Paxton
ins-20400
2
337-520337-510337-500
M5 x 38 mm
337-420337-410337-400
35 mm (2-3/8)
M4 x 16 mm
x 8
x 7
x 7
M5 x 38 mm
35 mm (2-3/8)
M4 x 16 mm
x 8
x 7
x 7
x 1 x 1
ABS
x 1
x 1
x 1
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
3
59
111
295
48
55
7 x
5.3
7 x
5.3
43.5
39.5
79
26
223
148
69
15.5
150
336
113
298
24
39.5
79
43.5
49 248
111
295
62.2
48
7 x
5.3
7 x
5.3
55
39.5
79
25 70
149
224
46.7
151
336
310
124
48
39.5
43.5
79
70
ABS
337-420337-400
337-520337-500
4
337-400
337-410/337-420
ABS
ABS
8 mm
5
337-500
337-510/337-520
6
1
3
6
7
5
4
2
1
2
3
4
5
6
7
1
3
2
6
7
5
4
7
1
3
2
6
7
5
4
8
≤ 100
0°C +49°C *
32°F +120°F*
-20°C +55°C
-4°F +131°F
IK10
IP55
IP5X**
** - Not evaluated by UL.
*- Temperature evaluated by UL.
=
=
337-420
337-400
337-410
337-520
337-500
337-510
12.95W
9
≤ 100
0°C +49°C *
32°F +120°F*
-20°C +55°C
-4°F +131°F
IK10
IP55
IP5X**
** - Not evaluated by UL.
*- Temperature evaluated by UL.
=
=
337-420
337-400
337-410
337-520
337-500
337-510
12.95W
Standard Panels -- Models 337-400, 337-410, 337-420, Vandal Resistant Panels – models 337-
500, 337-510, 337-520, and monitor--model 337-290 are the only equipment evaluated by UL
to be connected to 337-727 for UL 293.
No other PoE equipment to be connected to 337-727. Shielded Ethernet cable to be used for
UL 293 installations
The monitor and Net2 monitoring station were not fully evaluated to UL 293 and are for
supplemental use.
Standard Panel (Models 337-
400, 337-410, 337-420),
VR Panel (Models 337-500,
337-510, 337-520),
150mA48VDC PoE from 337-727
only
UL 293 performance Levels:
Ratings:
Ethernet ports may extend beyond 30m if Emerson Network Power Surge Protection Inc.,
Model No. LCDP-060 is employed on each circuit extending beyond 30m.
++ Level 3 may be achieved when powered from model 337-727 control unit
Model Destructive
Attack
Line
Security
Endurance Standby
Power
1++
1++
4
4
1 1
11
Standard Panel Models
337-400, 337-410, 337-420
Vandal Resistant Panels –
models 337-500, 337-510,
337-520
Product Input Voltage Input Current
10
+44 (0)1273 811011
paxton.support
support@paxton.co.uk
877.438.7298
usapaxton.support
supportUS@paxton-access.com
+31 (0)76 3333 999
paxton.benelux.support
support@paxton-benelux.com
+32 (0) 78485147
paxton.benelux.support
support@paxton-benelux.com
+49 (0) 251 2080 6900
paxton.gmbh.support
+33 (0)1 57 32 93 56
support@paxtonaccess.fr
paxton.support
+27 (0) 21 4276691
support@paxtonaccess.co.za
paxton.support
8000 3570 3783
paxton.support
support@paxtonaccess.ae
+52 55 5351 3667
paxton.soporte
+57 1508 8198
paxton.soporte
+44 (0)1273 811011
paxton.support
support@paxton.co.uk
11
+44 (0)1273 811011
paxton.support
support@paxton.co.uk
877.438.7298
usapaxton.support
supportUS@paxton-access.com
+31 (0)76 3333 999
paxton.benelux.support
support@paxton-benelux.com
+32 (0) 78485147
paxton.benelux.support
support@paxton-benelux.com
+49 (0) 251 2080 6900
paxton.gmbh.support
+33 (0)1 57 32 93 56
support@paxtonaccess.fr
paxton.support
+27 (0) 21 4276691
support@paxtonaccess.co.za
paxton.support
8000 3570 3783
paxton.support
support@paxtonaccess.ae
+52 55 5351 3667
paxton.soporte
+57 1508 8198
paxton.soporte
+44 (0)1273 811011
paxton.support
support@paxton.co.uk
Ce dispositif est conforme à la section 15 du règlement de la FCC. Le fonctionnement est
soumis aux deux conditions suivantes : (1) ce dispositif ne doit pas créer d'interférences nuis-
ibles et (2) ce dispositif doit accepter toute interférence reçue, y compris des interférences
qui peuvent causer un fonctionnement non souhaité. Tout changement ou modication
non agréé par la partie responsable de la mise en conformité peut entraîner une interdiction
d'utilisation de l'équipement.
Conformité et limitations du produit
Les méthodes de câblage doivent être en accord avec le code nation électrique (ANSI/
NFPA70), codes locaux et les autorités ayant la juridiction.
Ce dispositif est conforme au(x) standards RSS de l'industrie Canadienne sans-licence. Le
fonctionnement est soumis aux deux conditions suivantes : (1) ce dispositif ne doit pas créer
d'interférences nuisibles et (2) ce dispositif doit accepter toute interférence reçue, y compris
des interférences qui peuvent causer un fonctionnement non souhaité.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any in-
terference received, including interference that may cause undesired operation. Changes or
modications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Product compliance and limitations
Wiring methods shall be in accordance with the National Electrical Code (ANSI/NFPA70), local
codes, and the authorities having jurisdiction.
The R.F exposure safe operating distance is 20cm
La distance de sécurité d’exposition au FR (fréquence Radio) est de 20cm
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
These products are not suitable for retail sale. All warranties are invalid if these products are
not installed by a competent person.
Paxton Access Ltd hereby declares that this product is in conformity with all the
essential requirements of the Directive 2014/53/EU.
http://paxton.info/4867
Contact details are provided at: http://paxton.info/596
The full declaration of conformity is provided at: http://paxton.info/3910
12
© Paxton Ltd 1.0.9 29/03/2019
Made in the UK
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- français: Paxton ins-20400 Mode d'emploi
Related papers
-
Paxton ins-20107 Operating instructions
-
-
-
-
-
-
-
-
Paxton Ins-01026 Operating instructions
-
