2. Crystorama
  3. 131-VZ-CEILING
131-VZ-CEILING

Crystorama 131-VZ-CEILING User manual

  • Hello! I've reviewed the assembly instructions for the CRYSTROMA 131-VZ_CEILING ceiling light. The document outlines the steps for both hanging and flush-mount installations, including how to attach the crystal drops and secure the fixture. I'm ready to answer your questions about the installation or components.
  • What type of bulb is recommended?
    Is this fixture suitable for damp locations?
    What is the correct way to hang the crystals?
ASSEMBLYINSTRUCTIONMODEL#131-VZ_CEILING
CRYST
RAMA
WARNING:
ElectricalDanger TurnPoweroff
WARNING: ThisproductcanexposeyoutoLead
whichisknowntothestateofCaliforniatocausecancer
and/orbirthdefectsorreproductiveharm.Formore
informationgotowww.P65Warnings.ca.gov
L I G H T I N GT H EW A YF O RS I X T YY E A R S
installedbyalicensedelectrician
inaccordancewiththeNational
Allelectricalcomponentsmustbe
ElectricCodeandtheappropriate
localelectricalcodes.
Youwillneed1-MediumBaseBulb
40WattsRecommended60WattsMax.
USELEDBULBSFOREXTENDEDUSE
ThisfixtureisDamprated
A-14sets
B-14sets
A-10sets
B-10sets
A-5sets
B-5sets
C-1set
Bottom
basket
Socket
Loop
5-7/8’’
1-1/8’’
13-3/4’’
7-1/4’’
13’’
A= 30mmx29sets
B= 76mmx29sets
C= (30mmBallwithchain)x1set
Metalring
Howtoinstall
Forceiling:
Forhanging:
7.HangglassdropCatthebottomofthebottombasket.
8.Installthebulb(notincluded)intothesocket.
1.Determinethepreferredhangingheightand
adjusttothechainrequired.
2.Openonelinkofchainconnectittofixtureloop
andclosethelink.Opentheotheronelinkofchain
connectittoloopofcanopyandclosethelink.
3.Threadthemountingscrewsintothematching
holesofthemountingbar,andtightenwiththe
smallhexnut.
4.Securethemountingbartotheoutletboxwith
theoutletboxscrews.
5.Raisecanopyallowingthemountingscrewsto
protrudethroughtheholesinthecanopy,and
securewiththeballnut.
1.Loosethehexnutofcanopyanddisassemblecanopy.
2.Removethelooponthetopofthefixture.
3.Slipthecanopy,themetalwasherandlockwasherover
thenipple,thensecurewiththehexnut.
4 Threadthemountingscrewsintothematching
holesofthemountingbar,andtightenwiththe
smallhexnut.
.
5 Securethemountingbartotheoutletboxwith
theoutletboxscrews.
.
6.Raisecanopyallowingthemountingscrewsto
protrudethroughtheholesinthecanopy,and
securewiththeballnut.
9.HangglassdropCatthebottomofthebottombasket.
7.Installthebulb(notincluded)intothesocket.
6.Hangcrystalstothemetalringandbottombasket,
alternatingbetweenglassdropAandB.
8.Hangcrystalstothemetalringandbottombasket,
alternatingbetweenglassdropAandB.
Hangcrystalsontheringsalternating
betweencrystalsAandB
PARTNUMBERMODEL#131-VZ_CEILING
CRYST
RAMA
L I G H T I N GT H EW A YF O RS I X T YY E A R S
FORCEILING:
D
H
F
CrystalsA
HEXNUT
METAL WASHER
SMALLHEXNUT
LOCKWASHER
B
CNIPPLE
FORHANGING:
A
B
CD
E
SMALLHEXNUT HEXNUT
G
PartNumber
PartNumbers
A.(1)-Mountinghardware
F.(1)-Metalring
B.(1)-CanopyW5-7/8’’xH1-1/8’’ #XRF130VZCAN6IN
C.(2)-Finial#XRF130VZFIN
D.(2)-Loop#XRF130VZLOOP
E.(1)-Chain-L72’’,4mmthick#XRF130VZCHA4MM
G.(1)-Bottombasket#XRF131VZBT
H.(1)-Socket
CrystalsB
CrystalsC
/