MODEL: PE4118GF MODEL: PE4118GF
Remove the four bolts on nose cover or 45º
flooring attachment with a hex wrench.
Use a flat screw driver to remove the jammed
fastener and push the drive blade back into place.
45° Flooring Attachment
Regular Nose Cover
To charge the battery, line up the slot of the
battery with the slot of the charger and slide into
place.
The battery indication light should turn from green
to red when the battery is charging.
When the indication light has turned green, the
battery should be fully charged.
After a tool has been used for a prolong amount of
time, the batteries in the battery pack will become
hot. This only occurs when the tool has been used
continuously for a extended period of time. When
the battery becomes hot, let it cool for 30 minutes
before recharging. Refer to the CHARGING
BATTERY section for normal charging of batteries.
If the charger does not charge your battery under
normal circumstances, contact the authorized
dealer.
These batteries will wear out over time, like all
batteries. If this happens, do not disassemble the
battery and attempt to fix it. This could cause
serious burns especially when wearing rings and
jewelry. To have the longest possible battery life, we
suggest the following.
Once a battery pack has been fully charged,
remove it from the charger.
The battery should be stored in a temperature
that is below 80°F and away from moisture.
Batteries should be stored with a 30%-50%
charge.
If a battery has been stored for six months or
more, charge the battery as normal.
Problems with driving nails or cycling of nails while
firing may be due to glue residue from the nail strips.
If this is the case, clean the area around the driving
mechanism.
45° Flooring Attachment
Regular Nose Cover
Four Bolts