ROOMS TO GO 18118249 Assembly Instructions

  • I have reviewed the assembly instructions for the Dexter Accent Chair. This document guides you through the process of assembling the chair, including attaching the legs and adding the back cushion. I can answer questions about the steps, included parts, and safety precautions mentioned in the document.
  • How many adults are recommended for assembly?
    What should I do with the content of the box before assembly?
    What is included in the hardware list?
    What is the first step of assembly ?
    What to do with the plastic caps on the screws heads?
Page 1of 1
ASSEMBLY INSTRUCTIONS
Description: Dexter Accent Chair
Important safety instructions:
Please read carefully all instructions before assembly.
For your safety and ease, assembly by two or more adults is recommended.
Keep instructions for future use.
Pre-assembly:
Do not discard any content until assembly is complete to avoid accidentally discarding small parts or hardware.
Take out all parts and hardware from box.
Parts List
Item
Description
QTY
P1
Front Legs
2
P2
Back Legs
2
P3
Back Cushion
1
P4
Chair
1
Hardware List
Item
Description
QTY
H1
Plastic washer
4
DISCLAIMER:
WHEN PROPERLY ASSEMBLED, THIS ITEM IS SAFE FOR INTENDED USE. SELLER IS NOT LIABLE FOR ANY DAMAGES RESULTING
FROM ITEM BEING IMPROPERLY ASSEMBLED AFTER PURCHASE.
Assembly Procedures:
Step 2. Turn the chair upside down and lay on protective carpet. Screw in the front legs (P1) and back legs (P2) using
Plastic Washer (H1) for each. Screw tight to the right angle.
Step 3. Place chair upright on a level surface. Put the back cushion(P3) on it. Assembly is complete.
ADDITIONAL NOTE ABOUT SAFETY: BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE. THEY SHOULD BE PERIODICALLY
INSPECTED AND RE-TIGHTENED TO PREVENT DAMAGE OR INJURY. ALWAYS CHECK TO ENSURE THAT ALL HARDWARE IS KEPT
TIGHTENED
Thank you for your purchase
P2
Remove the plastic caps
from screw heads before
attaching legs.
P1
P1
H1
P3
/