2. JetMAX
  3. FY-RC-RF-RGB
FY-RC-RF-RGB

JetMAX FY-RC-RF-RGB User manual

  • Hello! I'm here to assist you with the Remote Control FY-RC-RF-RGB user manual. This document provides safety instructions, battery installation details, and explains how to use the timer function for your lights. I've reviewed the document and I'm ready to answer any questions you might have about the remote control.
  • What type of battery does the remote control require?
    How does the timer function work?
    Is this product intended for permanent installation?
RF Remote Control
Model: FY-RC-RF-RGB
FCC ID:2AZA6FY-RC-RF-RGB
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
• Do not use seasonal products outdoors unless marked suitable for indoor and outdoor use.
• This seasonal use product is not intended for permanent installation or use.
• Do not secure the wiring of the product with staples or nails, or place on sharp hooks or nails.
• Unplug the product when leaving the house, when retiring for the night, or if left unattended.
• Do not use this product for other than its intended use.
• Never operate this product if the power cord or plug is damaged.
•CAUTION: This is an electrical product – not a toy! To avoid risk of fire, burns, personal injury and electric shock, it
should not be played with or placed where small children can reach it.
OPERATIONG INSTRUCTIONS
Controller on Remote assembly works in the same manner as the controller that came with the tree.
Pressing the button on the switch or remote control operate the functions of the lights.
Pressing the TIMER button once will turn on the lights and begin the timer. The timer will run continually: 6 hours with
lights on, then 18 hours with lights off and repeat until deactivated by pressing TIMER button.
BATTERY INSTALLATION
Remote Control requires one CR2025 button battery (battery included).
Open battery compartment and insert one CR2025 button battery observing proper polarity(+/-).
Battery use reminders
(1) Always purchase the correct size and grade of battery most suitable for the intended
use.
(2) Replace all batteries of a set at the same time.
(3) Clean the battery contacts and also those of the device prior to battery installation.
(4) Ensure the batteries are installed correctly with regard to polarity(+and -)
(5) Remove batteries from equipment which is not to be used for an extended period of
time.
(6) Remove used batteries promptly.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that may cause undesired
operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a class B digital device,pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequence energy and,if not installed and used
in accordance with the instructions,may cause harmful interference to radio communications.However,there
is no guarantee that interference will not occur in a particular installation.if this equipmemt does cause
harmful interference to radio or television reception,which can be determined by turning the equipment off
and on,the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an autlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
/