Sony Ericsson HBH-10 User manual

This is the Internet version of the user’s guide © Print only for private use.

Stereo Bluetooth™

Headset

HBH-DS970

English

Deutsch

Español

Français

This is the Internet version of the user’s guide © Print only for private use.

1

English .......................................................... 3

Deutsch ...................................................... 17

Español ....................................................... 33

Français ...................................................... 49

Declaration of conformity ............................ 65

This is the Internet version of the user’s guide © Print only for private use.

2

This is the Internet version of the user’s guide © Print only for private use.

3

English

Introduction.................................................. 4

Getting started ............................................. 8

Listening to music..................................... 10

Calling functions ....................................... 13

Troubleshooting ........................................ 14

Sony Ericsson HBH-DS970

This manual is published by Sony Ericsson Mobile Communications

AB, without any warranty. Improvements and changes to this manual

necessitated by typographical errors, inaccuracies of current

information, or improvements to programs and/or equipment, may

be made by Sony Ericsson Mobile Communications AB at any time

and without notice. Such changes will, however, be incorporated

©Sony Ericsson Mobile Communications AB, 2006

Publication number: LZT 108 8379/3 R1A

Some of the services in this manual are not supported by all

networks. This also applies to the GSM International Emergency

Number 112. Contact your network operator or service provider if

you are in doubt whether you can use a particular service or not.

The Bluetooth word mark and logos are owned by the Bluetooth

SIG, Inc. and any use of such marks by Sony Ericsson is

under license.

This product is leadfree and halogenfree.

This is the Internet version of the user’s guide © Print only for private use.

4

Introduction

The Stereo Bluetooth™ Headset HBH-DS970 lets you

stay in control of your incoming and outgoing phone

calls. You can enjoy stereo audio from a phone or other

Bluetooth device, such as a computer or a portable

music player. When you receive or make a call, the

music automatically pauses and starts playing again

when the call ends.

Your phone or other device should support the

following Bluetooth profiles:

• Bluetooth Handsfree or Bluetooth Headset.

• Bluetooth Advanced Audio Distribution.

• Bluetooth Audio/Video Remote Control profile.

This is the Internet version of the user’s guide © Print only for private use.

5

Overview

Microphone

Call handling

button

Right earpiece (replaceable

ear cushion)

Left earpiece

(replaceable ear

cushion)

Cord length

adjustment

Safety release

This is the Internet version of the user’s guide © Print only for private use.

6

Buttons and display

Vo l u m e u p

Previous track

Multipoint mode

Singlepoint mode

Volu m e dow n

On/off button

Display with backlight

Music button

Next track

Selection button

This is the Internet version of the user’s guide © Print only for private use.

7

Display information

Battery status. Animated when charging.

The headset is on.

The headset is prepared to be added to

a phone.

The headset is prepared to be added to

a phone or other device.

The headset is successfully added to

a phone or other device.

Incoming call.

Outgoing call.

Ongoing call.

Singlepoint mode – the headset can only

connect to one phone.

Multipoint mode – the headset can

connect to several devices.

Voice control is activated.

The microphone is muted.

Connecting to a phone or other device.

Music mode.

Adjusting the ringtone volume.

Adjusting the call volume.

Adjusting the music volume.

This is the Internet version of the user’s guide © Print only for private use.

8

Getting started

To charge the headset

First time use: Charge approximately 8 hours before

using the headset.

Adding the headset to the phone

Before you can use the headset with your phone it has

to be added once to the phone. Follow the instructions

from the phone user guide on how to turn on Bluetooth

in your phone.

To add the headset to the phone

1

Turn on Bluetooth in your phone.

2

Turn on Bluetooth visibility in your phone, and keep

it close to the headset (20 cm).

This is the Internet version of the user’s guide © Print only for private use.

9

3

Select singlepoint mode and make sure the headset

is off.

4

Press and hold the on/off button for 2 seconds.

You hear a signal and the Sony Ericsson logo is

displayed briefly. The display shows when the

headset is prepared to be added to the phone. If not,

make sure the headset is off, and press and hold the

on/off button for 5 seconds. You hear a long beep

after the first signal.

5

If your phone supports auto pairing, press YES

when Add device? appears in your phone to

complete the procedure. If not, continue with the

next step.

6

Prepare your phone according to the phone user

guide on how to add a Bluetooth device. Please note

that for some phones you may need to enter a

passcode. The headset passcode is 0000.

Note: For Bluetooth communication, we recommend

a maximum distance of 10 metres, with no solid objects

in between.

To turn the headset on or off

Press and hold the on/off button for 2 seconds. You hear

a signal. The Sony Ericsson logo is displayed briefly.

To turn on the backlight

Press any button. The backlight turns off automatically.

This is the Internet version of the user’s guide © Print only for private use.

10

To reset the headset to default settings

1

Make sure the headset is off, and press and hold the

on/off button for 5 seconds. You hear a long beep

after the first signal. The headset is prepared to be

added.

2

Press and hold the on/off button and the call

handling button simultaneously for 5 seconds.

The headset is turned off.

Listening to music

Before you can listen to music, the headset has to be

added once to your phone, see instructions on page 8.

This is the Internet version of the user’s guide © Print only for private use.

11

To play a music track

1

Start the media player in your phone, and select

to use the headset.

2

Press the music button. The headset connects

to your phone, and the music starts playing.

3

To pause the music or start playing again, press

the music button.

To stop the music

1

Press and hold the music button. The music stops.

2

To start the music again, press the music button.

The headset connects to your phone, and the music

starts playing.

To skip to another music track

Select Next or Previous.

To adjust the music volume

When you listen to music, press the volume button up

or down.

Using another device as a music source

In singlepoint mode, the headset is connected only

to your phone. In multipoint mode, you can use the

headset together with your phone and one of your

other Bluetooth devices, where music is saved.

Before you can listen to music from another device,

the headset has to be added once to the device. The

headset can be added to up to 10 devices. When you

press the music button, the headset connects to the most

recently used device.

This is the Internet version of the user’s guide © Print only for private use.

12

To add the headset to another device

1

Turn on Bluetooth in your device.

2

Turn on Bluetooth visibility in your device,

and keep it close to the headset (20 cm).

3

Select multipoint mode and make sure the headset

is off.

4

Press and hold the on/off button for 5 seconds.

You hear a long beep after the first signal.

The headset is prepared to be added.

5

Prepare your device according to the device user

guide on how to add a Bluetooth device. Please note

that you may need to enter a passcode. The headset

passcode is 0000.

This is the Internet version of the user’s guide © Print only for private use.

13

Calling functions

Your phone uses the headset for calls, even if you

are listening to music from another device in

multipoint mode.

To answer a call

Press the call handling button. The music pauses during

the call.

To reject a call

Press and hold the call handling button for 2 seconds.

To end a call

Press the call handling button. The display shows the

duration of the call. The music starts playing again.

To make a call using voice commands

1

Press the call handling button and the music

is muted.

2

Say the name you want to call.

To be able to use this function, you first have to activate

voice control in your phone and record voice commands.

For more information on voice commands, and if your

phone supports it, refer to the phone user guide.

To transfer sound from phone to headset

During an ongoing call in your phone, press the call

handling button on the headset. To transfer from

headset to phone, refer to the phone user guide.

This is the Internet version of the user’s guide © Print only for private use.

14

To switch between two calls

Press and hold the call handling button for 2 seconds.

To redial the last dialled number

Press the call handling button quickly twice.

To turn the microphone on or off (mute)

During a call, press both volume buttons.

To adjust the ringtone volume

When you have no ongoing call or music playing, press

the volume button up or down.

To adjust the speaker volume for calls

During a call, press the volume button up or down.

Troubleshooting

No connection to phone or other device

• Before you can use your Stereo Bluetooth Headset

with your phone or other device it has to be added

once according to page 8.

• It is recommended to first add the headset to your

phone, in singlepoint mode. Select singlepoint mode

and add the headset to the phone again. In

multipoint mode, the phone or other device that first

adds the headset will be used for phone calls.

• Make sure the headset is charged and within range

of the phone or other device. We recommend a

maximum distance of 10 metres, with no solid

objects in between.

15

• Check or redo the Bluetooth settings in the phone

or other device. For more information on

Bluetooth and pairing, go to

www.sonyericsson.com/learnabout.

Redial does not work

If the call list in the phone is empty you cannot use the

redial function.

The headset does not connect to my music source

• Make sure your device is available, and supports

Bluetooth Advanced Audio Distribution profile.

The headset tries to connect to the most recent

device used as a music source. You may have to

restart the media player in your device.

• Check the setting of the singlepoint/multipoint

mode selection button.

The remote control functions do not work

Make sure your device supports Bluetooth Audio/Video

Remote Control profile.

The headset is switched off automatically

• The battery is too low. You hear a low beep.

• When you are adding the headset, it switches off if

you do not add it to the phone within 10 minutes.

16

Battery capacity

A battery that has been infrequently used or a new one,

could have reduced capacity. It may need to be

recharged a number of times.

Unexpected behaviour

Reset the headset according to page 10.

www.sonyericsson.com/support

Page is loading ...

19

Übersicht

Mikrofon

Anruftaste

Rechter Ohrstecker

(Polster auswechselbar)

Linker Ohrstecker

(Polster auswechselbar)

Kabellängeneinstellung

Sicherheitsauslösung

20

Tasten und Display

Lautstärke

erhöhen

Vo r h e r i g e r

Titel

Multimodus

Einzelmodus

Lautstärke

verringern

Ein/Aus-Taste

Display mit

Hintergrundbeleuchtung

Musiktaste

Auswahltaste

Page is loading ...

32

Akkukapazität

Ein nur wenig benutzter Akku oder ein neuer Akku

kann eine geringe Kapazität aufweisen. Er muss dann

mehrmals ge- und entladen werden.

Unerwartetes Verhalten

Setzen Sie das Headset zurück (siehe Seite 24).

www.sonyericsson.com/support

Page is loading ...

Sony Ericsson HBH-10, HBH-DS970 User manual

Related papers

Other documents