Binks Pump Mounting Hardware & Accessories User manual

Brand
Binks
Model
Pump Mounting Hardware & Accessories
Type
User manual
Binks HOSE SIPHON KITS
for Pumps
ITEM PART
NO. NO. DESCRIPTION QTY.
1 20-11 ELBOW,
3/4" NPT x 90º street ................. 1
2 41-2517 PIPE NIPPLE,
Aluminum 16" long ........... 1
3 41-2662 STRAINER,
30 mesh ............................. 1
4 41-11211 HOSE ASSEMBLY,
5 ft. long ................ 1
5 83-1822 NIPPLE ............................................... 1
Replaces
Part Sheet
77-2098R-7
Part
Sheet
77-2098R-8
41-2294 3/4" HOSE SIPHON KIT – 5 & 10 GALLON (SOLVENT BORNE)
3/4" NPT
ITEM PART
NO. NO. DESCRIPTION QTY.
1 20-100 ELBOW,
1" NPT x 90º street .................... 1
2 41-2519 PIPE NIPPLE,
Aluminum 16" long ........... 1
3 41-2663 STRAINER,
30 mesh ............................. 1
4 41-11212 HOSE ASSEMBLY,
5 ft. long ................ 1
5 72-423 NIPPLE ............................................... 1
41-2296 1" HOSE SIPHON KIT – 5 & 10 GALLON (SOLVENT BORNE)
ITEM PART
NO. NO. DESCRIPTION QTY.
1 20-11 ELBOW,
3/4" NPT x 90º street ................. 1
2 41-2617 PIPE NIPPLE,
Aluminum 33" long ........... 1
3 41-2662 STRAINER,
30 mesh ............................. 1
4 41-11216 HOSE ASSEMBLY,
8 ft. long ................ 1
5 83-1822 NIPPLE ............................................... 2
6 20-5 ELBOW,
3/4" NPT x 90º ........................ 1
41-2616 3/4" HOSE SIPHON KIT – 55 GALLON (SOLVENT BORNE)
1" NPT
3/4" NPT
1" NPT
3/4" NPT
3/4" NPT
ITEM PART
NO. NO. DESCRIPTION QTY.
1 20-100 ELBOW,
1" NPT x 90º street ................... 1
2 41-2702 SIPHON TUBE,
1" NPT x 35" long Galv. ... 1
3 41-2663 STRAINER,
30 mesh ............................. 1
4 41-11210 HOSE ASSEMBLY,
8 ft. long ................ 1
5 72-423 DM NIPPLE,
1" NPT x 2-1/16" long .......... 2
6 20-1257 ELBOW,
1" NPT x 90º .......................... 1
41-10467 1" HOSE SIPHON KIT – 55 GALLON (SOLVENT BORNE)
1" NPT
1" NPT
2
Warning
!
In this part sheet, the words WARNING, CAUTION and NOTE are used to emphasize important safety information as follows:
CAUTION
Hazards or unsafe practices which could
result in minor personal injury, product
or property damage.
!
WARNING
Hazards or unsafe practices which could
result in severe personal injury, death or
substantial property damage.
!
NOTE
Important installation, operation or
maintenance information.
Read the following warnings before using this equipment.
READ THE MANUAL
Before operating finishing equipment, read and
understand all safety, operation and maintenance
information provided in the operation manual.
ELECTRIC SHOCK/GROUNDING
Improper grounding or sparks can cause a
hazardous condition and result in fire, explosion
or electric shock and other serious injury.
PROJECTILE HAZARD
You may be injured by venting liquids or gases
that are released under pressure, or flying debris.
INSPECT THE EQUIPMENT DAILY
Inspect the equipment for worn or broken parts
on a daily basis. Do not operate the equipment
if you are uncertain about its condition.
NEVER MODIFY THE EQUIPMENT
Do not modify the equipment unless the
manufacturer provides written approval.
FIRE AND EXPLOSION HAZARD
Improper equipment grounding, poor ventilation,
open flame or sparks can cause hazardous
conditions and result in fire or explosion and
serious injury.
KNOW WHERE AND HOW TO SHUT OFF THE
EQUIPMENT IN CASE OF AN EMERGENCY
STATIC CHARGE
Fluid may develop a static charge that must be
dissipated through proper grounding of the
equipment, objects to be sprayed and all other
electrically conductive objects in the dispensing
area. Improper grounding or sparks can cause a
hazardous condition and result in fire, explosion
or electric shock and other serious injury.
WEAR SAFETY GLASSES
Failure to wear safety glasses with side shields
could result in serious eye injury or blindness.
DE-ENERGIZE, DISCONNECT AND LOCK OUT ALL
POWER SOURCES DURING MAINTENANCE
Failure to De-energize, disconnect and lock out
all power supplies before performing equipment
maintenance could cause serious injury or death.
OPERATOR TRAINING
All personnel must be trained before operating
finishing equipment.
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equip ment to
rupture, malfunction, or start unexpectedly and
result in serious injury.
KEEP EQUIPMENT GUARDS IN PLACE
Do not operate the equipment if the safety
devices have been removed.
HIGH PRESSURE CONSIDERATION
High pressure can cause serious injury. Relieve all
pressure before servicing. Spray from the spray
gun, hose leaks, or ruptured components can
inject fluid into your body and cause extremely
serious injury.
PRESSURE RELIEF PROCEDURE
Always follow the pressure relief procedure in the
equipment instruction manual.
FOR FURTHER SAFETY INFORMATION REGARDING BINKS AND DEVILBISS EQUIPMENT,
SEE THE GENERAL EQUIPMENT SAFETY BOOKLET (77-5300).
IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PROVIDE THIS INFORMATION TO THE OPERATOR OF THE EQUIPMENT.
CA PROP
65
PROP 65 WARNING
WARNING: This product contains chemicals known
to the State of California to cause cancer and
birth defects or other reproductive harm.
3
ITEM PART
NO. NO. DESCRIPTION QTY.
1 20-1739 ELBOW,
1" NPT x 90º street (S.S.) ............ 1
2 44-156 SIPHON TUBE,
1" x 35" (S.S.) ............... 1
3 101-142 STRAINER,
1" inlet, 16 mesh ................. 1
4 44-1561 HOSE ASSEMBLY,
8 ft. ...................... 1
5 20-5737 D.M. NIPPLE,
1" NPT x 1" NPS (S.S.) ....... 2
6 20-3812 ELBOW,
1" NPT (F) x 1" NPT (F) x 90º ...... 1
44-155 1" HOSE SIPHON KIT – 55 GALLON (STAINLESS STEEL)
1" NPT
1" NPT
ITEM PART
NO. NO. DESCRIPTION QTY.
1 20-3590 ELBOW,
3/4" NPT x 90º street ................ 1
2 41-2777 SIPHON TUBE,
3/4" x 35" (S.S.) ............. 1
3 41-10094 STRAINER,
3/4" inlet, 16 mesh .............. 1
4 41-11213 HOSE ASSEMBLY,
8 ft. ...................... 1
5 72-1770 D.M. NIPPLE,
3/4" NPT x 3/4" NPS .......... 2
6 20-2118 ELBOW,
3/4" NPT x 90º ........................ 1
44-355 3/4" HOSE SIPHON KIT – 55 GALLON (STAINLESS STEEL)
3/4" NPT
3/4" NPT
ITEM PART
NO. NO. DESCRIPTION QTY.
1 20-3590 ELBOW,
3/4" NPT x 90º street ................ 1
2 44-349 SIPHON TUBE,
3/4" x 17" (S.S.) ............. 1
3 41-9854 STRAINER,
3/4" inlet, 8 mesh ................ 1
4 44-1605 HOSE ASSEMBLY,
5 ft. ...................... 1
5 72-1770 D.M. NIPPLE,
3/4" NPT x 3/4" NPS .......... 2
6 20-2118 ELBOW,
3/4" NPT x 90º ........................ 1
44-350 3/4" HOSE SIPHON KIT – 5 GALLON (STAINLESS STEEL)
3/4" NPT
3/4" NPT
ITEM PART
NO. NO. DESCRIPTION QTY.
1 20-3204-1 ELBOW,
1/2" Galv. ............................... 1
2 135-54 SIPHON TUBE,
Polypro 15-3/4" long ...... 1
3 41-2661 STRAINER,
30 mesh ............................. 1
4 71-3414 HOSE ASSEMBLY,
42" long ................ 1
5 72-1243 D.M. NIPPLE,
1/2" Brass, Nickel Plated ... 2
135-83 1/2" HOSE SIPHON KIT – 5 GALLON (POLYPROPYLENE TUBE)
1/2" NPT
1/2" NPT
NO LONGER AVAILABLE
3/13 ©2013 Binks All rights reserved. Printed in U.S.A.
Binks Sales and Service: www.binks.com
WARRANTY
This product is covered by Binks’ 1 Year Limited Warranty.
77-2098R-8 Revisions: Trademark updates;
(P2) Added Prop 65 warning; (P4) Updated
contact information.
U.S.A./Canada Customer Service
195 Internationale Blvd.
Glendale Heights, IL 60139
630-237-5000
Toll Free Customer Service
and Technical Support
800-992-4657
Toll Free Fax
888-246-5732
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Binks Pump Mounting Hardware & Accessories User manual

Brand
Binks
Model
Pump Mounting Hardware & Accessories
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents