Techwall Electronics BAP-2 User manual

BAP-2 Instruction Manual

1．Power On/Off button①；Power ON；Long press Power

On/off button to switch on the purifier. Indicator⑦light on

and the purifier start to work. Power OFF ；Long press

Power On/off button can switch off the purifier. The

indicator⑦will light off，the unit stop working. Wake up；

short press button ①can wake up touch function，and

touch function indicator will light on. The function

indicator will automatically turn off after 10 seconds of no

operation.

2. Fan speed ②；Fan speed can be adjusted to 3 levels,

high/medium/low ，press button ②can change fan speed.

Screen ⑨can show current fan speed。

3. Automatic Fan speed mode ③；press ③can activate /

disable automatic fan speed mode，if this mode is activated fan

speed will be changed automatically depending on air quality of

current environment.

4. Filter replacement indicator ④；need to replace a new filter if

this indicator light on. See diagram below, unscrew the bottom

cover to replace a new filter.

5. Display of Temperature / Humidity ；press ⑤to switch

between temperature and humidity on screen.

6. Auto-sweep mode ⑥ ； press ⑥to activate or disable this

mode。

7. Function indicator ⑦；This indicator light on if the purifier is

switched on. And light off if this unit is switched off. Flashing

of this indicator mean not enough battery power. Light on red

mean the battery is under charging.

8.Power port ⑧；connect the adapter with USB cable to supply

power for this unit。

1Power On/Off button ②Fan speed ③Automatic Fan speed

mode ④ Filter Replacement indicator ⑤ Display of

Temperature / Humidity ⑥ Auto-sweep ⑦ Function

indicator ⑧Power port ⑨Screen

FCC Warning

This device complies with part 15 of the FCC Rules.Operation is subject to the

conditionthatthisdevicedoesnotcauseharmfulinterference

(1) Thisdevicemaynotcauseharmfulinterference.

(2) Thisdevicemustacceptanyinterferencereceived,includinginterferencethatmay

causeundesiredoperation.

Any changes or modifications not expressly approved by the party responsible for compliance could

voidtheuser’sauthoritytooperatetheequipment.

NOTE:ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,

pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates,usesandcanradiate

radiofrequencyenergyand,ifnotinstalledandusedinaccordancewiththeinstructions, may cause

harmful interference to radio communications. However, there is no guaranteethatinterferencewill

notoccurinaparticularinstallation.

Ifthisequipmentdoescauseharmfulinterferencetoradioortelevisionreception,whichcanbedetermined

by turning theequipment off and on, the user is encouraged to try to correct the interferencebyoneor

moreofthefollowingmeasures:

‐‐Reorientorrelocatethereceivingantenna.

‐‐Increasetheseparationbetweentheequipmentandreceiver.

‐‐Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiveris

connected.

‐‐Consultthedealeroranexperiencedradio/TVtechnicianforhelp.

)&&5DGLDWLRQ([SRVXUH6WDWHPHQW

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

This equipment should be installed and operated with minimum distance 20cm between the radiator&

your body.

Techwall Electronics BAP-2 User manual

Other documents