2. CLEAR DESIGN
  3. THREE60 Conference Sleigh LEG

CLEAR DESIGN THREE60 Conference Sleigh LEG User manual

  • Hello! I've reviewed the user manual for the Clear Design THREE60 SLEIGH LEG Conference Table. This document covers the assembly process, including the installation of the sleigh legs, wire management grommet, and optional power modules. I'm ready to answer any questions you have about setting up your conference table or its components.
  • What is included in the parts list for the Sleigh Leg?
    Are the installation steps the same for both sitting and standing-height tables?
    What is the purpose of the optional covered sleigh leg?
    How do I install the optional power module?
Includes Optional Power and Wire Management Install
THREE60 CONFERENCE
SLEIGH LEG
TH–1
*General Guide | See Master Plan
THREE60 SLEIGH LEG
PARTS LIST
ITEM CODE QTY PRODUCT CODE
GCNAB 2Angled Sleigh Leg
CNS#### 1Main Surface
BASB72 1Surface Support Bar
CNWG 1In-Surface Grommet
Note: Install steps are the same for sitting and standing-height tables
SLEIGH LEG
SLEIGH LEG
THREE60
THREE60
Carefully place surface upside-down on floor, a cushioned area is
preferred.
Measure from surface edge to determine leg placement.
Follow measurements and insert 15 screws per leg through the
metal plate and into the laminate surface.
1 | PREPARE SURFACE
2 | INSTALL ANGLED SLEIGH LEGS
3 | FLIP AND INSERT GROMMET
Insert wire management grommet.
36" DEEP42" DEEP
12”
~2 ”
3
8
~2 ”
3
8
12”
~5 ”
3
8
~5 ”
3
8
1 2
THREE60 OPTIONAL POWER
PARTS LIST
ITEM CODE QTY PRODUCT CODE
BPCONF2V2
or BPCONF3 1In-Surface Power Module
JC1 5J-Clips
VB24 1Cable Vertebrae
SLEIGH LEG
THREE60
All steps for installation are the same, however leg will be aligned
with the grommet cutout on the table
Panel on leg will swing open to manage date and power cables.
OPTIONAL COVERED SLEIGH LEG
3 4
POWER
THREE60
OPTIONAL POWER MODULE INSTALL
Insert the plastic clamps into the holes on the bottom of the
module. Rotate and then push against the surface to clamp the
module into place.
OPTIONAL POWER MODULE INSTALL
Attach 2 metal clips to the back of the module base then insert into
the pre-cut holes in the surface.
1
2
3
POWER
THREE60
5 6
PARSONS
THREE60
Attach the vertebrae to the underside of the top panel. Insert
woodscrews through the top bracket and into the laminate panel.
OPTIONAL POWER VERTEBRAE
7
210.648.2095 | mycleardesign.com
© 2021 Clear Design. All rights reserved.
/