For use in normal environments.
CM_ Room Thermostat Hardwired Installation Instructions
Page 1 of 1
Before commencing any work on the electrical connections, you must rst disconnect the thermostat
from the mains.
None of the 230V connections must be live until the installation has been completed and the housing is
closed.
Only qualied electricians or authorised service sta are permitted to open the thermostat.
There are parts that carry mains voltage behind the cover. The thermostat must not be left unsupervised
when open. (Prevent non specialists and especially children from gaining access to it.)
If the thermostat is used in a way not specied by the manufacturer, its safety may be impaired.
Prior to setting the thermostat, it is neccessary to complete all required settings described in this section.
CAUTION! Installation and connection should only be carried out by a qualied
person and in accordance with national wiring regulations.
Type
EN60730
1C IP20
EN60529
50
°C
0
122
°F
32
5-95%RH
This thermostat can be mounted in the following ways:
1. To a recessed conduit box 2. To a surface mounted box 3. Directly mounted on wall
The above image displayed is product CM2, design of
other products in the CM_ range may vary.
Important: Keep this document
1
34
5 6
2
84
84
86
20221006_CM_InsIns_PK
EPH Controls Ireland
technical@ephcontrols.com www.ephcontrols.com
EPH Controls UK
technical@ephcontrols.com www.ephcontrols.co.uk
