4TUBE UNDER CAR LIGHTING KIT
INSTRUCTIONS
PLEASE READ CAREFULLY BEFORE INSTALLING NEON
*WARNING*
1) DISCONNECT YOUR CAR BATTERY BEFORE INSTALLING NEON TUBES
2) THIS IS A HIGH VOLTAGE SYSTEM AND MAY CAUSE BURN OR SHOCK IF NEON
TUBES ARE NOT PROPERLY CONNECTED.LOOSE WIRES CAN ARC AND MAY
CAUSE FIRE.
3) CONSULT YOUR MECHANIC OR TECHNICIAN IF NOT SURE OF WIRING OR
INSTALLATION OF NEON TUBES.
*IMPORTANT*
1) MOUNT NEON TUBING
A) AS HIGH INTO CHASSIS AS POSSIBLE
B) AWAY FROM ALL FULL LINES .AND ANY AREA WHERE VENICLE MAY BE
JACKED OR LIFTED.
C) AWAY FROM EXHAUST SYSTEM,EXTREME HEAT AND MOVING PARTS.
NOTE: SOME COMPACT CARS WILL ONLY ACCEPT TUBES MOUNTED BEHIND
THE GRILL OR UNDER THE BUMPER.
2) WIRING :
A) TRUN OFF SURPLUS WIRE BEFORE CONNECT.MAKE SURE ALL WIRES ARE
AS SHORT AS POSSIBLE ,AND CLOSE TO TUBE AS ILLUSTRATED IN WIRING
DIAGRAM
B) ALLOW AT LEAST 2 INCHES OF CLEARANCE AF THE END OF EACH TUBE SO
THAT WIRE MAY BE EASILY BENT BACK.
C) MOUNT MULT-OUTLETS POWER CONNECT NEAR TO BATTERY BUT AWAY
FROM ENGINE ON A FLAT METAL SURFACE.
D) BLACK(GROUND) WIRES CAN BE INDIVIDUALLY SECURED TO CHASSIS ,OR
TO THE BATTERY(-)
CAUTION: BEFORE SWITCHING ON SYSTEM ,BE SURE TO SECURELY
CONNECT ALL THE WIRES FROM TUBES TO BATTERY.
3) GENERAL INFORMATION:
A) THE 12 VOLT ELECTRONIC NEON TUBES DRAW ONLY 6 AMPS AN8 AMP IN
LINE FUSE IS PROVIDED.
B) EACH PREWIRED NEON GLASS TUBE IS SEALED AND PROTECTED IN A HIGH
IMPACT ACRYLIC TRANSPARENT COVER FOR INCREASED LIFE AND
DURABILITY.
C) ALWAYS CONNECT WIRES TO EACH OTHER AND SOLDER IN PLACE AND
TAPE FOR BEST CONNECTIONS
CONTAINS: ONE 4-TUBES KIT
CONSISTING OF :4 NEON TUBES(2-3FT & 2-4FT)
1 MULTI-OUTLETS POWER CONNECTOR
BLOCK,NOUNTING BRACKETS ,FUSE.SWITCH
AND ALL HARD WARD WIRING DIAGRAM&
INSTRUCTIONS ,READ INSTRUCTIONS
CAREFULLY FOR SIIOW USE ONLY .
/