Lenoxx 1135 Operating Instructions Manual

Lenoxx
Brand
Lenoxx
Model
1135
Category
Radio receivers
Type
Operating Instructions Manual

This manual is also suitable for

AM / FM DIGITAL STEREO
CASSETTE PLAYER
WITH BASS BOOST
MODEL 1135
®
oOPERATING INSTRUCTIONS
1135110298
E
LOCATION OF CONTROLS
1. RADIO/TAPE (RADIO OFF)
FUNCTION SWITCH
2. VOLUME CONTROL
3. HEADPHONE JACK
4. DC JACK FOR ADAPTOR
(OPTIONAL ADAPTOR)
5. BELT CLIP (REAR)
6. DISPLAY WINDOW
7. AM/FM TUNING
BUTTONS
8. FM/AM BAND BUTTON
9. TUNE LOCK SWITCH
(LOCKS FRONT BUTTONS)
10.MEMORY STORE BUTTON
11. BATTERY COMPARTMENT
(REAR)
12. BASS BOOST SWITCH
13.PRESET MEMORY
BUTTONS (AM & FM)
14.TAPE STOP BUTTON
15.TAPE FAST FORWARD
BUTTON
16.TAPE PLAY BUTTON
17.FM STEREO SWITCH
18.RADIO FREQUENCY
DISPLAY
19.AM/FM INDICATOR
20.FM STEREO INDICATOR
21.LOCK ON INDICATOR
22.BASS BOOST INDICATOR
23.MEMORY NUMBER
INDICATOR
BATTERY INSTALLATION
Open the battery compartment
located on the rear of the unit, and
insert 2 size AA batteries (not
included) observing the battery
polarity indicated on the set. Wrong
polarity may damage the unit. We
recommend Alkaline batteries for
longer life.
NOTE: Weak or dead batteries may swell and leak. To avoid damage
to the unit, remove batteries when the unit is not to be used for a long
period of time ( 2 months or more), or when the batteries become
exhausted.
Do not mix old and new batteries.
Do not mix alkaline, standard ( carbon-zinc ) or rechargeable
(nickel-cadmium ) batteries.
1135110298
E
1
EXTERNAL AC ADAPTOR ( NOT INCLUDED )
This unit can be powered by an AC outlet.
Be careful to use an AC adapter which is correctly matched to your
unit. Your cassette radio requires a DC input of 3V (300 mA or more )
with a XXXXX polarity. This AC Adapter can be purchased
separately in many radio stores.
RADIO OPERATION
NORMAL TUNING
1. Insert the headphone plug into the Headphone jack. Unbunch the
headphone wire because this is also your FM Antenna.
2. Slide the Function switch (1) to the RADIO position.
3. Select the FM or AM band by pressing the AM/FM band button (8).
Lock switch (9) must be in OFF position.
4. Tune a station by pressing the Tuning UP or DOWN button (UP or
DN).
5. If the FM Stereo switch is in ON position, pressing either tuning
button for more than 0.5 seconds activates the automatic tuning
mode. The automatic tuner will scan up or down and lock onto the
next station. If the automatic tuning does not precisely tune a
radio station, press the Tuning UP or DOWN button to adjust the
tuning.
6. Adjust the Volume Control (2).
7. To turn off the radio, set the Function switch (1) to TAPE position.
MEMORY TUNING
UP TO 5 AM STATIONS AND 5 FM STATIONS CAN BE STORED
IN MEMORY
1. Tune to a desired station as described in Normal Tuning (either
AM or FM ).
2. Press the Memory Store button (10), the Memory Number
indicator (23) blinks.
3. While the Memory Number indicator is blinking, press one of the
Preset Memory (M1 to M5) to store a station in it.
NOTE: Preset Memory buttons M1 to M5 can store AM stations and
FM stations in the same button.
1135110298
E
2
TO RECEIVE PRESET MEMORY STATIONS (AFTER
YOU PROGRAMMED THEM)
1. Slide Tune Lock switch (9) to OFF position.
2. Set the Function switch (1) to the RADIO position.
3. Set AM/FM switch to the band you want.
4. Press one of the Preset Memory buttons (M1 to M5) to select
stations stored and slide the Tune Lock button (9) to ON position.
The display will show the word LOCK, and you will receive the
station you stored into that memory button.
NOTE: When you are in the fringe area of a particular FM station,
the stereo program from that station may be noisy. To
reduce the noise interference, stretch the headphone cord
or switch the FM Stereo switch to OFF position. When
tuning a AM station, rotate the set slowly for best
reception.
MEMORY BACKUP OF STORED STATIONS
Once the batteries are weak, switch the Function switch to TAPE
position and press the Stop button to turn off power. Then you have
30 seconds to change the new batteries.
NOTE: When you replace batteries or switch from batteries to AC
adapter, make sure to turn the power off (Function Switch on TAPE
position). Otherwise the set may lose the preset memory.
CAUTION:
If the batteries have been removed for more than 30 seconds, you
may need to re-program all the radio stations.
RESET: (If some erratic information appears on the LCD display)
Take out the batteries and switch to radio function for quick
discharge and replace the batteries after 1 minute. You will
have to re-program the memory.
1135110298
E
3
TO PLAY A PRE-RECORDED CASSETTE TAPE
1. Open the cassette door.
2. Insert a pre-recorded tape into the slots on the door with the
open surface facing up. Full spool of tape on the right side.
3. Close the cassette door.
4. Set the Function switch to TAPE position.
5. Press the Play button.
6. Plug in the headphones provided.
7. Turn the Volume Control to the desired level.
8. Set Bass Boost switch to ON if an emphasized bass level is
desired.
9. The tape will play till the end and the set will shut itself off. To
listen to the other side, remove the tape, flip it over to the other
side, re-insert and press Play.
10. Press the Stop button to stop playing the tape.
1135110298
E
4
FAST FORWARD
Press Fast Forward button (15) to advance the tape. Release the
button by pressing Stop.
POWER
To turn radio on, slide Radio/Tape switch (1) to RADIO. To shut the
radio off, slide switch TAPE. To turn tape on, slide switch to TAPE
(radio off) position and press Play. When the tape reaches the end
and Play button pops up, the power is off.
LOCK SWITCH
Sliding the Tune Lock switch ON (up) disables the Front panel
(door) buttons. This prevents accidentally tuning to a different
station.
BASS BOOST SWITCH
Sliding this switch to ON gives you more bass ( low frequency )
sounds in radio or tape.
FM STEREO SWITCH
Sliding the switch to FM STEREO ON (stereo) will give you stereo
sound and stereo indicator will show in the display window.
However, some FM Stereo stations are noisy, so you may want to
switch to OFF (mono) for clearer sound in some locations.
NOTE: To avoid damaging the tape head, do not open the cassette
door in the play mode. Press Stop first.
ANTENNA
The AM Band has a built-in ferrite rod antenna. The FM Antenna is
built-in to headphone wire so be sure to extend the headphone wire
for best reception. You may find you can improve AM reception by
rotating the set or bringing it closer to a window.
1135110298
E
5
CASSETTE TAPE OPERATION TIPS
1. To obtain good operation, the head should be cleaned after
every 30 hours of use. It is also recommended that the tape be
kept away from excessive heat or cold.
2. If there is slack in the tape, remove it before inserting the tape.
To do so, insert a pencil into the hub and rotate clockwise as
shown.
3. Keep the tape head clean since a dirty tape head can cause
distorted sound or improper tape speed. Press the play button
and use a small cotton swab with tape head cleaner or alcohol
to clean the tape head, capstan and pinch roller as shown on
page 7.
NOTE: If the Play button pops up and you cannot get tape to play,
flip the tape around to the other side and insert into door
again (the tape may be at the end).
Remember the full spool of the tape must be inserted as
shown on page 4 on the right side.
1135110298
E
6
CARE AND MAINTENANCE
1. Clean you unit with a slightly dampened cloth. Solvents or
detergents should never be used.
2. Avoid leaving you unit in direct sunlight, in hot, humid, or dusty
place.
3. Keep your unit away from heating appliances and sources of
electrical noise such as fluorescent lamps or motors.
Read this important information before using your headset.
Avoid extended play at very high volume as it may harm your
ears. Keep volume at a reasonable level.
If you experience ringing in your ears, reduce the volume or shut
off your unit.
Do not use headphones while driving a motorized vehicle. It is
dangerous and illegal in some states.
1135110298
E
7
IN CASE OF DIFFICULTY
If your unit is not operating properly, check the following points listed
below:
1. Tape fails to move. Set the Function switch (1) to TAPE and try
another tape, also check if batteries are weak.
2. Tape sound fades or is unsteady. Clean the tape head, pinch roller
and capstan or replace batteries or try another tape.
3. Poor radio reception. Straighten the headphone cord. Or bring the
set close to a window ( some steel walls block radio waves ).
SPECIFICATIONS
Frequency response:
Receiving frequency:
Output terminal:
Max. output power:
Power supply:
100 Hz to 6.3 KHz
FM: 88 MHz to 108 MHz
AM: 530 KHz to 1700 KHz
3.5 mm dia. Stereo headphones jack x 1
20 mW (10 mW +10 mW)
DC 2 size AA batteries
External power source adapter (DC 3V
300mA ) jack, 3.4mm diameter, center
connection pin negative
Specifications are subject to change without notice due to
improvement.
1135110298
E
8
LIMITED WARRANTY
We warrant this product to be free from defects in material and
workmanship under normal use for a period of 90 days after pur-
chase, and we will repair it free of charge or replace it at no charge,
should it become defective under this warranty, providing you submit
proof of purchase sales slip with the set.
During the initial 90 days period after original purchase, we will
service the set that is returned to LENOXX ELECTRONICS CORP.,
prepaid, at no charge. After the initial 90 days period expires, and for
a period of 12 months from original purchase date, we will exchange
at no charge any part that is defective, but will charge for the cost of
labor, return postage paid by LENOXX.
This warranty does not apply to any products which have been
subject to misuse, neglect or accident. This warranty does not cover
broken antenna or cabinet. UNDER NO CIRCUMSTANCES WILL
LENOXX ELECTRONICS CORP. BE LIABLE FOR ANY INCIDEN-
TAL OR CONSEQUENTIAL DAMAGES. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so
the above exclusions or limitations may not apply to you.
This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state. The following charges
apply to repairs beyond the warranty period: $12.00. Be sure to pack
carefully and return postage paid insured together with your money
order and proof of purchase date to:
LENOXX ELECTRONICS CORP.,
2 GERMAK DRIVE, CARTERET, N.J. 07008
1135110298
E
For customer service, dial 1-800-315-5885.
© 1998 LENOXX ELECTRONICS CORP.
CARTERET, N.J. 07008
MADE & PRINTED IN CHINA
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10

Lenoxx 1135 Operating Instructions Manual

Lenoxx
Brand
Lenoxx
Model
1135
Category
Radio receivers
Type
Operating Instructions Manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents