
Compression
Fitting
(Assembled)
Plastic Tubing
(Assembled)
Bulb
Compression Nut
(1/4”) (Assembled)
(
Not supplied)
(
Not supplied)
Copper tubing or Plastic tubing
Refrigerator
Ferrule
(Purchased)
A
Take out the upper drawer by
lifting it up.
C
Press the fixing hook of rail
system.
D
After holding and pulling out the
top of Freezer Door, remove it at
the rail system.
Check
Refer to User Manual for more information.
1
Flat-blade screw
driver(-)
Control Lever
PUSH
A B E
Disconnect two connector (2) on the
left side door. To remove the water
coupler from the hinge, twist and pull
it from the hinge. Remove the water
line (3) while pressing the marked part
(4) of the water line coupler.
(External dispenser only )
Remove 3 screws holding
dowm the TOP TABLE (1)
and turn it with wires
connected.
Pull and remove the hinge lever
(6) attached to the upper left door
hinges with a philips screwdriver
(+). Remove the upper left and
right door hinges (7).
Remove the screw ( 8 ) attached to
the lower left and right door hinges
with a philips screwdriver (+).
Remove the 2 hex head bolts ( 9 )
attached to the lower left and right
door hinges with an allen wrench
(3/16”). Remove the lower left and
right door hinges ( 10 ).
2
3
4
Red Clip
(1/4")
Reattaching the Water Supply Line
- The Water Line must be fully
Inserted to the center of
transparent coupler to prevent
water leakage from the dispenser.
C
5
6
7
Lift the door straight up
to remove.
D
Allen wrench
10
8
9
1
*
*
*
*
Refer to User Manual for more information.
∙
Pull out the freezer drawer ,then you
can see the lower hinge .
∙
∙ Adjust the height by turning a philips
screwdriver (+) clockwise ( ) or
counterclockwise ( ).
1
2
3
4
Insert a philips screwdriver (+) into
the shaft of the lower hinge.
DOWN
UP
3
When you turn a philips screwdriver (+)
counterclockwise ( ), the door will
move up.
UP
1
2
3
4
3
(5). Remove the ground screw
If Display shows “OF OF”, Press below button for 5 seconds to cancel
Cooling Off
7. Make sure the fridge is not in Cooling Off
9. Dispense water for
at
least 1 gallons of
water to remove
trapped air from the
water line.
Page is loading ...
  • Page 1 1
  • Page 2 2

Samsung RF261BEAESR Installation guide

RF261BEAESR
Samsung
Brand
Samsung
Model
RF261BEAESR
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers