Page is loading ...
66
Introduction
Congratulations on your purchase and welcome to Philips! To fully benet from the support that
Philips offers, register your product at www.philips.com/welcome.
With its ‘skin protection system’, Ladyshave Sensitive protects your skin while providing you with
beautifully smooth results. Its double foil pivoting head makes light work of even the toughest
hairs, without fear of nicks and cuts.
You can use the Ladyshave Sensitive either dry or wet. It’s a cordless appliance equipped with a
rechargeable battery.
General description (Fig. 1)
Shaving head with cutting unit (trimmer, aloe vera strip, gentle hair lifter and gold-plated
double shaving foil)
B Opti-light
C On/off button
D Handle
E Battery low light
F Socket for appliance plug
G Guiding grooves
H Cutting unit release slide
I Precision trimming head
J 3mm comb
5mm comb
L Cleaning brush
M Adapter
N Charging light
Not shown: Storage pouch
Important
Read this user manual carefully before you use the appliance and save it for future reference.
Danger
- Keep the adapter dry.
Warning
- Only use the Ladyshave with the adapter supplied.
- Do not use the appliance, an attachment or the adapter if it is damaged or broken to avoid
injuries.
- If the adapter is damaged, always have it replaced with one of the original type in order to
avoid a hazard.
- The adapter contains a transformer. Do not cut off the adapter to replace it with another
plug, as this causes a hazardous situation.
- This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
- Children should be supervised to ensure that they do not play with the appliance.
ENGLISH
7
- Do not insert metal-containing material into the socket for the appliance plug to avoid
short circuiting.
Caution
- Do not clean the Ladyshave with water that is hotter than shower temperature (max.
40°C).
- Charge, use and store the appliance at a temperature between 10°C and 40°C.
- This appliance is only intended to be used by women to shave and trim their body hair. It is
not intended for shaving or trimming scalp hair or for any other purpose.
- Only use the shaving head and the precision trimming head on the legs, the arms, the
underarms and the bikini area. Never use the shaving head on other body areas (e.g. the
face).
- Other than on the bikini line, do not use the precision trimming head without comb on
the intimate area because skin injuries can occur.
- Make sure the socket is live when you charge the appliance. The electricity supply to sockets
in mirror cabinets over washbasins or shaver sockets in bathrooms may be cut off when the
light is turned off.
- Do not look directly into the Opti-light to avoid being dazzled by the light.
- Noiselevel: Lc= 65 dB(A)
General
- The appliance complies with the internationally approved IEC safety regulations and can be
safely used in the bath or shower and cleaned under the tap (Fig. 2).
- The appliance is equipped with an automatic voltage selector and is suitable for mains
voltages ranging from 100 to 240 volts.
This Philips appliance complies with all standards regarding electromagnetic elds (EMF). If
handled properly and according to the instructions in this user manual, the appliance is safe to
use based on scientic evidence available today.
Preparing for use
Charging
It takes approximately 10 hours to charge the batteries fully. With its batteries fully charged, the
appliance has a cordless shaving time of up to 40 minutes.
Always switch off the appliance before you connect it to the mains.
1 Insert the appliance plug into the appliance (1). Plug the adapter into a wall socket
(2) (Fig. 3).
, The charging light on the adapter goes on.
Note: The charging light on the adapter remains on after the appliance is fully charged.
Note: Do not leave the adapter plugged in for longer than 14 hours, as this may affect the lifetime of
the batteries.
Rechargeable batteries low or empty
- If the batteries run low during use, the battery low light lights up. You can continue to shave
for a few minutes (Fig. 4).
ENGLISH 7
8
- When the batteries are empty, the battery low light goes out and the appliance stops.
Charge the batteries immediately.
- When you switch off the appliance while the batteries are low, the battery low light ashes
4 times.
1 To attach the shaving head, slide it into the guiding grooves on both sides of the opening
in the handle. Then press the shaving head onto the appliance (‘click’) (Fig. 5).
2 To detach the shaving head, pull it off the appliance (Fig. 6).
Caution: Do not exert excessive pressure on the double shaving foil to avoid damage.
1 To attach the precision trimming head, slide it into the guiding grooves on both sides of
the opening in the handle. Then press it onto the appliance (‘click’) (Fig. 7).
2 To detach the precision trimming head, hold it at the protrusions while you pull. (Fig. 8)
1 To attach the 3mm or 5mm comb onto the precision trimming head, place the teeth of
the comb onto the teeth of the trimming head and push down the comb (‘click’). The
projections on the inside of the comb should t exactly into the guiding grooves of the
precision trimming head (Fig. 9).
2 To detach the 3mm or 5mm comb, slide it forward with your thumb (Fig. 10).
Make sure that the appliance is fully charged before you use it for the rst time.
Note: You cannot use the Ladyshave while it is connected to the mains.
Note: When you use the appliance for shaving, you can use it under both dry and wet conditions.
1 Place the double shaving foil and the integrated trimmer gently on the skin. Stretch the
skin with your free hand while you shave your bikini line. (Fig. 11)
Note: Do not press the appliance too rmly onto the skin.
Note: When you shave the underarms, raise your arm to stretch the skin.
2 Move the appliance slowly over the skin against the direction of hair growth while you
press it lightly. Make sure that the trimmer and the double shaving foil are always in full
contact with the skin (Fig. 12).
Note: If you move the appliance over the skin too fast, you may not obtain a smooth result.
Tip: To achieve the best result when you shave wet, lather your skin with soap or shaving cream
before you start to shave.
Caution: Never apply any cream or foam before you start to shave under dry conditions.
ENGLISH8
9
Note: To achieve the best result, only trim your bikini line when your skin and the appliance are dry.
1 Follow the steps in the chapters ‘Attaching/detaching the precision trimming head’ and
‘Attaching/detaching the combs on the precision trimming head’.
2 Place the comb on the skin. To obtain an even result, make sure that the at part of the
comb is in contact with the skin (Fig. 13).
Note: Do not use the front part of the comb (Fig. 14).
Note: Do not place the appliance on the skin too steeply.
3 Move the comb slowly against the direction of hair growth.
Note: To make trimming easier, stretch the skin with your free hand during trimming (Fig. 15).
4 Since not all hair grows in the same direction, you need to move the appliance in
different directions (upwards, downwards and across) (Fig. 16).
5 Regularly remove cut hair from the comb.
6 To detach the comb, slide it forward with your thumb (Fig. 10).
Note: Only style your bikini line when your skin and the appliance are dry.
1 Attach the precision trimming head (without comb) onto the appliance
(see chapter ‘Preparing for use’, section ‘Attaching/detaching the precision trimming head’).
Note: Trimming without a comb results in a hair length of approximately 0.5mm.
2 Move the appliance towards the desired contour of your bikini line. Touch the skin lightly
with the precision trimming head (Fig. 17).
Note: Make sure you stretch your skin with your free hand to avoid possible injuries.
Note: Do not press the appliance too rmly onto the skin.
You can use the appliance:
- with the trimmer teeth vertically on the skin. Use this method to create straight lines or
other shapes. Do not make long strokes, but tap the skin lightly with the trimmer
teeth (Fig. 18).
- with the teeth of the trimming head parallel to the skin. Use this method to shorten the
hairs to a minimum length around the contours of your bikini line (Fig. 19).
Cleaning and maintenance
Always switch off and unplug the appliance before you clean it.
Never switch on the appliance while you clean it or while the cutting unit is not attached.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or
acetone to clean the appliance.
Cleaning the handle and adapter
1 Clean the handle with the cleaning brush or under a running tap.
ENGLISH 9
10
Note: Make sure that the handle is completely dry before you reassemble the appliance.
2 If necessary, clean the adapter with the cleaning brush or a dry cloth.
Always keep the adapter dry. Never rinse it under the tap or immerse it in water.
1 Press the on/off button to switch off the appliance (Fig. 20).
2 Pull the shaving head off the appliance (Fig. 6).
Do not exert pressure on the double shaving foil to avoid damage.
3 Push the cutting unit release slide to the right (1) and remove the cutting unit
(2) (Fig. 21).
4 Clean the cutting unit and the inside of the shaving head with the cleaning brush. Also
brush away any hairs that have collected under the trimmer (Fig. 22).
Caution: Do not brush the foil to avoid damage to the brush or the foil.
5 You can also rinse the cutting unit and the shaving head under the tap. To dry the cutting
unit and the shaving head, shake them rmly (Fig. 23).
6 Place the cutting unit back onto the shaving head (‘click’) (Fig. 24).
Note: Make sure that the shaving head and the cutting unit are completely dry before you
reattach them onto the appliance.
Cleaning the precision trimming head and combs
1 Press the on/off button to switch off the appliance. (Fig. 25)
2 If a comb is attached to the precision trimming head, remove the comb (Fig. 10).
3 Remove the precision trimming head (Fig. 8).
4 Brush the hairs off the precision trimming head or rinse it under the tap (Fig. 26).
5 Brush the hairs off the combs or rinse them under the tap.
6 You can also rinse the precision trimming head and the combs under the tap. To dry
them, shake them rmly or use a tea towel (Fig. 27).
7 To reattach the precision trimming head, slide it into the guiding grooves on both sides
of the opening in the handle (‘click’) (Fig. 7).
Note: Make sure that the precision trimming head is completely dry before you reattach it onto the
appliance.
Maintenance
1 Lubricate the cutting unit (double shaving foil and trimmer) or the precision trimming
head, when attached on the handle, with a drop of sewing machine oil twice a
year. (Fig. 28)
ENGLISH10
11
2 Let the appliance operate briey to spread the oil.
Replacement
The shaving head, the precision trimming head, both combs (3mm and 5mm) and the adapter of
the appliance can be replaced. If you need to replace one or more parts, go to your Philips
dealer or an authorised Philips service centre. If you use the Ladyshave two or more times a
week, we advise you to replace the shaving head after one or two years or if it is damaged.
Storage
1 Store the appliance in a safe, dry place.
- Do not throw away the appliance with the normal household waste at the end of its life,
but hand it in at an ofcial collection point for recycling. By doing this, you help to preserve
the environment (Fig. 29).
- The built-in rechargeable batteries contains substances that may pollute the environment.
Always remove the batteries before you discard and hand in the appliance at an ofcial
collection point. Dispose of the batteries at an ofcial collection point for batteries. If you
have trouble removing the batteries, you can also take the appliance to a Philips service
centre. The staff of this centre will remove the batteries for you and will dispose of it in an
environmentally safe way (Fig. 30).
1 Disconnect the appliance from the adapter. Let the appliance run until the batteries are
completely empty. Remove the shaving head or precision trimming head.
2 Release the side panels on both sides of the appliance with a screwdriver and remove
them (Fig. 31).
3 Remove the front panel by pushing it upwards with a screwdriver.
4 Cut the wires at the end of the handle and pull out the inner parts. Take out the
rechargeable batteries (Fig. 32).
Do not try to replace the rechargeable batteries.
Do not connect the appliance to the mains again after you have removed the rechargeable
batteries.
If you need service or information or if you have a problem, please visit the Philips website at
www.philips.com or contact the Philips Consumer Care Centre in your country. You nd its
phone number in the worldwide guarantee leaet. If there is no Consumer Care Centre in your
country, go to your local Philips dealer.
ENGLISH 11
/
