SECOMP 12021107 USB 3.0 3 Port Hub Installation guide

Hello! I've reviewed the Quick Installation Guide for the 3-Port Hub with Gigabit Ethernet Adapter. This document covers the installation process for Windows and Mac operating systems, including driver installation and network connection. It also mentions that the hub may need a power adapter for high power devices. I am here to help you with any questions you might have about setting up this device. Feel free to ask.
Do I need to install a driver before using the Ethernet adapter?

What operating systems are supported?

How do I check if the installation is completed on Mac OS X?

Quick Installation Guide

USB 3.0 3-Port Hub with Gigabit Ethernet Adapter

Driver Installation

Caution: DO NOT connect the Ethernet adapter to your computer before you install

the provided driver. You will be instructed to do so later.

For Windows XP/ Windows Vista/ Windows 7/ Windows® 8

1. Insert the provided CD into your disc drive. Locate and double-click the

Setup.exe file in the Driver folder to launch the setup program.

2. Wait for the program to install the drivers.

3. Click Finish to complete the installation.

4. Connect the Ethernet adapter’s USB end to a free USB port of your computer. At

this stage, different situations may occur according to your operation system.

Mac OS X v10.6-10.8

1. Insert the provided CD and double-click AX88179.pkg file in the Driver folder

on Mac OS X v10.6 at least.

2. Click the Continue to install and it will restart your computer automatically.

3. Connect the Ethernet adapter to a free USB port.

4. You can Click System Report on the desktop to check if the installation is

completed.

5. Connect the Ethernet adapter to a free USB port. Then a New port Detected

screen will prompt, and you will find that a new Ethernet network interface is

available.

Connecting to Your Network

Now the installation is completed. You can connect the adapter to your network

device such as hub, switch or router by an Ethernet cable. The Link LED should

light up to indicate a proper physical connection between the adapter and the

network.

Notice: The hub bus power may not meet higher power need like 2.5” HDD. In this

case, we suggest that you use power adapter for the power need.

This Quick Installation Guide describes only the basic instructions on installation. For

more information, please refer to the User’s Manual on the provided CD-ROM.