Hagerco 5950 - Spring Cushion Installation guide

Hagerco
Brand
Hagerco
Model
5950 - Spring Cushion
Type
Installation guide

This manual is also suitable for

Non-Handed Spring Cushion Arm Kit
Installation Instructions
I-CL00236
THIS KIT CAN BE USED WITH THE FOLLOWING HAGER SPRING ARM PRODUCTS:
5125, 5906, 5907, and 5961
OVERVIEW
REV 1
Page 1 of 1
INSTALLATION INSTRUCTIONS
5125 and 5961 Arm Only
Determine hand of arm required and remove appropriate plug.
Position spring cushion assembly on soffit plate and, using the 5/32”
hex wrench provided, thread assembly to soffit plate.
Exiting 5906 and 5907 Arm Only
Remove stop from existing plate. Position spring cushion assembly
on soffit plate and thread assembly to soffit plate using the 5/32” hex
wrench provided.
Please note that where severe or abusive conditions are expected, a
separate door stop is recommended to assist in preventing damage to
the door closer and closer arm as well as the door, frame, and
adjacent walls.
Plug
Spring Cushion
Hex Wrench
Soffit Plate
Removable Stop
Spring Cushion
5907 arm shown
5961 arm shown (right hand)
5954 5961 + spring cushion
5955 5125 + spring cushion
5956 5906 + spring cushion
5957 5907 + spring cushion
  • Page 1 1

Hagerco 5950 - Spring Cushion Installation guide

Hagerco
Brand
Hagerco
Model
5950 - Spring Cushion
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents