Power Fist 2461325 Owner's manual

Brand: Power Fist

Model: 2461325

Type: Owner's manual

2461325

V 1.3V 1.33

For any technical questions, please call 1-800-665-8685

IMPORTANT SAFETY PRECAUTIONS

WARNING! Read and understand all instructions before using this tool. Keep this

manual for the safety warnings and precautions, operating, inspection and maintenance

instructions. When using this tool, basic precautions should always be followed to reduce

the risk of personal injury and/or damage to the equipment. Make sure you fully understand

the nature of the product being pumped, i.e., volatile, hazardous, caustic, etc.

INSTALLATION

1. Make sure the spigot is positioned as illustrated.

2. Join the two extension tubes with tube connectors and

clamps. Tighten to secure connection.

3. Attach extension tubing to outlet on bottom of pump and

secure with clamp.

4. lnsert pump in either 3/4" or 2" drum opening and tighten by

hand. Adjust pump delivery using the snap-on clips.

Note:

The spigot is permanently attached. Do not try to pull or twist

it off. Do not hang containers from the end of the spigot. The

additional weight could damage it.

Choose proper clip for desired ow:

The entire pump head may be rotated to any position. The pump

operator should stand to the side or in back of the spigot. When removed

from drum, rinse the pump thoroughly in warm water before re-using it.

The packing nut on the end of the shaft should be tightened periodically to

prevent leakage. For 5, 15 and 55 gallon drums, excessive tubing may be cut

off to proper length.

For 8 oz. ow - Do not use any clips.

For 6 oz. ow - Use small clip only.

For 4 oz. ow - Use large clip only.

For 2 oz. ow - Use both large and small clips.

Note:

This adapter is designed to t on containers equipped with directional

pour spouts. Attach the tube extension to the outlet on the bottom

of the pump and secure it with a clamp. Tube extensions may be cut

off for proper length. Screw the adapter on the male threads at the

bottom of the pump. Tighten the adapter. lnsert the tube extension

into the spout and snap the pump over the metal retainer ring on

one edge of the spout, then snap it over the other side. To remove

the pump from the pail, pull towards the side and snap off. Once

removed, rinse the pump thoroughly in water before re-use.

Warning:

Remember some solutions can be harmful. Wear safety glasses and protective clothing such as gloves, etc.

Plastic Drum

Pump

55 Gallon

drum

5 Gallon

drum

fitting

on lid

adapter

2461325

V 1.33

For any technical questions, please call 1-800-665-8685

PARTS LIST

# Description Qty

1 Cylinder Body 1

2 Cylinder Cap 1

3 Drum Bung 1

4 Bung Adaptor 1

5 Grip 1

6 Packing Nut 1

7 Piston Rod 1

8 Piston 1

9 Second Valve 1

10 First Valve 1

11 Suction Tube (40 CM) 1

12 Suction Tube (42 CM) 1

13 Spout 1

14 Packing 1

15 Clamp 1

16 Tube Clamp 3

17 Tube Connector 1

18 Restriction Clip (L) 1

19 Restriction Clip (S) 1

20 Spout Cap 1

Page is loading ...

Power Fist 2461325 Owner's manual

Brand: Power Fist

Model: 2461325

Type: Owner's manual

Download PDF

report

in other languages

français: Power Fist 2461325 Le manuel du propriétaire

Power Fist 2461325 Owner's manual

Power Fist 2461325 Owner's manual

in other languages

Related papers

Other documents