2. Maverick
  3. BT-150
BT-150

Maverick BT-150 User guide

  • I've reviewed the Quick Start Guide for the Maverick BT-150 STAKE Bluetooth extended range truly wireless thermometer. This document outlines the device's features including its extended bluetooth range using repeater, the overheat alert system, and crucial handling instructions, like the required use of oven gloves when moving after cooking. I'm ready to answer your questions about this device.
  • Can I use this thermometer in a microwave oven?
    Do I need gloves to handle the STAKE after cooking?
    What happens if the temperature gets too high?
BT150 QSG Page 1
MODEL # BT-150 STAKE Bluetooth Extended Range
Truly Wireless Thermometer Quick Start Guide
▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬
1. Introduction
Thank you for choosing our product, MODEL BT-150. Please read the information in this Quick Start Guide
before using the product.
2. Important Notes – Please read this carefully before use
• This product is exclusive for cooking meat/food in a grill or oven. It should only be used as described in
the User Manual.
• This product is not intended for use by people ages 12 and under.
• It is required to insert the STAKE properly into the charging compartment of BT-150 repeater for charging.
Please make sure the pole of STAKE and the charging pin is properly contact while charging.
• It is required to insert the STAKE properly into the meat/food during cooking. Do not expose the metal
part of the STAKE to the heat generated by grill/oven directly.
• To obtain the best result, please make sure the tip of the STAKE is located at the center (or the thickest
part) of the meat/food.
• Do not use the STAKE in a microwave oven.
• DO NOT TOUCH THE STAKE WITH BARE HANDS JUST AFTER COOKING. Always wear oven gloves to
remove the STAKE from the meat/food after cooking.
• When the temperature is higher than the overheat threshold (212 °F/100 °C), an overheat alert will
be triggered. Remove the STAKE immediately from the heat source with oven gloves.
• The STAKE can be washed in water but do not immerse for more than a few seconds.
• Do not recharge the STAKE until it has cooled down to room temperature.
• The STAKE has normal bluetooth range of 30 ft to your phone. The BT-150 repeater receives the bluetooth
signal instead of your phone and repeats it up to 150 ft to your phone. These are clear line of sight ranges
and will be reduced if obstacles are in the path of the RF signal.
• The BT-150 repeater is not waterproof.
• Take out the battery from BT-150 repeater whenever it is not in use for long periods.
• Turn off the BT-150 and save the battery power by sliding the switch to the USB position.
• Maverick will not be liable for any damage of the product due to misuse of the device.
BT150 QSG Page 2
3. Getting Started
3.1 Insert Battery into BT-150 repeater
• Slide the side switch to USB position
• Take out the battery door
• Insert a new AAA size battery
• Put back the battery door
3.2 Turn ON BT-150 repeater
• Slide the side switch to BAT position
• The LED will be flashing slowly
PS: To save power, slide the side switch to USB
position to switch off the device or take out the
battery when it is not in use.
3.3 Charging the STAKE
• Put the STAKE into the charging compartment
• The LED will then be flashing quickly. When the
STAKE is charged, the LED will stay ON for about
2 seconds and go off.
The STAKE is ready to use now !!!
3.4 Download the app
• Download the latest version of APP (STAKE)
from Apple APP Store or Google Play (or scan
the QR code in the right hand side)
4. Support
E mail – help@maverickhousewares.com
5. Regulation & Compliance
For information regarding Regulation and
Compliance (e.g. FCC ID), tap the setting icon of the
APP and select “Regulation & Compliance”.
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This
equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
RF exposure statements
1. This Transmitter must not be co‐located or operating in conjunction with any other antenna or transmitter.
2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body or nearby persons.
Canadian Compliance Statement
This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following two conditions:
1) This device may not cause interference, and
2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, meme si le brouillage est susceptible d’en compromettre le
fonctionnement.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment.
/