FALCON RIDGE PO-TURBO-S-RW02 User manual

Hello! I've reviewed the instructions for installing and caring for the Turbo S Poly Rear Window. This document provides step-by-step directions on how to install the rear window using velcro strap clamps. It also highlights important safety considerations, such as not exposing the enclosure to direct flames, and informs you about the refund and return policy.
What should I do before installing the rear window?

What should be done first with the rear window?

How do I install the window to the roll cage?

How do I attach the window to the frame?

2515 Bypass Rd. Flemingsburg, KY 41041

606-845-7439

Instructions for Installation and Care of

2019 Polaris Turbo S Poly Rear Window

PO-TURBO-S-RW02

Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.

NOTICE: Please check contents of package for any damage and make sure all parts fit

correctly and you are happy with the product before removing protective film. Once the

film is removed you cannot return the product for a full refund.

1. Be sure to read these instructions thoroughly before opening and installing the Ranger

RZR Turbo S Hard Rear Window.

2. Check over the parts included in the carton with the parts list shown below:

Velcro Strap Clamps 4 each

3. Begin by Pulling the Rear Window out and removing the protective film from both sides.

Then take the window and install it in the roll cage from the inside. The window should

look like the picture below.

4. Now you are ready to attach the Rear Window to the frame. Take the four strap clamps

and put the rectangle through the matching hole in the rear window from the inside and

wrap the strap around the bar. Then put the strap under the metal bar and pull it tight

back around the bar and secure the Velcro in place. Do this for all four locations on the

rear window.

5. This concludes your installation. Enjoy!!