244

PO

(244PO) 7.5” X 10.3” ENGLISH 04/06/2017

READ BEFORE YOU START!

NOTE: This quick start guide provides important and useful tips before you start

the setup of your spa. However, it does not address all aspects of spa installation

and use, and you are still required to read, understand, and follow the owner’s

manual for proper installation, maintenance, and safe use of your spa.

• Power:Thisproductrequiresaminimumof13AMPS.Mosthouseholdcircuitsare15to20AMPS.Ifthe

 =15hours.Forsubsequentusetheheatingtimecanbeshortenedbymaintaininganidletemperaturein

 thespa(seeHEATINGANDWATERTEMPERATUREsection).BesuretokeepthecoverontheSpawhen

 notinuse.

• GFCI/RCD:ThisproductisprovidedwithaGFCI/RCDlocatedattheendofthepowercord.The 

 GFCImustbetestedbeforeeachuse.DoNOTusetheSpaiftheGFCI/RCDdoesnotfunction 

 properly.(Seepage4forpropertestingofGFCI/RCDinstructions).

• FilterCartridge:Keepthespawaterproperlysanitizedtoextendthelifeofthecartridge.Refertothe 

 owner’smanualfordetailedinformationonspawaterchemistryandbalance.

UNFOLDING AND INFLATING YOUR SPA:

 • Whenyouunfoldtheinatablespatubyoumaynoticethesmellofthematerialthatisnormalfor

  familiarizeyourselfwithitscontent,anddisplayitintheproximityofthespawherealluserswillbeable

  toseeitandreadit.

 • Forspaination,familiarizeyourselfwiththespringloadedvalveonthespatubandtheination

  outletonthecontrolbaseunittoassurefastandproperination.

Ination Outlet Tips:

 • Thelargerendoftheinationhoseattachestotheairoutletatthebackofthecontrolbaseunit(see

  owner’smanualfordrawingsandfurtherdetails).

 • Toattachtheinationhosetotheairoutlet,unscrewthecapfromtheoutlet,insertthelargerendofthe

  hose(theendwiththelockingcollar)allthewayintotheairoutlet,andthenturnthecollarclockwiseto

  lockitinplace.

 • Uponremovingthevalvecap,notethespringloadedpininthecenterofthevalve.Forination,

  thespringloadedpinshouldbeintheup/raisedposition(closedpositionofthevalve)astheair

  pressureofthepumpwillpushtheairthroughthevalveduringination.Checkthevalvepinand

  assureitisintheup/raisedpositionbeforestartingination.

 • Thepincanbepresseddownandlockedintherecessedpositionbypressingandturningit90°

  clockwisewithyournger–thisistheopenpositionofthevalvethatallowstheairtoowout

  freelyandthatisusedfordeation.

SAVE THESE INSTRUCTIONS

244

PO

(244PO) 7.5” X 10.3” ENGLISH 04/06/2017

  heat-uptime.However,makesurenottousewaterexceedingthenormalspaoperating

  temperatureswhicharenottoexceed104°F.Waterover104°Fwillturnofftheheatingunitandis

  notconsideredsafe.Alwayscheckthewatertemperatureinyourspabeforeuseandrefertothe

  owner’smanualfordetailedinformationonsafeuse.

 • Maintainingidlewatertemperature:YourPureSpaislikeanyhouseholdapplianceoraxedspa,

  andforcontinuoususeyoumaychoosetosetacertainidletemperaturetobemaintainedin

  thespawhennotinuse.Thiswillallowshorterheat-uptimeforwhenyoudecidetouseit.For

  example,maintainingthespawatertemperatureat85°Fwillallowreaching100°Finapproximately

  8hours.Remember,thewatertemperatureincreaseisapproximately2°Fperhourofheating(may

  varydependingonoutsidetemperatureandconditions),soplanyourspauseaccordingly.

  reachabletemperatureforthegivenconditions,whichwillnotrequirere-startingtheheatingunit

  after72hours.

 • Watertemperatureduringuse:Whenyouareusingthespa,thewatertemperaturewillnaturally

  decreaseslightlyovertime.Theexpectedtemperaturedecreasecanbeanywherebetween2°F

  and4°Fperhourdependingonexternalconditions.Aslongastheheatingunitisturnedonwitha

  settemperature,itwillstartheatingthewaterautomaticallywhenwatertemperaturedropsby2°F

  fromthesettemperature.

  Example:Ifyoursettemperatureis102°F,theheaterwillnotcomeonuntilthetemperaturedrops

  to100°F.Ifyoushouldwishtoheatitbackupsooner,youcansimplyre-settheheaterbyturningit

  offandbackontostartheatingtoyourpreferredtemperature.

  “unlocked”symbolsforeasyoperation:putthekeyintotheslotonthebuckleandturnittothe

  appropriatepositiontolockorunlockthebucklerespectively.

 • Toassuresafetyfromunauthorizedaccess,alwaysputthecoveronwhenspaisnotinuseand

  lockallbuckles.Alwayskeepthekeysoutofreachofchildren.

 • Incaseyoumisplacethekeys,youcanuseanysimilarsizeatscrewdrivertolockorunlockthe

  buckles.

SAVE THESE INSTRUCTIONS