Heat & Glo WH-STAT Wall Thermostat Kit, WH-STAT Installation and Operation Instructions

I've read the Installation and Operation Instructions for the WH-STAT Wall Thermostat Kit. This document covers the unpacking process, electrical wiring, and operational procedures. I'm ready to answer your questions about this device and its installation.
What should I do if parts are missing or damaged?

What kind of wire should be used for the thermostat?

Where can I find the pigtail wires in the fireplace?

Hearth & Home Technologies Inc.

20802 Kensington Boulevard, Lakeville, MN 55044 146-900C 5/05

WH-STAT WALL THERMOSTAT KIT

- Installation and Operation Instructions -

Figure 1

CHECK CONTENTS OF SHIPPING CARTON

Compare contents of carton in Figure 1 with the actual

parts received. If any parts are missing or damaged, con-

tact your dealer before beginning installation. DO NOT in-

stall a damaged Wall Thermostat Kit.

Thermostat

Wire

Male

Connector

Female

Connector

REPLACEMENT PARTS AND

CUSTOMER SERVICE

Replacement parts and customer service may be obtained

through your dealer.

INSTALLING ELECTRICAL WIRING FROM

WALL THERMOSTAT TO FIREPLACE:

1. Run low voltage 2- conductor wire from the wall ther-

mostat into the base of the fireplace (behind grille). Find

the male and female connectors provided and attach

them to the ends of this wire.

2. Find the red and brown pigtail wires labeled "THER-

MOSTAT", "REMOTE", or "WALL SWITCH", located

in the base pan of the fireplace.

OPERATING PROCEDURES

1. Follow the lighting instructions section in the fireplace

instruction manual. Be certain that the pilot light is on

and the gas control valve is in the "ON" position.

2. Set the wall thermostat to the desired setting.

NOTE:For installing and selecting the proper thermo-

stat location, refer to instruction manual provided in

this kit.

WARNING

Shock Hazard.

Explosion Risk.

Do NOT wire 110V-120V to valve.

Do NOT wire 110V-120V to wall switch.